Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@linux.ie>

- add support for inline src params
- fix shift_left/shift_right and shl/shr ops
  shift_* ops use inline src params, shl/r use full params
- fix mask op (uses inline params)
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@linux.ie>

newer asics have large mmio apertures
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@linux.ie>

The first dword of PACKET3_3D_DRAW_IMMD maps to
SE_VTX_FMT so the vertex size is part of the draw
packet.

This patch fixes a possible case where you have a
command buffer that does not contain SE_VTX_FMT
register write, but does contain PACKET3_3D_DRAW_IMMD.
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@linux.ie>

Add missing vertex shader regs for r200.

fixed fdo bug 26061

agd5f: use official reg names
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@linux.ie>

The checks for CUBE and 3D textures were inverted.

fixes fdo bug 24159

agd5f: added comments for clarity.
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@linux.ie>

Use same common function to disable agp so we replace the GART
callback by the proper one when we do so. This fix oops if
radeon_agp_init report failure.

This patch also move radeon_agp_init out of *_mc_init for r600
& rv770 so that we can have a similar behavior than for previous
hw, ie if agp_init fails it will fallback to GPU GART and disable
AGP.
Signed-off-by: NJerome Glisse <jglisse@redhat.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

radeon KMS need a GART of at least 32M to properly work. This patch
check the AGP aperture size and disable if it's less than 32M. Note
than unlike non KMS path we don't staticaly allocate AGP memory so
we are not wasting memory not used by graphic processing.
Signed-off-by: NJerome Glisse <jglisse@redhat.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

r600 blit cleanup path need to check if a bo was allocated before
trying to free or unpin it. This patch add this check and avoid
oops when the initialization on r6xx or r7xx hw fails.
Signed-off-by: NJerome Glisse <jglisse@redhat.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

It's not necessary to unpin buffer in fb destruction. pin/unpin
need to be balanced and we don't pin in fb creation. We pin when
an fb is associated to a crtc and unpin when the fb is disassociated
from the crtc.

Note:
Maybe we should take reference on fb in set_base callback so fb
doesn't disappear until it's unbind from ctrc.
Signed-off-by: NJerome Glisse <jglisse@redhat.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

It appears that attempting AUXCH DDC breaks the subsequent attempt
to do DDC over the i2c lines, so use the sink type to determine
if we should be doing AUXCH or i2c DDC.

This fixes my DVI monitor plugged into DP->DVI convertor.
Signed-off-by: NDave Airlie <airlied@redhat.com>

Testing GTT ready might be more correct but cp.ready
works fine and has been tested on irc by 2-3 ppl.

fixes bug k.org 15035 and fd.o 25733
Signed-off-by: NDave Airlie <airlied@redhat.com>

Signed-off-by: NMichel Dänzer <daenzer@vmware.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Due to heat issues.  Fixes fdo bug 25992

v2: fix typo noticed by Maarten Maathuis
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Unhandled vectors can be safely ignored, no need
to spam the kernel log by default.
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Based on radeonfb code and recent ddx fix.

v2: minor formatting fix from Michel Dänzer
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Reviewed-by: NMichel Dänzer <michel@daenzer.net>
Tested-by: NMichel Dänzer <michel@daenzer.net>
Signed-off-by: NDave Airlie <airlied@redhat.com>

- r4xx/rs6xx: add support for extended pixel shader
instruction/temp regs
- r5xx: add SM3 regs
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

If for any reason we haven't installed handler we shouldn't try to
enable IRQ/MSI on the hw so we don't get unhandled IRQ/MSI which
makes the kernel sad.
Signed-off-by: NJerome Glisse <jglisse@redhat.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

In some case vblank might not be initialized and we shouldn't
try to use associated function. This patch make sure this is
the case. It also export drm_vblank_cleanup so driver can cleanup
vblank if for any reason IRQ/MSI is not working.
Signed-off-by: NJerome Glisse <jglisse@redhat.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Signed-off-by: NAlexander Beregalov <a.beregalov@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

In some case we weren't releasing the AGP device at module unloading.
This leaded to unfunctional AGP at next module load. This patch make
sure we release the AGP bus if we acquire it.
Signed-off-by: NJerome Glisse <jglisse@redhat.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

R300 family will hard lockup if host path read cache flush is
done through MMIO to HOST_PATH_CNTL. But scheduling same flush
through ring seems harmless. This patch remove the hdp_flush
callback and add a flush after each fence emission which means
a flush after each IB schedule. Thus we should have same behavior
without the hard lockup.

Tested on R100,R200,R300,R400,R500,R600,R700 family.

V2: Adjust fence counts in r600_blit_prepare_copy()
Signed-off-by: NJerome Glisse <jglisse@redhat.com>
Reviewed-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Long story short, this fixes sporadic hardlocks with my rv410 during
times of intense 2D acceleration (Flash on Fx3).

V2: Fix indentation and move errata_fini to suspend function so we
don't leak scratch register over suspend/resume cycle.
V3: Move scratch_reg to asic specific structure (aim is to slowly
    move stuff to asic specific structure and avoid poluting
    radeon_device struct with asic specific variables)
Signed-off-by: NCorbin Simpson <MostAwesomeDude@gmail.com>
Signed-off-by: NJerome Glisse <jglisse@redhat.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

This detects if the sideport memory is enabled and
if it is VRAM is evicted on suspend/resume.

This should fix s/r issues on some IGPs.
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

There are a couple of array overruns, and some associated confusion in
the code.
This is just a wild guess at what the code should actually look like.

Coverity CID: 13305 13306

agd5f: fix up the original intent of the timing code
Signed-off-by: NDarren Jenkins <darrenrjenkins@gmail.com>
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

This is displayport used for internal connections such
as laptop panels and systems with integrated monitors.
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Add a new connector type for eDP (embedded displayport)

eDP is more or less the same as DP but there are some
cases when you might want to handle it separately.
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Makes it easier to keep in sync with ddx and the upstream
AMD versions.
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Also remove the problematic enums that were unused
remnants from the ddx.
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

The mask happens to be the same, but the IH is reading the status, not the
not the control register.
Signed-off-by: NLuca Tettamanti <kronos.it@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

If a NULL value is possible, the dereference should only occur after the
NULL test.

Coverity CID: 13338
Signed-off-by: NDarren Jenkins <darrenrjenkins@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

If a NULL value is possible, the dereference should only occur after the
NULL test.

Coverity CID: 13335
Signed-off-by: NDarren Jenkins <darrenrjenkins@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

If a NULL value is possible, the dereference should only occur after the
NULL test.

Coverity CID: 13334
Signed-off-by: NDarren Jenkins <darrenrjenkins@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

The encoder variable can be NULL in this function so I believe it should
be checked before dereference.

Coverity CID: 13253

[airlied: extremely unlikely to happen]
Signed-off-by: NDarren Jenkins <darrenrjenkins@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Stanse found a memory leak in radeon_master_create. master_priv is not
freed/assigned on all paths. Fix that.
Signed-off-by: NJiri Slaby <jslaby@suse.cz>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Should fix fdo bug 25741
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Look up primary dac adj values from the table if
there is no bios or bios dac table to reference.

The lookup table may need to be adjusted for certain
families.

Should fix kernel bug 14945.
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

if necessary for combios

Some early combios radeon cards don't have a connector
table or dac table in the bios, if they do not, fallback
to the default tables.

Should fix kernel bug 14963.
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

[airlied: just adding this for completeness to avoid drift between
public atombios.h files]
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>