Skip to content

cloud-kernel
cloud-kernel

openanolis / cloud-kernel
1 年多 前同步成功

通知 160
Star 36
Fork 7
cloud-kernel
cloud-kernel
切换分支/标签
  1. 07 2月, 2009 5 次提交
    • D
      net_dma: call dmaengine_get only if NET_DMA enabled · b4bd07c2
      由 David S. Miller 提交于 
      Based upon a patch from Atsushi Nemoto <anemo@mba.ocn.ne.jp>

--------------------
The commit 649274d9 ("net_dma:
acquire/release dma channels on ifup/ifdown") added unconditional call
of dmaengine_get() to net_dma.  The API should be called only if
NET_DMA was enabled.
--------------------
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
Acked-by: NDan Williams <dan.j.williams@intel.com>
      b4bd07c2
    • O
      3c509: Fix resume from hibernation for PnP mode. · 152abd13
      由 Ondrej Zary 提交于 
      From: Ondrej Zary <linux@rainbow-software.org>

last year, I posted a patch which fixed hibernation on 3c509
cards. That was back in 2.6.24. It worked fine in 2.6.25. But then I
stopped using hibernation (as it did not work with my new IT8212 RAID
controller).

Now I fixed it and noticed that 3c509 does not wake up properly
anymore (in 2.6.28) - neither in PnP nor in ISA modes. ifconfig
down/up makes the card work again in PnP mode. However, in ISA mode,
ifconfig up ends with "No such device" error.

Comparing the 3c509 driver between 2.6.25 and 2.6.28, there's only
some statistics-related change. So the cause of the problem must be
somewhere else.

This patch makes the resume work in PnP mode, but it's still not
enough for ISA mode.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      152abd13
    • I
      sungem: Soft lockup in sungem on Netra AC200 when switching interface up · 71822faa
      由 Ilkka Virta 提交于 
      From: Ilkka Virta <itvirta@iki.fi>

In the lockup situation the driver seems to go off in an eternal storm
of interrupts right after calling request_irq(). It doesn't actually
do anything interesting in the interrupt handler. Since connecting the link
afterwards works, something later in initialization must fix this.

Looking at gem_do_start() and gem_open(), it seems that the only thing
done while opening the device after the request_irq(), is a call to
napi_enable().

I don't know what the ordering requirements are for the
initialization, but I boldly tried to move the napi_enable() call
inside gem_do_start() before the link state is checked and interrupts
subsequently enabled, and it seems to work for me. Doesn't even break
anything too obvious...
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      71822faa
    • D
      RxRPC: Fix a potential NULL dereference · 15bde727
      由 David Howells 提交于 
      Fix a potential NULL dereference bug during error handling in
rxrpc_kernel_begin_call(), whereby rxrpc_put_transport() may be handed a NULL
pointer.

This was found with a code checker (http://repo.or.cz/w/smatch.git/).
Reported-by: NDan Carpenter <error27@gmail.com>
Signed-off-by: NDavid Howells <dhowells@redhat.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      15bde727
    • I
      r8169: Don't update statistics counters when interface is down · 355423d0
      由 Ivan Vecera 提交于 
      Some Realtek chips (RTL8169sb/8110sb in my case) are unable to retrieve
ethtool statistics when the interface is down. The process stays in
endless loop in rtl8169_get_ethtool_stats. This is because these chips
need to have receiver enabled (CmdRxEnb bit in ChipCmd register) that is
cleared when the interface is going down. It's better to update statistics
only when the interface is up and otherwise return copy of statistics
grabbed when the interface was up (in rtl8169_close).

It is interesting that PCI-E NICs (like 8168b/8111b...) are not affected.
Signed-off-by: NIvan Vecera <ivecera@redhat.com>
Acked-by: NFrancois Romieu <romieu@fr.zoreil.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      355423d0
  3. 06 2月, 2009 7 次提交
  5. 05 2月, 2009 5 次提交
    • A
      gianfar: Fix potential soft reset race · b98ac702
      由 Andy Fleming 提交于 
      SOFT_RESET must be asserted for at least 3 TX clocks in order for it to work
properly.  The syncs in the gfar_write() commands have been hiding this, but
we need to guarantee it.
Signed-off-by: NAndy Fleming <afleming@freescale.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      b98ac702
    • A
      gianfar: Fix BD_LENGTH_MASK definition · 1fbe4932
      由 Andy Fleming 提交于 
      BD_LENGTH_MASK is supposed to catch the low 16-bits of the status field, not
the low byte.  The old way, we would never be able to clean up tx packets with
sizes divisible by 256.
Signed-off-by: NAndy Fleming <afleming@freescale.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      1fbe4932
    • D
      cxgb3: Fix lro switch · 65ab8385
      由 Divy Le Ray 提交于 
      The LRO switch is always set to 1 in the rx processing loop.
It breaks the accelerated iSCSI receive traffic.
Fix its computation.
Signed-off-by: NDivy Le Ray <divy@chelsio.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      65ab8385
    • R
      iwlwifi: save PCI state before suspend, restore after resume · c4e061ac
      由 Reinette Chatre 提交于 
      This is the right thing to do and fixes the following warning:

[  115.012278] ------------[ cut here ]------------
[  115.012281] WARNING: at drivers/pci/pci-driver.c:370
pci_legacy_suspend+0x85/0xc2()
[  115.012285] Hardware name: Latitude D630
[  115.012301] PCI PM: Device state not saved by
iwl3945_pci_suspend+0x0/0x4c [iwl3945]
[  115.012304] Modules linked in: fuse nfsd lockd nfs_acl auth_rpcgss
exportfs sunrpc ipv6 acpi_cpufreq kvm_intel kvm snd_hda_codec_idt
snd_hda_intel snd_hda_codec snd_hwdep arc4 snd_seq_device snd_pcm_oss
snd_mixer_oss ecb snd_pcm cryptomgr aead snd_timer crypto_blkcipher
snd snd_page_alloc ohci1394 crypto_hash crypto_algapi ch341 ieee1394
usbserial thermal iwl3945 mac80211 led_class lib80211 tg3 processor
i2c_i801 i2c_core sg cfg80211 libphy usbhid battery ac button sr_mod
cdrom evdev dcdbas ata_generic ata_piix libata sd_mod scsi_mod ext3
jbd mbcache uhci_hcd ohci_hcd ehci_hcd usbcore [last unloaded:
microcode]
[  115.012374] Pid: 4163, comm: pm-suspend Not tainted
2.6.29-rc3-00227-gf1dd849-dirty #67
[  115.012377] Call Trace:
[  115.012382]  [<ffffffff8023d04d>] warn_slowpath+0xb1/0xed
[  115.012387]  [<ffffffff80450b5e>] ? _spin_unlock_irqrestore+0x5c/0x78
[  115.012390]  [<ffffffff80254f08>] ? up+0x34/0x39
[  115.012394]  [<ffffffff80362319>] ? acpi_ut_release_mutex+0x5d/0x61
[  115.012397]  [<ffffffff803584b2>] ? acpi_get_data+0x5e/0x70
[  115.012400]  [<ffffffff80363dd9>] ? acpi_bus_get_device+0x25/0x39
[  115.012403]  [<ffffffff80363e98>] ? acpi_bus_power_manageable+0x11/0x29
[  115.012406]  [<ffffffff803462f7>] ? acpi_pci_power_manageable+0x17/0x19
[  115.012410]  [<ffffffff8033ddfd>] ? pci_set_power_state+0xcc/0x101
[  115.012418]  [<ffffffffa01f28e9>] ? iwl3945_pci_suspend+0x0/0x4c [iwl3945]
[  115.012422]  [<ffffffff803401e6>] pci_legacy_suspend+0x85/0xc2
[  115.012425]  [<ffffffff80340316>] pci_pm_suspend+0x34/0x86
[  115.012429]  [<ffffffff8039d7ce>] pm_op+0x52/0xe5
[  115.012432]  [<ffffffff8039dd78>] device_suspend+0x32a/0x451
[  115.012436]  [<ffffffff80269ec2>] suspend_devices_and_enter+0x3e/0x13a
[  115.012439]  [<ffffffff8026a128>] enter_state+0x110/0x164
[  115.012442]  [<ffffffff8026a233>] state_store+0xb7/0xd7
[  115.012446]  [<ffffffff8032f95f>] kobj_attr_store+0x17/0x19
[  115.012449]  [<ffffffff80307d64>] sysfs_write_file+0xe4/0x119
[  115.012453]  [<ffffffff802baa7a>] vfs_write+0xae/0x137
[  115.012456]  [<ffffffff802babc7>] sys_write+0x47/0x70
[  115.012459]  [<ffffffff8020b73a>] system_call_fastpath+0x16/0x1b
[  115.012467] ---[ end trace 829828966f6f24dc ]---
Signed-off-by: NReinette Chatre <reinette.chatre@intel.com>
Tested-by: NMing Lei <tom.leiming@gmail.com>
Cc: Rafael J. Wysocki <rjw@sisk.pl>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
      c4e061ac
    • R
      iwlwifi: clean key table in iwl_clear_stations_table · 5e46882e
      由 Reinette Chatre 提交于 
      Cleans uCode key table bit map iwl_clear_stations_table
since all stations are cleared also the key table must be.

Since the keys are not removed properly on suspend by mac80211
this may result in exhausting key table on resume leading
to memory corruption during removal
Signed-off-by: NTomas Winkler <tomas.winkler@intel.com>
Signed-off-by: NReinette Chatre <reinette.chatre@intel.com>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
      5e46882e
  7. 04 2月, 2009 5 次提交
  9. 03 2月, 2009 18 次提交