- 06 9月, 2008 1 次提交
-
-
由 Nick Kossifidis 提交于
* No code changes... * Split hw.c to multiple files for better maintenance and add some documentation on each file code is going to grow soon (eeprom.c for example is going to get much stuff currently developed on ath_info) so it's better this way. * Rename following functions to maintain naming scheme: ah_setup_xtx_desc -> ah_setup_mrr_tx_desc (Because xtx doesn't say much, it's actually a multi-rate-retry tx descriptor) ath5k_hw_put_tx/rx_buf - > ath5k_hw_set_tx/rxdp ath5k_hw_get_tx/rx_buf -> ath5k_hw_get_tx/rxdp (We don't put any "buf" we set descriptor pointers on hw) ath5k_hw_tx_start -> ath5k_hw_start_tx_dma ath5k_hw_start_rx -> ath5k_hw_start_rx_dma ath5k_hw_stop_pcu_recv -> ath5k_hw_stop_rx_pcu (It's easier this way to identify them, we also have ath5k_hw_start_rx_pcu which completes the set) ath5k_hw_set_intr -> ath5k_hw_set_imr (As in get_isr we set imr here, not "intr") * Move ath5k_hw_setup_rx_desc on ah->ah_setup_rx_desc so we can include support for different rx descriptors in the future * Further cleanups so that checkpatch doesn't complain (only some > 80 col warnings for eeprom.h and reg.h as usual due to comments) Tested on 5211 and 5213 cards and works ok. Changes-licensed-under: ISC Signed-off-by: NNick Kossifidis <mickflemm@gmail.com> Acked-by: NLuis R. Rodriguez <lrodriguez@atheros.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
- 02 8月, 2008 1 次提交
-
-
由 Nick Kossifidis 提交于
* Update list of registers * Use updated register macros inside hw.c, initvals.c and debug.c Changes-licensed-under: ISC Signed-off-by: NNick Kossifidis <mickflemm@gmail.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
- 17 4月, 2008 1 次提交
-
-
由 Nick Kossifidis 提交于
*Add RF2425 initvals (still no rx/tx) This was on my laptop for a long time so it has to go out even if it still doesn't work, i hope i'll get my hands on an eeepc so i can work this out. base.c Changes-licensed-under: 3-clause-BSD rest Changes-licensed-under: ISC Signed-off-by: NNick Kossifidis <mickflemm@gmail.com> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
- 08 3月, 2008 1 次提交
-
-
由 Nick Kossifidis 提交于
* Add initial settings for RF2413 Changes-licensed-under: ISC Signed-off-by: NNick Kossifidis <mickflemm@gmail.com> Signed-off-by: NLuis R. Rodriguez <mcgrof@winlab.rutgers.edu> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
- 01 3月, 2008 2 次提交
-
-
由 Luis R. Rodriguez 提交于
Cleanup after API changes patch (checkpatch.pl stuff) and on ath5k_hw_channel() make use of the existing ath5k_channel_ok() instead of re-implementing the checks again. This was necessary to make the code cleaner and fit the 80-chars wide limit so sending it within the same patch. Finally make a note that we *may* eventually move cap_range stuff to struct wiphy (band frequency range capabilities). This information can later be exported to userspace, for example, and giving it access to mac80211 and drivers in general can come in handy. Changes to initvals.c, phy.c Changes-licensed-under: ISC Changes to ath5k.h, base.c Changes-licensed-under: 3-Clause-BSD Signed-off-by: NLuis R. Rodriguez <mcgrof@winlab.rutgers.edu> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
由 Luis R. Rodriguez 提交于
Author: Nick Kossifidis <mickflemm@gmail.com> Tested on 5211, 5213+5112, 5213A+2112A and it wors fine. Also i figured out a way to process rate vallue found on status descriptors, it's still buggy but we are getting closer (i think it improved stability a little). Changes to hw.c, initvals.c, phy.c Changes-licensed-under: ISC Changes to ath5k.h, base.c, base.h Changes-licensed-under: 3-Clause-BSD Acked-by: NJiri Slaby <jirislaby@gmail.com> Signed-off-by: NNick Kossifidis <mickflemm@gmail.com> Signed-off-by: NLuis R. Rodriguez <mcgrof@winlab.rutgers.edu> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-
- 29 1月, 2008 1 次提交
-
-
由 Jiri Slaby 提交于
add ath5k wireless driver Portions of this driver are covered by one or both of the ISC and 3-clause BSD licenses. Specific license information is cited at the top of each file. Acked-by and Signed-off-by information is collected from individual patches as collected in the wireless-2.6 tree prior to upstream submission. Acked-by: NMatthew W. S. Bell <mentor@madwifi.org> Acked-by: NMichael Taylor <mike.taylor@apprion.com> Acked-by: NPavel Roskin <proski@gnu.org> Signed-off-by: NAndrew Morton <akpm@linux-foundation.org> Signed-off-by: NBradley M. Kuhn <bkuhn@softwarefreedom.org> Signed-off-by: NBruno Randolf <bruno@thinktube.com> Signed-off-by: NDave Young <hidave.darkstar@gmail.com> Signed-off-by: NFrancesco Gringoli <francesco.gringoli@ing.unibs.it> Signed-off-by: NJiri Slaby <jirislaby@gmail.com> Signed-off-by: NJohannes Berg <johannes@sipsolutions.net> Signed-off-by: NKaren Sandler <karen@softwarefreedom.org> Signed-off-by: NKrzysztof Halasa <khc@pm.waw.pl> Signed-off-by: NLuis R. Rodriguez <mcgrof@gmail.com> Signed-off-by: NMatt Norwood <norwood@softwarefreedom.org> Signed-off-by: NNick Kossifidis <mickflemm@gmail.com> Signed-off-by: NRichard Fontana <fontana@softwarefreedom.org> Signed-off-by: NStephen Hemminger <shemminger@linux-foundation.org> Signed-off-by: NUlrich Meis <meis@nets.rwth-aachen.de> Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
-