Skip to content

cloud-kernel
cloud-kernel

openanolis / cloud-kernel
接近 2 年 前同步成功

通知 170
Star 36
Fork 7
cloud-kernel
cloud-kernel
切换分支/标签
  1. 18 4月, 2018 1 次提交
  3. 11 1月, 2018 1 次提交
  5. 03 11月, 2017 1 次提交
    • T
      ipv6: Implement limits on Hop-by-Hop and Destination options · 47d3d7ac
      由 Tom Herbert 提交于 
      RFC 8200 (IPv6) defines Hop-by-Hop options and Destination options
extension headers. Both of these carry a list of TLVs which is
only limited by the maximum length of the extension header (2048
bytes). By the spec a host must process all the TLVs in these
options, however these could be used as a fairly obvious
denial of service attack. I think this could in fact be
a significant DOS vector on the Internet, one mitigating
factor might be that many FWs drop all packets with EH (and
obviously this is only IPv6) so an Internet wide attack might not
be so effective (yet!).

By my calculation, the worse case packet with TLVs in a standard
1500 byte MTU packet that would be processed by the stack contains
1282 invidual TLVs (including pad TLVS) or 724 two byte TLVs. I
wrote a quick test program that floods a whole bunch of these
packets to a host and sure enough there is substantial time spent
in ip6_parse_tlv. These packets contain nothing but unknown TLVS
(that are ignored), TLV padding, and bogus UDP header with zero
payload length.

  25.38%  [kernel]                    [k] __fib6_clean_all
  21.63%  [kernel]                    [k] ip6_parse_tlv
   4.21%  [kernel]                    [k] __local_bh_enable_ip
   2.18%  [kernel]                    [k] ip6_pol_route.isra.39
   1.98%  [kernel]                    [k] fib6_walk_continue
   1.88%  [kernel]                    [k] _raw_write_lock_bh
   1.65%  [kernel]                    [k] dst_release

This patch adds configurable limits to Destination and Hop-by-Hop
options. There are three limits that may be set:
  - Limit the number of options in a Hop-by-Hop or Destination options
    extension header.
  - Limit the byte length of a Hop-by-Hop or Destination options
    extension header.
  - Disallow unrecognized options in a Hop-by-Hop or Destination
    options extension header.

The limits are set in corresponding sysctls:

  ipv6.sysctl.max_dst_opts_cnt
  ipv6.sysctl.max_hbh_opts_cnt
  ipv6.sysctl.max_dst_opts_len
  ipv6.sysctl.max_hbh_opts_len

If a max_*_opts_cnt is less than zero then unknown TLVs are disallowed.
The number of known TLVs that are allowed is the absolute value of
this number.

If a limit is exceeded when processing an extension header the packet is
dropped.

Default values are set to 8 for options counts, and set to INT_MAX
for maximum length. Note the choice to limit options to 8 is an
arbitrary guess (roughly based on the fact that the stack supports
three HBH options and just one destination option).

These limits have being proposed in draft-ietf-6man-rfc6434-bis.

Tested (by Martin Lau)

I tested out 1 thread (i.e. one raw_udp process).

I changed the net.ipv6.max_dst_(opts|hbh)_number between 8 to 2048.
With sysctls setting to 2048, the softirq% is packed to 100%.
With 8, the softirq% is almost unnoticable from mpstat.

v2;
  - Code and documention cleanup.
  - Change references of RFC2460 to be RFC8200.
  - Add reference to RFC6434-bis where the limits will be in standard.
Signed-off-by: NTom Herbert <tom@quantonium.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      47d3d7ac
  7. 28 10月, 2017 1 次提交
  9. 18 10月, 2017 1 次提交
  11. 08 8月, 2017 1 次提交
  13. 01 8月, 2017 1 次提交
    • P
      udp6: fix jumbogram reception · cb891fa6
      由 Paolo Abeni 提交于 
      Since commit 67a51780 ("ipv6: udp: leverage scratch area
helpers") udp6_recvmsg() read the skb len from the scratch area,
to avoid a cache miss.
But the UDP6 rx path support RFC 2675 UDPv6 jumbograms, and their
length exceeds the 16 bits available in the scratch area. As a side
effect the length returned by recvmsg() is:
<ingress datagram len> % (1<<16)

This commit addresses the issue allocating one more bit in the
IP6CB flags field and setting it for incoming jumbograms.
Such field is still in the first cacheline, so at recvmsg()
time we can check it and fallback to access skb->len if
required, without a measurable overhead.

Fixes: 67a51780 ("ipv6: udp: leverage scratch area helpers")
Signed-off-by: NPaolo Abeni <pabeni@redhat.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      cb891fa6
  15. 04 7月, 2017 1 次提交
  17. 16 6月, 2017 1 次提交
    • J
      networking: make skb_push & __skb_push return void pointers · d58ff351
      由 Johannes Berg 提交于 
      It seems like a historic accident that these return unsigned char *,
and in many places that means casts are required, more often than not.

Make these functions return void * and remove all the casts across
the tree, adding a (u8 *) cast only where the unsigned char pointer
was used directly, all done with the following spatch:

    @@
    expression SKB, LEN;
    typedef u8;
    identifier fn = { skb_push, __skb_push, skb_push_rcsum };
    @@
    - *(fn(SKB, LEN))
    + *(u8 *)fn(SKB, LEN)

    @@
    expression E, SKB, LEN;
    identifier fn = { skb_push, __skb_push, skb_push_rcsum };
    type T;
    @@
    - E = ((T *)(fn(SKB, LEN)))
    + E = fn(SKB, LEN)

    @@
    expression SKB, LEN;
    identifier fn = { skb_push, __skb_push, skb_push_rcsum };
    @@
    - fn(SKB, LEN)[0]
    + *(u8 *)fn(SKB, LEN)

Note that the last part there converts from push(...)[0] to the
more idiomatic *(u8 *)push(...).
Signed-off-by: NJohannes Berg <johannes.berg@intel.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      d58ff351
  19. 02 5月, 2017 1 次提交
  21. 26 4月, 2017 1 次提交
  23. 22 4月, 2017 1 次提交
  25. 04 2月, 2017 1 次提交
  27. 26 12月, 2016 1 次提交
    • T
      ktime: Get rid of the union · 2456e855
      由 Thomas Gleixner 提交于 
      ktime is a union because the initial implementation stored the time in
scalar nanoseconds on 64 bit machine and in a endianess optimized timespec
variant for 32bit machines. The Y2038 cleanup removed the timespec variant
and switched everything to scalar nanoseconds. The union remained, but
become completely pointless.

Get rid of the union and just keep ktime_t as simple typedef of type s64.

The conversion was done with coccinelle and some manual mopping up.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
Cc: Peter Zijlstra <peterz@infradead.org>
      2456e855
  29. 10 11月, 2016 4 次提交
  31. 28 6月, 2016 2 次提交
  33. 28 4月, 2016 1 次提交
  35. 03 12月, 2015 1 次提交
  37. 10 7月, 2015 1 次提交
  39. 12 11月, 2014 1 次提交
    • J
      net: Convert LIMIT_NETDEBUG to net_dbg_ratelimited · ba7a46f1
      由 Joe Perches 提交于 
      Use the more common dynamic_debug capable net_dbg_ratelimited
and remove the LIMIT_NETDEBUG macro.

All messages are still ratelimited.

Some KERN_<LEVEL> uses are changed to KERN_DEBUG.

This may have some negative impact on messages that were
emitted at KERN_INFO that are not not enabled at all unless
DEBUG is defined or dynamic_debug is enabled.  Even so,
these messages are now _not_ emitted by default.

This also eliminates the use of the net_msg_warn sysctl
"/proc/sys/net/core/warnings".  For backward compatibility,
the sysctl is not removed, but it has no function.  The extern
declaration of net_msg_warn is removed from sock.h and made
static in net/core/sysctl_net_core.c

Miscellanea:

o Update the sysctl documentation
o Remove the embedded uses of pr_fmt
o Coalesce format fragments
o Realign arguments
Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      ba7a46f1
  41. 28 10月, 2014 1 次提交
  43. 25 8月, 2014 1 次提交
    • I
      ipv6: White-space cleansing : Line Layouts · 67ba4152
      由 Ian Morris 提交于 
      This patch makes no changes to the logic of the code but simply addresses
coding style issues as detected by checkpatch.

Both objdump and diff -w show no differences.

A number of items are addressed in this patch:
* Multiple spaces converted to tabs
* Spaces before tabs removed.
* Spaces in pointer typing cleansed (char *)foo etc.
* Remove space after sizeof
* Ensure spacing around comparators such as if statements.
Signed-off-by: NIan Morris <ipm@chirality.org.uk>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      67ba4152
  45. 12 9月, 2013 1 次提交
  47. 14 1月, 2013 1 次提交
  49. 16 11月, 2012 5 次提交
  51. 02 11月, 2012 1 次提交
  53. 04 6月, 2012 1 次提交
    • J
      net: Remove casts to same type · e3192690
      由 Joe Perches 提交于 
      Adding casts of objects to the same type is unnecessary
and confusing for a human reader.

For example, this cast:

	int y;
	int *p = (int *)&y;

I used the coccinelle script below to find and remove these
unnecessary casts.  I manually removed the conversions this
script produces of casts with __force and __user.

@@
type T;
T *p;
@@

-	(T *)p
+	p
Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      e3192690
  55. 21 5月, 2012 1 次提交
    • E
      ipv6/exthdrs: strict Pad1 and PadN check · 9b905fe6
      由 Eldad Zack 提交于 
      The following tightens the padding check from commit
c1412fce :

* Take into account combinations of consecutive Pad1 and PadN.

* Catch the corner case of when only padding is present in the
  header, when the extention header length is 0 (i.e., 8 bytes).
  In this case, the header would have exactly 6 bytes of padding:

+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
:  Next Header  : Hdr Ext Len=0 :                               :
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+                               +
:                        Padding (Pad1 or PadN)                 :
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
Signed-off-by: NEldad Zack <eldad@fogrefinery.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      9b905fe6
  57. 19 5月, 2012 1 次提交
  59. 18 5月, 2012 1 次提交
  61. 01 5月, 2012 1 次提交
  63. 13 4月, 2012 1 次提交
    • E
      net/ipv6/exthdrs.c: Strict PadN option checking · c1412fce
      由 Eldad Zack 提交于 
      Added strict checking of PadN, as PadN can be used to increase header
size and thus push the protocol header into the 2nd fragment.

PadN is used to align the options within the Hop-by-Hop or
Destination Options header to 64-bit boundaries. The maximum valid
size is thus 7 bytes.
RFC 4942 recommends to actively check the "payload" itself and
ensure that it contains only zeroes.

See also RFC 4942 section 2.1.9.5.
Signed-off-by: NEldad Zack <eldad@fogrefinery.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      c1412fce