Skip to content

cloud-kernel
cloud-kernel

openanolis / cloud-kernel
1 年多 前同步成功

通知 160
Star 36
Fork 7
cloud-kernel
cloud-kernel
切换分支/标签
  1. 05 5月, 2009 1 次提交
  3. 03 5月, 2009 1 次提交
  5. 02 5月, 2009 4 次提交
  7. 01 5月, 2009 10 次提交
  9. 30 4月, 2009 18 次提交
  11. 29 4月, 2009 6 次提交
    • L
      Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6 · 3dacbdad
      由 Linus Torvalds 提交于 
      * git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-2.6: (24 commits)
  e100: do not go D3 in shutdown unless system is powering off
  netfilter: revised locking for x_tables
  Bluetooth: Fix connection establishment with low security requirement
  Bluetooth: Add different pairing timeout for Legacy Pairing
  Bluetooth: Ensure that HCI sysfs add/del is preempt safe
  net: Avoid extra wakeups of threads blocked in wait_for_packet()
  net: Fix typo in net_device_ops description.
  ipv4: Limit size of route cache hash table
  Add reference to CAPI 2.0 standard
  Documentation/isdn/INTERFACE.CAPI
  update Documentation/isdn/00-INDEX
  ixgbe: Fix WoL functionality for 82599 KX4 devices
  veth: prevent oops caused by netdev destructor
  xfrm: wrong hash value for temporary SA
  forcedeth: tx timeout fix
  net: Fix LL_MAX_HEADER for CONFIG_TR_MODULE
  mlx4_en: Handle page allocation failure during receive
  mlx4_en: Fix cleanup flow on cq activation
  vlan: update vlan carrier state for admin up/down
  netfilter: xt_recent: fix stack overread in compat code
  ...
      3dacbdad
    • P
      perf_counter: powerpc: allow use of limited-function counters · ab7ef2e5
      由 Paul Mackerras 提交于 
      POWER5+ and POWER6 have two hardware counters with limited functionality:
PMC5 counts instructions completed in run state and PMC6 counts cycles
in run state.  (Run state is the state when a hardware RUN bit is 1;
the idle task clears RUN while waiting for work to do and sets it when
there is work to do.)

These counters can't be written to by the kernel, can't generate
interrupts, and don't obey the freeze conditions.  That means we can
only use them for per-task counters (where we know we'll always be in
run state; we can't put a per-task counter on an idle task), and only
if we don't want interrupts and we do want to count in all processor
modes.

Obviously some counters can't go on a limited hardware counter, but there
are also situations where we can only put a counter on a limited hardware
counter - if there are already counters on that exclude some processor
modes and we want to put on a per-task cycle or instruction counter that
doesn't exclude any processor mode, it could go on if it can use a
limited hardware counter.

To keep track of these constraints, this adds a flags argument to the
processor-specific get_alternatives() functions, with three bits defined:
one to say that we can accept alternative event codes that go on limited
counters, one to say we only want alternatives on limited counters, and
one to say that this is a per-task counter and therefore events that are
gated by run state are equivalent to those that aren't (e.g. a "cycles"
event is equivalent to a "cycles in run state" event).  These flags
are computed for each counter and stored in the counter->hw.counter_base
field (slightly wonky name for what it does, but it was an existing
unused field).

Since the limited counters don't freeze when we freeze the other counters,
we need some special handling to avoid getting skew between things counted
on the limited counters and those counted on normal counters.  To minimize
this skew, if we are using any limited counters, we read PMC5 and PMC6
immediately after setting and clearing the freeze bit.  This is done in
a single asm in the new write_mmcr0() function.

The code here is specific to PMC5 and PMC6 being the limited hardware
counters.  Being more general (e.g. having a bitmap of limited hardware
counter numbers) would have meant more complex code to read the limited
counters when freezing and unfreezing the normal counters, with
conditional branches, which would have increased the skew.  Since it
isn't necessary for the code to be more general at this stage, it isn't.

This also extends the back-ends for POWER5+ and POWER6 to be able to
handle up to 6 counters rather than the 4 they previously handled.
Signed-off-by: NPaul Mackerras <paulus@samba.org>
Acked-by: NPeter Zijlstra <a.p.zijlstra@chello.nl>
Cc: Robert Richter <robert.richter@amd.com>
LKML-Reference: <18936.19035.163066.892208@cargo.ozlabs.ibm.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>
      ab7ef2e5
    • I
      perf_counter: add/update copyrights · 98144511
      由 Ingo Molnar 提交于 
      Acked-by: NPeter Zijlstra <a.p.zijlstra@chello.nl>
Signed-off-by: NIngo Molnar <mingo@elte.hu>
      98144511
    • R
      perf_counter: update 'perf top' documentation · 38105f02
      由 Robert Richter 提交于 
      The documentation about the perf-top build was outdated after
perfstat has been implemented. This updates it.

[ Impact: update documentation ]
Signed-off-by: NRobert Richter <robert.richter@amd.com>
Cc: Paul Mackerras <paulus@samba.org>
Acked-by: NPeter Zijlstra <a.p.zijlstra@chello.nl>
LKML-Reference: <1241002046-8832-30-git-send-email-robert.richter@amd.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>
      38105f02
    • R
      perf_counter, x86: remove unused function argument in intel_pmu_get_status() · 19d84dab
      由 Robert Richter 提交于 
      The mask argument is unused and thus can be removed.

[ Impact: cleanup ]
Signed-off-by: NRobert Richter <robert.richter@amd.com>
Cc: Paul Mackerras <paulus@samba.org>
Acked-by: NPeter Zijlstra <a.p.zijlstra@chello.nl>
LKML-Reference: <1241002046-8832-29-git-send-email-robert.richter@amd.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>
      19d84dab
    • R
      perf_counter, x86: remove vendor check in fixed_mode_idx() · ef7b3e09
      由 Robert Richter 提交于 
      The function fixed_mode_idx() is used generically. Now it checks the
num_counters_fixed value instead of the vendor to decide if fixed
counters are present.

[ Impact: generalize code ]
Signed-off-by: NRobert Richter <robert.richter@amd.com>
Cc: Paul Mackerras <paulus@samba.org>
Acked-by: NPeter Zijlstra <a.p.zijlstra@chello.nl>
LKML-Reference: <1241002046-8832-28-git-send-email-robert.richter@amd.com>
Signed-off-by: NIngo Molnar <mingo@elte.hu>
      ef7b3e09