Remove old task switch code from x86.c
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Implement emulation of 16/32 bit task switch in emulator.c
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Provide get_cached_descriptor(), set_cached_descriptor(),
get_segment_selector(), set_segment_selector(), get_gdt(),
write_std() callbacks.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

When x86_emulate_insn() does not know how to emulate instruction it
exits via cannot_emulate label in all cases except when emulating
grp3. Fix that.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

If LOCK prefix is used dest arg should be memory, otherwise instruction
should generate #UD.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Return X86EMUL_PROPAGATE_FAULT is fault was injected. Also inject #UD
for those instruction when appropriate.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

If CR4.DE=1 access to registers DR4/DR5 cause #UD.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Resent spec says that for 0f (20|21|22|23) the 2 bits in the mod field
are ignored. Interestingly enough older spec says that 11 is only valid
encoding.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

It is undefined and should generate #UD.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

mov r/m, sreg generates #UD ins sreg is incorrect.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Eliminate the need to call back into KVM to get it from emulator.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Use (get|set)_cr callback to emulate lmsw inside emulator.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Use this callback instead of directly call kvm function. Also rename
realmode_(set|get)_cr to emulator_(set|get)_cr since function has nothing
to do with real mode.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

kvm_coalesced_mmio_init() keeps to hold the addresses of a coalesced
mmio ring page and dev even after it has freed them.

Also, if this function fails, though it might be rare, it seems to be
suggesting the system's serious state: so we'd better stop the works
following the kvm_creat_vm().

This patch clears these problems.

  We move the coalesced mmio's initialization out of kvm_create_vm().
  This seems to be natural because it includes a registration which
  can be done only when vm is successfully created.
Signed-off-by: NTakuya Yoshikawa <yoshikawa.takuya@oss.ntt.co.jp>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Make use of bool as return values, and remove some useless
bool value converting. Thanks Avi to point this out.
Signed-off-by: NGui Jianfeng <guijianfeng@cn.fujitsu.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Mov reg, cr instruction doesn't change flags in any meaningful way, so
no need to update rflags after instruction execution.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Check return value against correct define instead of open code
the value.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

During rep emulation access length to RCX depends on current address
mode.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Set correct operation length. Add RAX (64bit) handling.
Signed-off-by: NGleb Natapov <gleb@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Commit fb341f57 removed the pte prefetch on guest invlpg, citing guest races.
However, the SDM is adamant that prefetch is allowed:

  "The processor may create entries in paging-structure caches for
   translations required for prefetches and for accesses that are a
   result of speculative execution that would never actually occur
   in the executed code path."

And, in fact, there was a race in the prefetch code: we picked up the pte
without the mmu lock held, so an older invlpg could install the pte over
a newer invlpg.

Reinstate the prefetch logic, but this time note whether another invlpg has
executed using a counter.  If a race occured, do not install the pte.
Signed-off-by: NAvi Kivity <avi@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

The update_pte() path currently uses a nontrapping spte when a nonpresent
(or nonaccessed) gpte is written.  This is fine since at present it is only
used on sync pages.  However, on an unsync page this will cause an endless
fault loop as the guest is under no obligation to invlpg a gpte that
transitions from nonpresent to present.

Needed for the next patch which reinstates update_pte() on invlpg.
Signed-off-by: NAvi Kivity <avi@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Currently emulated atomic operations are immediately followed by a non-atomic
operation, so that kvm_mmu_pte_write() can be invoked.  This updates the mmu
but undoes the whole point of doing things atomically.

Fix by only performing the atomic operation and the mmu update, and avoiding
the non-atomic write.
Signed-off-by: NAvi Kivity <avi@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Once upon a time, locked operations were emulated while holding the mmu mutex.
Since mmu pages were write protected, it was safe to emulate the writes in
a non-atomic manner, since there could be no other writer, either in the
guest or in the kernel.

These days emulation takes place without holding the mmu spinlock, so the
write could be preempted by an unshadowing event, which exposes the page
to writes by the guest.  This may cause corruption of guest page tables.

Fix by using an atomic cmpxchg for these operations.
Signed-off-by: NAvi Kivity <avi@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

kvm_mmu_pte_write() reads guest ptes in two different occasions, both to
allow a 32-bit pae guest to update a pte with 4-byte writes.  Consolidate
these into a single read, which also allows us to consolidate another read
from an invlpg speculating a gpte into the shadow page table.
Signed-off-by: NAvi Kivity <avi@redhat.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Free IRQ's and disable MSIX upon failure.

Cc: Avi Kivity <avi@redhat.com>
Signed-off-by: NJing Zhang <zj.barak@gmail.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

This patch change the errno of ioctl KVM_[UN]REGISTER_COALESCED_MMIO
from -EINVAL to -ENXIO if no coalesced mmio dev exists.
Signed-off-by: NWei Yongjun <yjwei@cn.fujitsu.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

If no irq chip in kernel, ioctl KVM_IRQ_LINE will return -EFAULT.
But I see in other place such as KVM_[GET|SET]IRQCHIP, -ENXIO is
return. So this patch used -ENXIO instead of -EFAULT.
Signed-off-by: NWei Yongjun <yjwei@cn.fujitsu.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

If no irq chip in kernel, ioctl KVM_IRQ_LINE will return -EFAULT.
But I see in other place such as KVM_[GET|SET]IRQCHIP, -ENXIO is
return. So this patch used -ENXIO instead of -EFAULT.
Signed-off-by: NWei Yongjun <yjwei@cn.fujitsu.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

The ioctl KVM_IA64_VCPU_GET_STACK does not set the error code if
copy_to_user() fail, and 0 will be return, we should use -EFAULT
instead of 0 in this case, so this patch fixed it.
Signed-off-by: NWei Yongjun <yjwei@cn.fujitsu.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

This patch use generic linux function native_store_idt()
instead of kvm_get_idt(), and also removed the useless
function kvm_get_idt().
Signed-off-by: NWei Yongjun <yjwei@cn.fujitsu.com>
Signed-off-by: NMarcelo Tosatti <mtosatti@redhat.com>

Often an exception can help point out where things start to go wrong.
Signed-off-by: NAvi Kivity <avi@redhat.com>

Reading rip is expensive on vmx, so move it inside the tracepoint so we only
incur the cost if tracing is enabled.
Signed-off-by: NAvi Kivity <avi@redhat.com>

The prep_new_page() in page allocator calls set_page_private(page, 0).
So we don't need to reinitialize private of page.
Signed-off-by: NMinchan Kim <minchan.kim@gmail.com>
Cc: Avi Kivity<avi@redhat.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

This patch does:

 - no need call tracepoint_synchronize_unregister() when kvm module
   is unloaded since ftrace can handle it

 - cleanup ftrace's macro
Signed-off-by: NXiao Guangrong <xiaoguangrong@cn.fujitsu.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

If fail to create the vcpu, we should not create the debugfs
for it.
Signed-off-by: NWei Yongjun <yjwei@cn.fujitsu.com>
Acked-by: NAlexander Graf <agraf@suse.de>
Cc: stable@kernel.org
Signed-off-by: NAvi Kivity <avi@redhat.com>

This patch fixed possible memory leak in kvm_arch_vcpu_create()
under s390, which would happen when kvm_arch_vcpu_create() fails.
Signed-off-by: NWei Yongjun <yjwei@cn.fujitsu.com>
Acked-by: NCarsten Otte <cotte@de.ibm.com>
Cc: stable@kernel.org
Signed-off-by: NAvi Kivity <avi@redhat.com>