- 30 8月, 2005 40 次提交
-
-
由 Takashi Iwai 提交于
Digigram VX Pocket driver Fixed the wrong index number assignment. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Digigram VX Pocket driver Added the missing event callback. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Memalloc module Fix an error when built without CONFIG_PROC_FS. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
HDA Codec driver Use struct instead of array to improve the readability of hda_codec.c. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Nicolas Graziano 提交于
HDA Codec driver The insertion of the rate 9600 make a shift in detection of supported rate, put this rate at the end of the list. Signed-off-by: NNicolas Graziano <nicolas.graziano@wanadoo.fr> Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Sergey Vlasov 提交于
Intel8x0 driver,AC97 Codec The HP nx6110 laptop needs to have Headphone Jack Sense enabled so that the internal speakers will be turned off when headphones are plugged in. Also ac97_quirk=hp_only is needed to make a single Master volume in the mixer instead of separate volumes for internal speakers and headphones, which just confuses the user. Signed-off-by: NSergey Vlasov <vsu@altlinux.ru> Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Jaroslav Kysela 提交于
AC97 Codec Signed-off-by: NJaroslav Kysela <perex@suse.cz>
-
由 Jaroslav Kysela 提交于
AC97 Codec Signed-off-by: NJaroslav Kysela <perex@suse.cz>
-
由 Takashi Iwai 提交于
VIA82xx driver Added the DXS entry for MSI 7142 (K8MM-V). Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Jaroslav Kysela 提交于
Digigram VX core,CS4231 driver,ATIIXP driver,VIA82xx driver VIA82xx-modem driver,au88x0 driver,CS46xx driver,Trident driver This patch disables SNDRV_PCM_INFO_RESUME flag for drivers which does not support the full resume. Signed-off-by: NJaroslav Kysela <perex@suse.cz>
-
由 Bjorge Dijkstra 提交于
AC97 Codec The patch fixes the bus_id conflict error when registering two codecs of the same type (ALSA bug#1334). Signed-off-by: NBjorge Dijkstra <bjorge@gmx.net> Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
RME9652 driver Fix the module parameter description after proofreading. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
NM256 driver - Fixed the PCM resume - restoring the rate setting - Fixed the handling of buggy irqs - Dynamically acquire/release irq handler to make the driver more robust to unknown irq storms (as OSS driver does). Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
Intel8x0 driver Fixed the PCM resume of intel8x0. Restores the requested register setting. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Jaroslav Kysela 提交于
Timer Midlevel Signed-off-by: NJaroslav Kysela <perex@suse.cz>
-
由 Jaroslav Kysela 提交于
PCM Midlevel,Timer Midlevel,ALSA Core - added SNDRV_TIMER_EVENT_SUSPEND / RESUME events - changed timer events from PAUSE / CONTINUE in PCM midlevel to SUSPEND / RESUME Signed-off-by: NJaroslav Kysela <perex@suse.cz>
-
由 Jaroslav Kysela 提交于
HDA Intel driver - removed SNDRV_PCM_INFO_RESUME (the driver cannot do PCM resume at the time) - fixed chip->pcm_devs initialization Signed-off-by: NJaroslav Kysela <perex@suse.cz>
-
由 Jaroslav Kysela 提交于
[ALSA] hda-patch-realtek - added pci subdevice ID for Acer TravelMate 8100 (3 stack model + digital out) HDA Codec driver Signed-off-by: NJaroslav Kysela <perex@suse.cz>
-
由 Takashi Iwai 提交于
VIA82xx driver Fixed the sample rates set in the fourth DXS channel with Non-VRA mode. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
PCM Midlevel Fixed the handling of boundary in PCM 32bit compat layer. Positions in hwsync are bound in the 32bit boundary size. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Jaroslav Kysela 提交于
OPL3SA2 driver - use different name (opl3sa2-pnpbios) for PnP BIOS driver - don't print warning when manual config of resources fails (PnP BIOS) Signed-off-by: NJaroslav Kysela <perex@suse.cz>
-
由 Clemens Ladisch 提交于
AC97 Codec Make the patch_wolfson_wm97??_specific() functions static again. This patch was accidentally reverted in rev. 1.92. Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
-
由 Clemens Ladisch 提交于
USB generic driver With the double buffering, we no longer need contiguous memory for the PCM buffer, so we can use vmalloc() instead of the preallocation functions, and increase the maximum size to 256 KB. Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
-
由 Clemens Ladisch 提交于
USB generic driver Use the USB buffer allocation functions to avoid repeated DMA mappings of our buffers, which are re-used quite a lot. Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
-
由 Clemens Ladisch 提交于
USB generic driver Take the substream lock when reading hwptr_done to avoid a race condition with the updates in the URB callbacks. Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
-
由 Clemens Ladisch 提交于
USB generic driver Change prepare_playback_urb() not to stop preparing packets before a frame boundary has been reached. Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
-
由 Clemens Ladisch 提交于
USB generic driver We always had to use double buffering when capturing, and when playback data for one URB crosses a buffer boundary. The latter would make hwptr updates less precise because the double-buffered data is read from the buffer much earlier than the other data is read by the host controller. Double-buffering all data allows to update hwptr immediately after the data was copied to the USB buffer(s), which has the additional benefit of avoiding the latency imposed by the host controller's delay of up to one frame when interrupting. Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
-
由 Clemens Ladisch 提交于
USB generic driver When preparing capture URBs, we don't need to stop when we cross a period boundary because we now never handle more than one millisecond of data per URB anyway. When handling captured data, use an extra flag to call snd_pcm_period_elapsed() no more than once. This allows us to move the period boundary checking code before the copying of the data which avoids a second locking of the substream's lock. Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
-
由 James Courtier-Dutton 提交于
EMU10K1/EMU10K2 driver Signed-off-by: NJames Courtier-Dutton <James@superbug.co.uk>
-
由 James Courtier-Dutton 提交于
CA0106 driver Signed-off-by: NJames Courtier-Dutton <James@superbug.co.uk>
-
由 Jaroslav Kysela 提交于
OPL3SA2 driver Signed-off-by: NJaroslav Kysela <perex@suse.cz>
-
由 Jaroslav Kysela 提交于
OPL3SA2 driver The driver has been extended to support also PnP BIOS devices. The detection path is: 1) detect PnP BIOS devices 2) detect ISA PnP devices Signed-off-by: NJaroslav Kysela <perex@suse.cz>
-
由 Takashi Iwai 提交于
VIA82xx driver Added the DXS entry for MSI K8MM-V. Also fixed a typo in last patch for Acer Aspire 1524 WLMi. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Philip Prindeville 提交于
AC97 Codec Added (minimal) support of VT1617A codec with SPDIF. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Takashi Iwai 提交于
HDA Intel driver Added SiS966 pci id to snd-hda-intel driver. Signed-off-by: NTakashi Iwai <tiwai@suse.de>
-
由 Clemens Ladisch 提交于
USB generic driver The EHCI driver doesn't interrupt more than once per millisecond, and organizes all iso transfers with frame-sized ITDs, so we can (try to) be more efficient by aligning all URBs on frame boundaries. Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
-
由 Clemens Ladisch 提交于
USB generic driver The nrpacks module parameter is used only when initializing a playback stream, so it doesn't hurt to make it writeable. Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
-
由 Clemens Ladisch 提交于
USB generic driver When determining how many packets are needed for one period, we cannot assume that all packets have their maximum size -- we always use the nominal sample rate when sending data, and could use an even lower rate when the endpoint uses frequency feedback. Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
-
由 Clemens Ladisch 提交于
USB generic driver When capturing audio data, we do not know beforehand how many samples the device sends per frame, so we have to use URBs that are as short as possible to make sure that we can handle period boundaries without any additional latencies. Furthermore, the total count of URBs submitted doesn't matter when capturing, so we can just use the maximum number. Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
-
由 Clemens Ladisch 提交于
Memalloc module,PCM Midlevel,Timer Midlevel,GUS Library,AC97 Codec ALI5451 driver,RME9652 driver Make some functions/variables that are used in only one file static. Signed-off-by: NClemens Ladisch <clemens@ladisch.de>
-