Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

The purpose of this patch is to split off the case when a device does
not reply on the lower level (which is reported by HC hardware), and
a case when the device accepted the request, but does not reply at
upper level. This redefinition allows to diagnose issues easier,
without asking the user if the -110 happened "immediately".

The usbmon splits such cases already thanks to its timestamp, but
it's not always available.

I adjusted all drivers which I found affected (by searching for "urb").
Out of tree drivers may suffer a little bit, but I do not expect much
breakage. At worst they may print a few messages.
Signed-off-by: NPete Zaitcev <zaitcev@redhat.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>

Add a mixer name map for the TerraTec Aureon 5.1 MkII USB.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

To decrease the USB interrupts rate, increase both the default and the
maximum number of packets per URB.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

There's at least one USB audio chipset out there which supports only one
non-standard rate (ID 0e6a:0310 supports 46875Hz). There's a few other
patches for this card which are unsatisfactory because they attempt to
map this rate to 44.1k leading to sound distortion.
The patch below uses SNDRV_PCM_RATE_KNOT to properly support the
non-standard rates where they are available.
Signed-off-by: NLuke Ross <luke@lukeross.name>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

Fixed a typo of CONFIG_PROC_FS in usbaudio.c.
The stream proc file appears again.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

Add some quirks for some unknown Yamaha USB MIDI devices.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

Added TLV-read support to snd-usb-audio driver for passing
the volume dB scale information to user-space.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

Orignally proposed by Sam Revitch <sam.revitch@gmail.com>.
Unregister device files at disconnection to avoid the futher accesses.
Also, the dev_unregister callback is removed and replaced with the
combination of disconnect + free.
A new function snd_card_free_when_closed() is introduced, which is
used in USB disconnect callback.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

sound: Conversions from kmalloc+memset to k(c|z)alloc.
Signed-off-by: NPanagiotis Issaris <takis@issaris.org>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

From: Sam Revitch <sam.revitch@gmail.com>Recently a Turtle Beach Audio Advantage Roadie device ended up in my
possession.  It seems to work with the snd-usb-audio driver, but only
using the headphone jack in 2-channel mode.  The device has a DIN
connector carrying six more channels that are otherwise silent.
C-Media has freely available documentation for the CM106 chip around
which this device is based, and enabling 8-channel output, or
6-channel output with the headphone jack following the front pair is a
matter of setting one of its registers.
Attached is a patch to try to enable 5.1 output mode at probe time.
It seems to work correctly with my device.  There is quite list of
other configurables for this device that might deserve controls.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

Removed the CS_AUDIO_* #defines, which were duplicates of the
class-specific USB_DT_CS_* #defines in <linux/usb_ch9.h>.
Signed-off-by: NBen Williamson <ben.williamson@greyinnovation.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Fix a typo introduced by the last fix.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Some devices don't have the required class-specific endpoint descriptors.
Instead of making this case an error, this patch makes the driver guess the
endpoint attributes.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

This patch rewrites the remote control code to use a table for
the peculiarities of the various SB models, and adds support
for a third model.
Signed-off-by: NRaimonds Cicans <ray@vardes.lv>
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Add a get_port_info callback to the snd_rawmidi_global_ops structure to
allow the USB MIDI driver to supply information flags for the sequencer
ports created by seq_midi.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Added O_APPEND flag support to PCM to enable shared substreams
among multiple processes.  This mechanism is used by dmix and
dsnoop plugins.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Remove unneeded read/write_size fields in proc text ops.
snd_info_set_text_ops() is fixed, too.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Add a quirk entry for the TerraTec Phase 26 with yet another product ID.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Test the volume of usb audio whether actually it works and adjusts
the resolution value according to it.

Some USB audio devices report a lower resolution than it reacts.
The only possible check is to write and read a volume value.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Fix a lot of typos.  Eyeballed by jmc@ in OpenBSD.
Signed-off-by: NAlexey Dobriyan <adobriyan@gmail.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Modules: USB generic driver

We may leak 'namelist' in sound/usb/usbmixer.c::parse_audio_selector_unit()
Signed-off-by: NJesper Juhl <jesper.juhl@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: USB generic driver

Add mixer control names for the AudioTrak Maya44 USB.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Modules: USB generic driver

Add a quirk entry for the Casio PL-40R.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Modules: USB generic driver

Add support for the Yamaha MDP-5 and EZ-J24.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Modules: Documentation,USB generic driver

The patch adds the 'device_setup' module parameter and a specific
quirk to correctly initialize the audiophile usb device: this fixes
the distorted sound bug on the Analog capture port. Backward
compatibility is achieved by simply omitting the new parameter.
Signed-off-by: NThibault LE MEUR <Thibault.LeMeur@supelec.fr>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: USB generic driver

Add an error message for -ENOSYS for situations when split iso support
is needed but not enabled.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Modules: USB generic driver

Use a generic name for USB device 0x07cf:0x6802 because this ID is used
by several devices without a product ID.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Modules: USB generic driver

When usb_submit_urb() fails, show an error description instead of just
the error code.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Modules: USB generic driver

Add a quirk for the Casio AP-80R.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Modules: USB generic driver

snd_ctl_add() kfree's the kcontrol already if we fail there,
so this driver is currently doing a double kfree.

Coverity bug #959
Signed-off-by: NDave Jones <davej@redhat.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: USB generic driver

Reduce the code size of the snd_usbmidi_count_bits() function by using
simpler operations.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Modules: Digigram VX core,USB generic driver

There's no need to check pointers passed to vfree() for NULL.
Signed-off-by: NJesper Juhl <jesper.juhl@gmail.com>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>

Modules: USB generic driver

Add a quirk entry for the Miditech Play'n Roll.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Modules: USB generic driver

Rename QUIRK_MIDI_MIDITECH to QUIRK_MIDI_CME because Miditech keyboards
are built by CME and use the same protocol, and don't force a Miditech
product name for the USB ID used by both Miditech and CME UF-x
keyboards.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Modules: USB generic driver

Add comments with information about UM-1EX/UM-2EX devices.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Modules: USB generic driver

The G-70 has one MIDI port in each direction, no two.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Modules: PCM Midlevel,USB generic driver

Because snd_pcm_format_name() function is used only for informational
purposes, it is no longer exported from the PCM midlevel to reduce
space and dependency. usbaudio module shows only numeric value for format.
Signed-off-by: NJaroslav Kysela <perex@suse.cz>

Modules: USB generic driver

Add a quirk entry for the Roland G-70.
Signed-off-by: NClemens Ladisch <clemens@ladisch.de>

Semaphore to mutex conversion.

The conversion was generated via scripts, and the result was validated
automatically via a script as well.
Signed-off-by: NIngo Molnar <mingo@elte.hu>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NTakashi Iwai <tiwai@suse.de>