- 14 8月, 2009 1 次提交
-
-
由 Matt Fleming 提交于
This is a first cut at a generic DWARF unwinder for the kernel. It's still lacking DWARF64 support and the DWARF expression support hasn't been tested very well but it is generating proper stacktraces on SH for WARN_ON() and NULL dereferences. Signed-off-by: NMatt Fleming <matt@console-pimps.org> Signed-off-by: NPaul Mundt <lethal@linux-sh.org>
-
- 10 3月, 2009 1 次提交
-
-
由 Magnus Damm 提交于
Add Suspend-to-disk / swsusp / CONFIG_HIBERNATION support to the SuperH architecture. To suspend, use "swapon /dev/sda2; echo disk > /sys/power/state" To resume, pass "resume=/dev/sda2" on the kernel command line. The patch "pm: rework includes, remove arch ifdefs V2" is needed to allow the generic swsusp code to build properly. Hibernation is not enabled with this patch though, a patch setting ARCH_HIBERNATION_POSSIBLE will be submitted later. Signed-off-by: NMagnus Damm <damm@igel.co.jp> Signed-off-by: NPaul Mundt <lethal@linux-sh.org>
-
- 29 7月, 2008 1 次提交
-
-
由 Paul Mundt 提交于
This follows the sparc changes a439fe51. Most of the moving about was done with Sam's directions at: http://marc.info/?l=linux-sh&m=121724823706062&w=2 with subsequent hacking and fixups entirely my fault. Signed-off-by: NSam Ravnborg <sam@ravnborg.org> Signed-off-by: NPaul Mundt <lethal@linux-sh.org>
-
- 28 1月, 2008 1 次提交
-
-
由 Stuart Menefy 提交于
Presently most of the 29-bit physical parts do P1/P2 segmentation with a 1:1 cached/uncached mapping, jumping between the two to control the caching behaviour. This provides the basic infrastructure to maintain this behaviour on 32-bit physical parts that don't map P1/P2 at all, using a shiny new linker section and corresponding fixmap entry. Signed-off-by: NStuart Menefy <stuart.menefy@st.com> Signed-off-by: NPaul Mundt <lethal@linux-sh.org>
-
- 24 9月, 2007 1 次提交
-
-
由 Paul Mundt 提交于
The uClinux MTD device uses _ebss, add the symbol and corresponding export. Signed-off-by: NPaul Mundt <lethal@linux-sh.org>
-
- 08 6月, 2007 2 次提交
-
-
由 Paul Mundt 提交于
This fixes up much of the machvec handling, allowing for it to be overloaded on boot. Making practical use of this still requires some Kconfig munging, however. Signed-off-by: NPaul Mundt <lethal@linux-sh.org>
-
由 Paul Mundt 提交于
This adds in some more __user annotations. These weren't being handled properly in some of the __get_user and __put_user paths, so tidy those up. Signed-off-by: NPaul Mundt <lethal@linux-sh.org>
-
- 17 4月, 2005 1 次提交
-
-
由 Linus Torvalds 提交于
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
-