Currently we really only support S3, since the device doesn't support
saving of the 3D state.

On S3/S4, move all buffer objects to swappable memory and take down
GMR bindings. We need to do that from a PM notifier since we can't
do persistant memory allocations from the standard PM callbacks.
Signed-off-by: NThomas Hellstrom <thellstrom@vmware.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Signed-off-by: NThomas Hellstrom <thellstrom@vmware.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Unbind GMR bindings on the buffer about to be swapped out.
Signed-off-by: NThomas Hellstrom <thellstrom@vmware.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

This is needed for a bugfix in the vmwgfx driver.
Drivers may have GPU bindings on buffers that core TTM is not aware of,
and TTM may view those buffers as ordinary system memory buffers.
Add a notifier to such drivers when TTM is about to move the buffer
contents out to swappable memory. The driver must then release any
private GPU bindings on those buffers.
Signed-off-by: NThomas Hellstrom <thellstrom@vmware.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

This was previously done explicitly for overlay- and fb buffers.
Now it's done for any buffer leaving the SYSTEM memory region.
Signed-off-by: NThomas Hellstrom <thellstrom@vmware.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

A vt switch in stealth mode would take down the FIFO, and re-
initialize fence sequence numbers. This patch
saves the current state of the fence sequence when the FIFO is
disabled.
Signed-off-by: NThomas Hellstrom <thellstrom@vmware.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

An error happening before the snooper.image member had been set up
would cause a kfree of an arbitrary pointer. Set up the snooper.image
member early.
Signed-off-by: NThomas Hellstrom <thellstrom@vmware.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

That's unnecessary since partial screen updates from GMRs are fast.
Also fix cliprect pointer dereferencing
Signed-off-by: NThomas Hellstrom <thellstrom@vmware.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

* korg/drm-radeon-next
  drm/radeon/kms: only evict to GTT if CP is ready
  drm/radeon/kms: Fix crash getting TV info with no BIOS.
  drm/radeon/kms/rv100: reject modes > 135 Mhz on DVI (v2)
  drm/radeon/kms/r6xx+: make irq handler less verbose
  drm/radeon/kms: fix up LVDS handling on macs (v2)

Following drm info repeat 207 times during one hour, it's quite annoying
[ 1266.286747] [drm] TV-19: set mode NTSC 480i 0

Change from DRM_INFO to DRM_DEBUG
Signed-off-by: NDave Young <hidave.darkstar@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Toralf Förster pointed out the typo, the fact I forget the if
statement is purely personal fail.
Signed-off-by: NDave Airlie <airlied@redhat.com>

Testing GTT ready might be more correct but cp.ready
works fine and has been tested on irc by 2-3 ppl.

fixes bug k.org 15035 and fd.o 25733
Signed-off-by: NDave Airlie <airlied@redhat.com>

Signed-off-by: NMichel Dänzer <daenzer@vmware.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Due to heat issues.  Fixes fdo bug 25992

v2: fix typo noticed by Maarten Maathuis
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Unhandled vectors can be safely ignored, no need
to spam the kernel log by default.
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

Based on radeonfb code and recent ddx fix.

v2: minor formatting fix from Michel Dänzer
Signed-off-by: NAlex Deucher <alexdeucher@gmail.com>
Reviewed-by: NMichel Dänzer <michel@daenzer.net>
Tested-by: NMichel Dänzer <michel@daenzer.net>
Signed-off-by: NDave Airlie <airlied@redhat.com>

* 'for-airlied' of /ssd/git/drm-nouveau-next: (28 commits)
  drm/nv04: Fix set_operation software method.
  drm/nouveau: initialise DMA tracking parameters earlier
  drm/nouveau: use dma.max rather than pushbuf size for checking GET validity
  drm/nv04: differentiate between nv04/nv05
  drm/nouveau: Fix null deref in nouveau_fence_emit due to deleted fence
  drm/nv50: prevent a possible ctxprog hang
  drm/nouveau: have ttm's fault handler called directly
  drm/nv50: restore correct cache1 get/put address on fifoctx load
  drm/nouveau: create function for "dealing" with gpu lockup
  drm/nouveau: remove unused nouveau_channel_idle() function
  drm/nouveau: fix handling of fbcon colours in 8bpp
  drm/nv04: Context switching fixes.
  drm/nouveau: Use the software object for fencing.
  drm/nouveau: Allocate a per-channel instance of NV_SW.
  drm/nv50: make the blocksize depend on vram size
  drm/nouveau: better alignment of bo sizes and use roundup instead of ALIGN
  drm/nouveau: Don't skip card take down on nv0x.
  drm/nouveau: Implement nv42-nv43 TV load detection.
  drm/nouveau: Clean up the nv17-nv4x load detection code a bit.
  drm/nv50: fix fillrect color
  ...

* korg/drm-radeon-next:
  drm/radeon/kms: add additional safe regs for r4xx/rs6xx and r5xx
  drm/radeon/kms: Don't try to enable IRQ if we have no handler installed
  drm: Avoid calling vblank function is vblank wasn't initialized
  drm/radeon: mkregtable.c: close a file before exit
  drm/radeon/kms: Make sure we release AGP device if we acquired it
  drm/radeon/kms: Schedule host path read cache flush through the ring V2
  drm/radeon/kms: Workaround RV410/R420 CP errata (V3)
  drm/radeon/kms: detect sideport memory on IGP chips
  drm/radeon: fix a couple of array index errors
  drm/radeon/kms: add support for eDP (embedded DisplayPort)
  drm: Add eDP connector type
  drm/radeon/kms: pull in the latest upstream ObjectID.h changes
  drm/radeon/kms: whitespace changes to ObjectID.h
  drm/radeon/kms: fix typo in atom connector type handling

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Some upcoming G80 DMA changes will depend on this, but it's split out for
bisectibility just in case it causes some unexpected issues.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Currently Nouveau will unvalidate all buffers if it is forced to wait on
one, and then start revalidating from the beginning.  While doing so, it
destroys the operation fence, causing nouveau_fence_emit to crash.

This patch fixes this bug by taking the fence object out of validate_op
and creating it just before emit.  The fence pointer is initialized to 0
and unref'ed unconditionally.

In addition to fixing the bug, this prevents its reintroduction and
simplifies the code.
Signed-off-by: NLuca Barbieri <luca@luca-barbieri.com>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

The below is mainly an educated guess at what's going on, docs would
sure be handy...  NVIDIA? :P

It appears it's possible for a ctxprog to run even while a GPU exception
is pending.  The GF8 and up ctxprogs appear to have a small snippet of
code which detects this, and stalls the ctxprog until it's been handled,
which essentially looks like:

	if (r2 & 0x00008000) {
		r0 |= 0x80000000;
		while (r0 & 0x80000000) {}
	}

I don't know of any way that flag would get cleared unless the driver
intervenes (and indeed, in the cases I've seen the hang, nothing steps
in to automagically clear it for us).  This patch causes the driver to
clear the flag during the PGRAPH IRQ handler.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

There's no good reason for us to have our own anymore, this is left over
from an early port to these TTM interfaces.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

It's mostly a cleanup, but in nv50_fbcon_accel_init gpu lockup
message was printed, but HWACCEL_DISBALED flag was not set.
Signed-off-by: NMarcin Slusarz <marcin.slusarz@gmail.com>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Depending on the visual, the colours handed to us in fillrect() can either be
an actual colour, or an index into the pseudo-palette.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>

This should avoid a race condition on nv0x, if we're doing it with
actual PGRAPH objects and a there's a fence within the FIFO DMA fetch
area when a context switch kicks in.

In that case we get an ILLEGAL_MTHD interrupt as expected, but the
values in PGRAPH_TRAPPED_ADDR aren't calculated correctly and they're
almost useless (e.g. you can see ILLEGAL_MTHDs for the now inactive
channel, with a wrong offset/data pair).
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>

It will be useful for various synchronization purposes, mostly stolen
from "[PATCH] drm/nv50: synchronize user channel after buffer object
move on kernel channel" by Maarten Maathuis.
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>

- This should be better than what we have now.
- I'm less sure about the non power of two path.
Signed-off-by: NMaarten Maathuis <madman2003@gmail.com>

- Aligning to block size should ensure that the extra size is enough.
- Using roundup, because not all sizes are powers of two.
Signed-off-by: NMaarten Maathuis <madman2003@gmail.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>

struct fb_fillrect->color is not a color, but index into pseudo_palette
array
Signed-off-by: NMarcin Slusarz <marcin.slusarz@gmail.com>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Should fix dim panel issues reported on Dell M6400/M6500.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>