Skip to content

cloud-kernel
cloud-kernel

openanolis / cloud-kernel
大约 1 年 前同步成功

通知 158
Star 36
Fork 7
cloud-kernel
cloud-kernel

体验新版 GitCode，发现更多精彩内容 >>

切换分支/标签
  1. 22 10月, 2006 1 次提交
  3. 07 10月, 2006 1 次提交
  5. 23 9月, 2006 14 次提交
  7. 29 6月, 2006 1 次提交
  9. 23 6月, 2006 6 次提交
  11. 28 4月, 2006 1 次提交
  13. 31 3月, 2006 2 次提交
    • J
      [ALSA] HDA/Realtek: multiple input mux definitions and pin mode additions · a1e8d2da
      由 Jonathan Woithe 提交于 
      The following patch relative to CVS from 20060324 adds the following
features to the Realtek HDA codec.

1) Define two new pin modes: ALC_PIN_DIR_IN_NOMICBIAS and
   ALC_PIN_DIR_INOUT_NOMICBIAS.  These can be used with jack mode switch
   definitions in mixers to prevent the user being offered the mic bias
   options if the hardware doesn't support it.

2) Add the ability to have different input mux definitions for different
   ADCs.  This is needed because the ALC260 chip uses different mux layouts
   for the two onboard ADCs.  A new field (num_mux_defs) was added to the
   alc_spec and alc_config_preset structures to support this.

3) Adjust numerous comments to make them consistent with the above changes.

4) Utilise the new multi-mux definition functionality for the ALC260 fujitsu
   model to allow recording of the mixer output.

5) Utilise the new multi-mux definition functionality for the ALC260 test
   model to make the mux selections a little less confusing.

6) Allow the headphone jack of the ALC260 acer model to be retasked in
   the mixer.

6) Utilise the new multi-mux definition functionality for the ALC260 acer
   model to give access to the mixer output and the retasked headphone
   jack.

At this stage the *_NOMICBIAS modes are not used.  We have reports that the
"Line" jack of at least some Acer models doesn't pass the bias out, and we
also know that NIDs 0x0f and 0x10 don't seem to accept the mic bias requests
at all.  However, I feel we need to collect more evidence on both counts
before committing to the use of *_NOMICBIAS.  In the case of the Acers, it's
not clear whether this issue (probably caused by the inclusion of DC
blocking capacitors) affects all Acer models or just a small number.  With
the issue with NIDs 0x0f and 0x10 it's unclear whether this is a hardware
bug which will be addressed in later chip revisions or if it's an
intentional restriction.  The datasheet makes no mention of the restriction
so at this stage I'm inclined to consider it a hardware bug.  Comments in
the source reflect this reasoning.

On a similar theme, the headphone jack of the Fujitsu S7020 also doesn't
appear to pass mic bias voltage.  I'm still investigating this however.

With the ability to retask the headphone jack, owners of ALC260-based Acer
laptops should now be able to record 4 channels of audio if they desire. The
multiple mux definitions allow this jack to be presented from both ADCs
(since this mux input is one of those which differs between the muxes).

This patch has been tested on a Fujitsu S7020 laptop and appears to behave
itself both for the "test" and "fujitsu" models.  Definitions using only a
single mux specification also work.  Other ALC chips should be fine but I
cannot test these myself.  The "auto" modes should also continue to function
but again I have not verified this.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      a1e8d2da
    • T
      [ALSA] Add support of LG LW20 laptop · d681518a
      由 Takashi Iwai 提交于 
      Add support of LG LW20 laptop with ALC880 codec (ALSA bug#1572).
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      d681518a
  15. 22 3月, 2006 14 次提交
    • T
      [ALSA] hda-codec - Add support for ASUS P4GPL-X · 84f3430c
      由 Takashi Iwai 提交于 
      Modules: HDA Codec driver

Added the support ASUS P4GPL-X with ALC880 codec.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      84f3430c
    • T
      [ALSA] hda-codec - Fix BIOS auto-configuration · 82bc955f
      由 Takashi Iwai 提交于 
      Modules: HDA Codec driver,HDA generic driver

- Fix autoconfig speaker/hp detection
  Now it allows multiple speaker pins (e.g. Dell laptops have such config)

- Use speaker or hp pins if no line-outs are available
  This fixes the silence output on recent Dell laptops with STAC9200
  (ALSA bug#1843)

- Fix analog/realtek/sigmatel autoconfig parser
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      82bc955f
    • T
      [ALSA] hda-codec - Add model entry for FIC P4M-915GD1 · a12606cf
      由 Takashi Iwai 提交于 
      Modules: HDA Codec driver

Add model entry for FIC P4M-915GD1 with ALC880 codec.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      a12606cf
    • T
      [ALSA] hda-codec - Fix Aopen i915GMm-HFS mobo · ede3531e
      由 Takashi Iwai 提交于 
      Modules: HDA Codec driver

Add a model entry for Aopen i915GMm-HFS mobo with ALC880 codec.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      ede3531e
    • T
      [ALSA] Add default entry for CTL Travel Master U553W · c1fc8047
      由 Takashi Iwai 提交于 
      Modules: HDA Codec driver

Added the default entry of ALC880 configuration table for
CTL Travel Master U553W.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      c1fc8047
    • T
      [ALSA] hda-codec - Add lg model for LG laptop · ae6b813a
      由 Takashi Iwai 提交于 
      Modules: Documentation,HDA Codec driver

Added a new model 'lg' for LG laptop (m1 express dual) with ALC880 codec.
Also clean up the initialization/unsol_event hooks in patch_realtek.c.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      ae6b813a
    • T
      [ALSA] hda-codec - Fix ALC262 for Fujitsu laptop · 834be88d
      由 Takashi Iwai 提交于 
      Modules: HDA Codec driver,HDA generic driver

Add 'fujitsu' model for ALC262 patch to support a FSC laptop.
The internal speaker is turned on/off with jack sensing.

Also fixed alc262 'basic' model.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      834be88d
    • J
      [ALSA] HDA/ALC260: 7/7 - add SPDIF enable to test model · 92621f13
      由 Jonathan Woithe 提交于 
      Modules: HDA Codec driver

This patch adds mixer controls to the 'test' ALC260 model which allow the
user to selectively enable or disable the SPDIF output pins.  This should
assist people identify digital outputs on machines which bring them to the
outside world.

Note that while the patch *should* work, I cannot personally verify it since
my laptop doesn't bring the SPDIF lines out.

As for the GPIO switches added in patch 4, these controls are currently
only compiled in if debug mode is selected.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      92621f13
    • J
      [ALSA] HDA/ALC260: 6/7 - Fujitsu/test model tweaks · f7ace40d
      由 Jonathan Woithe 提交于 
      Modules: HDA Codec driver

This patch is janitorial - it cleans up a number of cosmetic issues with
the 'fujitsu' and 'test' models.  Issues addressed:

 * spaces instead of tabs used for some indents,

 * clarified/corrected selected comments.

Unlike a patch from earlier this week, this keeps both ADCs connected to
the mic1 pin widget by default.  I believe this is the better default, since
some laptops don't bring the line1 widget to the outside world.  Most (if
not all) do bring mic1 out though, so it seems to me that this default
should remain in place.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      f7ace40d
    • J
      [ALSA] HDA/ALC260: 5/7 - add 'acer' model · 0bfc90e9
      由 Jonathan Woithe 提交于 
      Modules: HDA Codec driver

This patch adds a new 'acer' model.  It is based on work by Rimas and many
other dedicated Acer owners over the past few weeks (see bug number
1618) - kudos to them. This adds support for a variety of Acer laptops,
although we are still in the process of collecting pci/subsystem IDs to add.
There are still some potentially outstanding issues: there are reports that
the CD control might not yet be functional for example.  However, the time
is probably right to get a 'first cut' into the kernel which can be refined
as more test reports come in.

From the reports by various Acer owners, this code allows them to record
from internal mics and external jacks.  Playback also seems to work to all
external jacks and the internal speaker.  The 'beep' control doesn't appear
functional at the moment.

This patch depends on the changes made in patch 3/7.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      0bfc90e9
    • J
      [ALSA] HDA/ALC260: 4/7 - add GPIO switches to test model · 5c8f858d
      由 Jonathan Woithe 提交于 
      Modules: HDA Codec driver

This patch adds 'test' model mixer switches for the GPIO controls found on
the ALC260.  It has been found that some laptops (eg: Acer) can use these to
enable particular controls, so it would be useful to have access to these
via the 'test' model.  It will make testing new models easy, especially if
certain outputs cannot be made to work any other way.

This patch *should* work, but because the GPIO pins don't do anything in
my laptop I cannot personally verify that all this works as expected.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      5c8f858d
    • J
      [ALSA] HDA/ALC260: 3/7 - generalise some structures · d57fdac0
      由 Jonathan Woithe 提交于 
      Modules: HDA Codec driver

This patch generalises a structure added for the 'fujitsu' model but which
is potentially useful for other models as well.  It turns the
'alc260_fujitsu_adc_nids' array into 'alc260_dual_adc_nids'; for other
models which decide to utilise the dual ADC functionality there's really
no reason why they need to define their own list of ADC nids.

The 'fujitsu' model preset is adjusted accordingly.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      d57fdac0
    • J
      [ALSA] HDA/ALC260: 2/7 - switch pin buffer enables · cdcd9268
      由 Jonathan Woithe 提交于 
      Modules: HDA Codec driver

This patch adds functionality which switches the input/output buffer enables
of retasking pins when the user changes their mode with the mode control.
This probably reduces noise *slightly* for recording compared to the case
where both input and output buffers were enabled simultaneously.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      cdcd9268
    • J
      [ALSA] HDA/ALC260: 1/7 - Fix test model input mux label · 17e7aec6
      由 Jonathan Woithe 提交于 
      Modules: HDA Codec driver

This patch fixes input mux labels used for the ALC260 'test' model.  This is
needed to avoid confusion which comes about because the two ADCs in the
ALC260 have slightly different mappings for their input selectors. Since
this is just the test model it's sufficient to simply report both options
where they exist.  If a model comes along for which this becomes an issue,
the ALC260 input mux code will have to be extended to allow different mux
layouts for different ADCs.
Signed-off-by: NTakashi Iwai <tiwai@suse.de>
      17e7aec6