- 06 1月, 2012 3 次提交
-
-
由 Malcolm Priestley 提交于
Fixes issues with PID filter Stalling of some channels when PID is on. PID filter not turning off fully. PID filter can now turn on and off each index. Removed PID_RST from it913x_pid_filter_ctrl. Replaced with PID_EN removed from it913x_pid_filter Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
由 Malcolm Priestley 提交于
Turn the pid filter off by caps option only. This is so the full stream is passed to demuxer and not limited by pid count. Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
由 Malcolm Priestley 提交于
Support for IT1935 9006 devices. 9006 have version 2 type chip. 9006 devices should use dvb-usb-it9135-02.fw firmware. On the device tested the tuner id was set to 0 which meant the driver used tuner id 0x38. The device functioned normally. Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
- 31 12月, 2011 2 次提交
-
-
由 Malcolm Priestley 提交于
Stop dual frontend attach in warm state with single devices. Since this is a no reconnect device this occurs only after a warm system reboot. Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
由 Malcolm Priestley 提交于
Re: [git:v4l-dvb/for_v3.3] [media] it9135: add support for IT9135 9005 devices On Sun, 2011-12-11 at 11:55 +0100, Mauro Carvalho Chehab wrote: > This is an automatic generated email to let you know that the following patch were queued at the > http://git.linuxtv.org/media_tree.git tree: > > Subject: [media] it9135: add support for IT9135 9005 devices > Author: Malcolm Priestley <tvboxspy@gmail.com> > Date: Wed Nov 30 17:16:09 2011 -0300 > > Support add for IT9135 9005 devices > > With this patch IT9135 devices now move to using > dvb-usb-it9135-01.fw firmware > IT9137 remain on previous firmware. Hi Mauro, I have made a small mistake on this patch. I forgot to increase number of num_device_descs to 4. Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
- 11 12月, 2011 7 次提交
-
-
由 Malcolm Priestley 提交于
If there are two or more different it913x devices on the system they share the same ite_config and over write its settings. To over come this, the ite_config is copied to the priv area. Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
由 Malcolm Priestley 提交于
This a bus repeater for it913x devices. Commands usually fail because of other activity on the USB bus. Bulk failures that report -ETIMEDOUT or -EBUSY are repeated. Enpoints that return actlen not equal len request -EAGAIN. The retry is set at 10. Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
由 Malcolm Priestley 提交于
Support add for IT9135 9005 devices With this patch IT9135 devices now move to using dvb-usb-it9135-01.fw firmware IT9137 remain on previous firmware. IT9135 devices seem more stable on this firmware. If the user wishes to remain on it9137 firmware they can change back using firmware=1 module option. Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
由 Malcolm Priestley 提交于
Multi firmware loader This uses scatter write firmware headers The firmware must start with 03 XX 00 and be the extract firmware length. I have tried all available firmwares with this loader. Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
由 Malcolm Priestley 提交于
Add support for NEC extended keys. The default remote has now changed to RC_MAP_MSI_DIGIVOX_III Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
由 Malcolm Priestley 提交于
There appears to be differences in the tuner registers on earlier IT9135 devices. Using the current IT9137 settings cause corruptions on some channels This patch is in preparation for multi firmware loading and current unsupported types. Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
由 Malcolm Priestley 提交于
Previously endpoint had been aligned to packet size (128) Some early it9135 devices appear to have problems with this. This patch now aligns with mpeg TS size (188) With the pid filter off max size is increased to the maxmium size (348 * 188) Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
- 08 11月, 2011 2 次提交
-
-
由 Malcolm Priestley 提交于
This indeed a clone of Kworld UB499 2T Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
由 Malcolm Priestley 提交于
IT9135 devices do support USB 1. Support added with restricton on pid count to 5. IT9137 devices wil not connect in USB 1 mode. Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
- 07 11月, 2011 1 次提交
-
-
由 Malcolm Priestley 提交于
Support for version 2 type chips and other LNA versions of version 1 Scripts may be compressed slightly at a later stage. TODO Firmware loader However, things are a little confusing, it is not clear that dvb-usb-it9137-01.fw does not work with version 2 chips as in recent files both firmwares are the same. Should be applied to: 8133 Support for single ITE 9135 device. Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
- 04 11月, 2011 1 次提交
-
-
由 Malcolm Priestley 提交于
Support for single ITE 9135 device. Only single devices have been tested. Dual ITE 9135 devices should work, but have not been tested. TODOs support for ver 2 chip config for other tuner types. rework of firmware file. Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
- 24 9月, 2011 1 次提交
-
-
由 tvboxspy 提交于
Add remote support for KWORLD UB499-2T-T09 The remote supplied is the same as KWORLD_315U. Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
- 07 9月, 2011 1 次提交
-
-
由 Michael Krufky 提交于
refactor MFE code to allow for individual streaming configuration for each frontend Signed-off-by: NMichael Krufky <mkrufky@kernellabs.com> Reviewed-by: NAntti Palosaari <crope@iki.fi> Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-
- 27 8月, 2011 1 次提交
-
-
由 Malcolm Priestley 提交于
Driver for Kworld UB499-2T (id 1b80:e409) The device driver has been named it913x, so that support for other family members can be added later. TODOs Firmware support for other it913x devices. Remote control support, there are two known types. Signed-off-by: NMalcolm Priestley <tvboxspy@gmail.com> [mchehab@redhat.com: Fix a merge conflict] Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>
-