Skip to content

cloud-kernel
cloud-kernel

openanolis / cloud-kernel
1 年多 前同步成功

通知 163
Star 36
Fork 7
cloud-kernel
cloud-kernel
切换分支/标签
  1. 05 2月, 2015 4 次提交
  3. 04 2月, 2015 15 次提交
  5. 26 1月, 2015 2 次提交
  7. 22 1月, 2015 1 次提交
  9. 20 1月, 2015 1 次提交
  11. 07 1月, 2015 1 次提交
  13. 06 1月, 2015 5 次提交
    • Z
      ACPI/int340x_thermal: enumerate INT3401 for Intel SoC DTS thermal driver · 014d9d5d
      由 Zhang Rui 提交于 
      Intel SoC DTS thermal driver on Baytrail platform uses IRQ 86 for
critical overheating notification.
But this IRQ 86 is described in the _CRS control method of INT3401 device,
thus we should enumerate INT3401 to set the IRQ descriptor when
Intel SoC DTS thermal driver is built.
Signed-off-by: NZhang Rui <rui.zhang@intel.com>
Tested-by: NSrinivas Pandruvada <srinivas.pandruvada@linux.intel.com>
      014d9d5d
    • Z
      ACPI/int340x_thermal: enumerate INT340X devices even if they're not in _ART/_TRT · 48628e40
      由 Zhang Rui 提交于 
      For some INT340X thermal devices, even if they are not referred in
_TRT/_ART table, they still can be used by userspace for thermal control.
Thus change the code to enumerated all the INT340X devices,
no matter if they're referred in _TRT/_ART or not.
Signed-off-by: NZhang Rui <rui.zhang@intel.com>
Tested-by: NSrinivas Pandruvada <srinivas.pandruvada@linux.intel.com>
      48628e40
    • H
      ACPI / processor: Rename acpi_(un)map_lsapic() to acpi_(un)map_cpu() · d02dc27d
      由 Hanjun Guo 提交于 
      acpi_map_lsapic() will allocate a logical CPU number and map it to
physical CPU id (such as APIC id) for the hot-added CPU, it will also
do some mapping for NUMA node id and etc, acpi_unmap_lsapic() will
do the reverse.

We can see that the name of the function is a little bit confusing and
arch (IA64) dependent so rename them as acpi_(un)map_cpu() to make arch
agnostic and explicit.
Signed-off-by: NHanjun Guo <hanjun.guo@linaro.org>
Signed-off-by: NRafael J. Wysocki <rafael.j.wysocki@intel.com>
      d02dc27d
    • H
      ACPI / processor: Convert apic_id to phys_id to make it arch agnostic · af8f3f51
      由 Hanjun Guo 提交于 
      apic_id in MADT table is the CPU hardware id which identify
it self in the system for x86 and ia64, OSPM will use it for
SMP init to map APIC ID to logical cpu number in the early
boot, when the DSDT/SSDT (ACPI namespace) is scanned later, the
ACPI processor driver is probed and the driver will use acpi_id
in DSDT to get the apic_id, then map to the logical cpu number
which is needed by the processor driver.

Before ACPI 5.0, only x86 and ia64 were supported in ACPI spec,
so apic_id is used both in arch code and ACPI core which is
pretty fine. Since ACPI 5.0, ARM is supported by ACPI and
APIC is not available on ARM, this will confuse people when
apic_id is both used by x86 and ARM in one function.

So convert apic_id to phys_id (which is the original meaning)
in ACPI processor dirver to make it arch agnostic, but leave the
arch dependent code unchanged, no functional change.
Signed-off-by: NHanjun Guo <hanjun.guo@linaro.org>
Signed-off-by: NRafael J. Wysocki <rafael.j.wysocki@intel.com>
      af8f3f51
    • R
      ACPI / PM: Fix PM initialization for devices that are not present · 1b1f3e16
      由 Rafael J. Wysocki 提交于 
      If an ACPI device object whose _STA returns 0 (not present and not
functional) has _PR0 or _PS0, its power_manageable flag will be set
and acpi_bus_init_power() will return 0 for it.  Consequently, if
such a device object is passed to the ACPI device PM functions, they
will attempt to carry out the requested operation on the device,
although they should not do that for devices that are not present.

To fix that problem make acpi_bus_init_power() return an error code
for devices that are not present which will cause power_manageable to
be cleared for them as appropriate in acpi_bus_get_power_flags().
However, the lists of power resources should not be freed for the
device in that case, so modify acpi_bus_get_power_flags() to keep
those lists even if acpi_bus_init_power() returns an error.
Accordingly, when deciding whether or not the lists of power
resources need to be freed, acpi_free_power_resources_lists()
should check the power.flags.power_resources flag instead of
flags.power_manageable, so make that change too.

Furthermore, if acpi_bus_attach() sees that flags.initialized is
unset for the given device, it should reset the power management
settings of the device and re-initialize them from scratch instead
of relying on the previous settings (the device may have appeared
after being not present previously, for example), so make it use
the 'valid' flag of the D0 power state as the initial value of
flags.power_manageable for it and call acpi_bus_init_power() to
discover its current power state.
Signed-off-by: NRafael J. Wysocki <rafael.j.wysocki@intel.com>
Reviewed-by: NMika Westerberg <mika.westerberg@linux.intel.com>
Cc: 3.10+ <stable@vger.kernel.org> # 3.10+
      1b1f3e16
  15. 23 12月, 2014 1 次提交
  17. 17 12月, 2014 1 次提交
    • L
      cpuidle / ACPI: remove unused CPUIDLE_FLAG_TIME_INVALID · 62c4cf97
      由 Len Brown 提交于 
      CPUIDLE_FLAG_TIME_INVALID is no longer checked
by menu or ladder cpuidle governors, so don't
bother setting or defining it.

It was originally invented to account for the fact that
acpi_safe_halt() enables interrupts to invoke HLT.
That would allow interrupt service routines to be included
in the last_idle duration measurements made in cpuidle_enter_state(),
potentially returning a duration much larger than reality.

But menu and ladder can gracefully handle erroneously large duration
intervals without checking for CPUIDLE_FLAG_TIME_INVALID.
Further, if they don't check CPUIDLE_FLAG_TIME_INVALID, they
can also benefit from the instances when the duration interval
is not erroneously large.
Signed-off-by: NLen Brown <len.brown@intel.com>
Acked-by: NDaniel Lezcano <daniel.lezcano@linaro.org>
Signed-off-by: NRafael J. Wysocki <rafael.j.wysocki@intel.com>
      62c4cf97
  19. 16 12月, 2014 3 次提交
    • J
      x86, irq: Keep balance of IOAPIC pin reference count · cffe0a2b
      由 Jiang Liu 提交于 
      To keep balance of IOAPIC pin reference count, we need to protect
pirq_enable_irq(), acpi_pci_irq_enable() and intel_mid_pci_irq_enable()
from reentrance. There are two cases which will cause reentrance.

The first case is caused by suspend/hibernation. If pcibios_disable_irq
is called during suspending/hibernating, we don't release the assigned
IRQ number, otherwise it may break the suspend/hibernation. So late when
pcibios_enable_irq is called during resume, we shouldn't allocate IRQ
number again.

The second case is that function acpi_pci_irq_enable() may be called
twice for PCI devices present at boot time as below:
1) pci_acpi_init()
	--> acpi_pci_irq_enable() if pci_routeirq is true
2) pci_enable_device()
	--> pcibios_enable_device()
		--> acpi_pci_irq_enable()
We can't kill kernel parameter pci_routeirq yet because it's still
needed for debugging purpose.

So flag irq_managed is introduced to track whether IRQ number is
assigned by OS and to protect pirq_enable_irq(), acpi_pci_irq_enable()
and intel_mid_pci_irq_enable() from reentrance.
Signed-off-by: NJiang Liu <jiang.liu@linux.intel.com>
Cc: Konrad Rzeszutek Wilk <konrad.wilk@oracle.com>
Cc: Tony Luck <tony.luck@intel.com>
Cc: Joerg Roedel <joro@8bytes.org>
Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: Rafael J. Wysocki <rjw@rjwysocki.net>
Cc: Bjorn Helgaas <bhelgaas@google.com>
Cc: Randy Dunlap <rdunlap@infradead.org>
Cc: Yinghai Lu <yinghai@kernel.org>
Cc: Borislav Petkov <bp@alien8.de>
Cc: Len Brown <lenb@kernel.org>
Link: http://lkml.kernel.org/r/1414387308-27148-13-git-send-email-jiang.liu@linux.intel.comSigned-off-by: NThomas Gleixner <tglx@linutronix.de>
      cffe0a2b
    • J
      ACPI: Fix minor syntax issues in processor_core.c · 13ca62b2
      由 Jiang Liu 提交于 
      Fix minor syntax issues in processor_core.c to follow coding styles.
Signed-off-by: NJiang Liu <jiang.liu@linux.intel.com>
Cc: Konrad Rzeszutek Wilk <konrad.wilk@oracle.com>
Cc: Tony Luck <tony.luck@intel.com>
Cc: Joerg Roedel <joro@8bytes.org>
Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: Rafael J. Wysocki <rjw@rjwysocki.net>
Cc: Bjorn Helgaas <bhelgaas@google.com>
Cc: Randy Dunlap <rdunlap@infradead.org>
Cc: Yinghai Lu <yinghai@kernel.org>
Cc: Borislav Petkov <bp@alien8.de>
Cc: Len Brown <lenb@kernel.org>
Link: http://lkml.kernel.org/r/1414387308-27148-7-git-send-email-jiang.liu@linux.intel.comSigned-off-by: NThomas Gleixner <tglx@linutronix.de>
      13ca62b2
    • J
      ACPI: Correct return value of acpi_dev_resource_address_space() · 6658c739
      由 Jiang Liu 提交于 
      Change acpi_dev_resource_address_space() to return failure if the
acpi_resource structure can't be converted to an ACPI address64
structure, so caller could correctly detect failure.
Signed-off-by: NJiang Liu <jiang.liu@linux.intel.com>
Acked-by: NRafael J. Wysocki <rjw@rjwysocki.net>
Cc: Konrad Rzeszutek Wilk <konrad.wilk@oracle.com>
Cc: Tony Luck <tony.luck@intel.com>
Cc: Joerg Roedel <joro@8bytes.org>
Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: Bjorn Helgaas <bhelgaas@google.com>
Cc: Randy Dunlap <rdunlap@infradead.org>
Cc: Yinghai Lu <yinghai@kernel.org>
Cc: Borislav Petkov <bp@alien8.de>
Cc: Len Brown <lenb@kernel.org>
Link: http://lkml.kernel.org/r/1414387308-27148-6-git-send-email-jiang.liu@linux.intel.comSigned-off-by: NThomas Gleixner <tglx@linutronix.de>
      6658c739
  21. 15 12月, 2014 2 次提交
  23. 13 12月, 2014 3 次提交
  25. 11 12月, 2014 1 次提交