- 12 1月, 2006 2 次提交
-
-
由 Venkatesh Pallipadi 提交于
Whenever we see that a CPU is capable of C3 (during ACPI cstate init), we disable local APIC timer and switch to using a broadcast from external timer interrupt (IRQ 0). Patch below adds the code for x86_64. Signed-off-by: NVenkatesh Pallipadi <venkatesh.pallipadi@intel.com> Signed-off-by: NAndi Kleen <ak@suse.de> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
由 Venkatesh Pallipadi 提交于
Remove the finer control of local APIC timer. We cannot provide a sub-jiffy control like this when we use broadcast from external timer in place of local APIC. Instead of removing this only on systems that may end up using broadcast from external timer (due to C3), I am going the "I'm feeling lucky" way to remove this fully. Basically, I am not sure about usefulness of this code today. Few other architectures also don't seem to support this today. If you are using profiling and fine grained control and don't like this going away in normal case, yell at me right now. Signed-off-by: NVenkatesh Pallipadi <venkatesh.pallipadi@intel.com> Signed-off-by: NAndi Kleen <ak@suse.de> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
- 15 11月, 2005 1 次提交
-
-
由 Jacob Shin 提交于
MC4_MISC - DRAM Errors Threshold Register realized under AMD K8 Rev F. This register is used to count correctable and uncorrectable ECC errors that occur during DRAM read operations. The user may interface through sysfs files in order to change the threshold configuration. bank%d/error_count - reads current error count, write to clear. bank%d/interrupt_enable - set/clear interrupt enable. bank%d/threshold_limit - read/write the threshold limit. APIC vector 0xF9 in hw_irq.h. 5 software defined bank ids in mce.h. new apic.c function to setup threshold apic lvt. defaults to interrupt off, count enabled, and threshold limit max. sysfs interface created on /sys/devices/system/threshold. AK: added some ifdefs to make it compile on UP Signed-off-by: NJacob Shin <jacob.shin@amd.com> Signed-off-by: NAndi Kleen <ak@suse.de> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
- 13 9月, 2005 5 次提交
-
-
由 Al Viro 提交于
... and with that all instances in arch/x86_64 are gone. Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
由 Andi Kleen 提交于
It could be wrong for kexec or other cases. Read it from the CPU instead. Signed-off-by: NMurali <muralim@in.ibm.com> Signed-off-by: NAndi Kleen <ak@suse.de> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
由 Andi Kleen 提交于
Originally from Stuart Hayes. When setting up the APIC for the Uniprocessor kernel don't assume the CPU has an APIC ID of zero. This fixes boot with the UP kernel on Dell PowerEdge 6800/6850 4way systems. Cc: Stuart.Hayes@dell.com Signed-off-by: NAndi Kleen <ak@suse.de> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
由 Andi Kleen 提交于
No x86-64 chipset has these APICs. Signed-off-by: NAndi Kleen <ak@suse.de> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
由 Andi Kleen 提交于
This was just needed for the Numasaurus, which fortunately doesn't support x86-64 CPUs. Signed-off-by: NAndi Kleen <ak@suse.de> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
- 26 6月, 2005 2 次提交
-
-
由 Eric W. Biederman 提交于
When coming out of apic mode attempt to set the appropriate apic back into virtual wire mode. This improves on previous versions of this patch by by never setting bot the local apic and the ioapic into veritual wire mode. This code looks at data from the mptable to see if an ioapic has an ExtInt input to make this decision. A future improvement is to figure out which apic or ioapic was in virtual wire mode at boot time and to remember it. That is potentially a more accurate method, of selecting which apic to place in virutal wire mode. Signed-off-by: NEric Biederman <ebiederm@xmission.com> Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
由 Ashok Raj 提交于
This patch adds __cpuinit and __cpuinitdata sections that need to exist past boot to support cpu hotplug. Caveat: This is done *only* for EM64T CPU Hotplug support, on request from Andi Kleen. Much of the generic hotplug code in kernel, and none of the other archs that support CPU hotplug today, i386, ia64, ppc64, s390 and parisc dont mark sections with __cpuinit, but only mark them as __devinit, and __devinitdata. If someone is motivated to change generic code, we need to make sure all existing hotplug code does not break, on other arch's that dont use __cpuinit, and __cpudevinit. Signed-off-by: NAshok Raj <ashok.raj@intel.com> Acked-by: NAndi Kleen <ak@muc.de> Acked-by: NZwane Mwaikambo <zwane@arm.linux.org.uk> Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
- 17 5月, 2005 2 次提交
-
-
由 Andi Kleen 提交于
Collected NMI watchdog fixes. - Fix call of check_nmi_watchdog - Remove earlier move of check_nmi_watchdog to later. It does not fix the race it was supposed to fix fully. - Remove unused P6 definitions - Add support for performance counter based watchdog on P4 systems. This allows to run it only once per second, which saves some CPU time. Previously it would run at 1000Hz, which was too much. Code ported from i386 Make this the default on Intel systems. - Use check_nmi_watchdog with local APIC based nmi - Fix race in touch_nmi_watchdog - Fix bug that caused incorrect performance counters to be programmed in a few cases on K8. - Remove useless check for local APIC - Use local_t and per_cpu variables for per CPU data. - Keep other CPUs busy during check_nmi_watchdog to make sure they really tick when in lapic mode. - Only check CPUs that are actually online. - Various other fixes. - Fix fallback path when MSRs are unimplemented Signed-off-by: NAndi Kleen <ak@suse.de> Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
由 Suresh Siddha 提交于
Use bitmap_zero instead of bitmap_empty to initialise cpu mask This makes it actually run reliable instead of relying on stack state. Signed-off-by: NSuresh Siddha <suresh.b.siddha@intel.com> Signed-off-by: NAndi Kleen <ak@suse.de> Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
- 17 4月, 2005 2 次提交
-
-
由 Pavel Machek 提交于
I thought I'm done with fixing u32 vs. pm_message_t ... unfortunately that turned out not to be the case... Here are fixes x86-64. Signed-off-by: NPavel Machek <pavel@suse.cz> Signed-off-by: NAndrew Morton <akpm@osdl.org> Signed-off-by: NLinus Torvalds <torvalds@osdl.org>
-
由 Linus Torvalds 提交于
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
-