Now that est_tree_lock is acquired with BH protection, the other
call is unnecessary.
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Use rcu_dereference_rtnl() helper

Change hard coded constants in fib_flag_trans()
 7 -> RTN_UNREACHABLE
 8 -> RTN_PROHIBIT
Signed-off-by: NEric Dumazet <eric.dumazet@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

This requires some reorganisation of channel setup and teardown to
ensure that we can always roll-back a failed change.

Based on work by Steve Hodgson <shodgson@solarflare.com>
Signed-off-by: NBen Hutchings <bhutchings@solarflare.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

- Allow the ring size to be specified in non
   power-of-two sizes (for instance to limit
   the amount of receive buffers).
 - Automatically size the event queue.
Signed-off-by: NBen Hutchings <bhutchings@solarflare.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

This will allow for reallocation of channel structures and rings.

Change module parameter separate_tx_channels to be read-only, since we
now require its value to be constant.
Signed-off-by: NBen Hutchings <bhutchings@solarflare.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

In preparation for changes to the way channels and queue structures
are allocated, revise the macros and functions used to look up and
iterator over them.

- Replace efx_for_each_tx_queue() with iteration over channels then TX
  queues
- Replace efx_for_each_rx_queue() with iteration over channels then RX
  queues (with one exception, shortly to be removed)
- Introduce efx_get_{channel,rx_queue,tx_queue}() functions to look up
  channels and queues by index
- Introduce efx_channel_get_{rx,tx}_queue() functions to look up a
  channel's queues
Signed-off-by: NBen Hutchings <bhutchings@solarflare.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NBen Hutchings <bhutchings@solarflare.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Currently we allocate DMA descriptor rings and event rings using
pci_alloc_consistent() which selects non-blocking behaviour from the
page allocator (GFP_ATOMIC). This is unnecessary, and since we
currently allocate a single contiguous block for each ring (up to 32
pages!) these allocations are likely to fail if there is any
significant memory pressure.  Use dma_alloc_coherent() and GFP_KERNEL
instead.
Signed-off-by: NBen Hutchings <bhutchings@solarflare.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NBen Hutchings <bhutchings@solarflare.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NBen Hutchings <bhutchings@solarflare.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

rx_over_errors appears to be intended as a count of packets that
overflow a packet buffer in the NIC.  Given that we implement a
cut-through receive path, this should always be 0.

rx_dropped appears to be the correct counter for packets dropped due
to lack of host buffers.
Signed-off-by: NBen Hutchings <bhutchings@solarflare.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Calculating rx_bad as rx_packets - rx_good is unnecessary and
incorrect, since rx_good does not include control frames (e.g.
pause frames) and rx_packets does.
Signed-off-by: NBen Hutchings <bhutchings@solarflare.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Conflicts:
	net/mac80211/main.c

Replace sizeof(bnx2x_parity_mask)/(sizeof(bnx2x_parity_mask[0]) with
ARRAY_SIZE(bnx2x_parity_mask) in drivers/net/bnx2x/bnx2x_main.c
Signed-off-by: NNikitas Angelinas <nikitasangelinas@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The 'wwan' devtype is meant for devices that require preconfiguration
and *every* time setup before the ethernet interface can be used, like
cellular modems which require a series of setup commands on serial ports
or other mechanisms before the ethernet interface will handle packets.

As ipheth only requires one-per-hotplug pairing setup with no
preconfiguration (like APN, phone #, etc) and the network interface is
usable at any time after that initial setup, remove the incorrect
devtype wwan.
Signed-off-by: NDan Williams <dcbw@redhat.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NFlorian Fainelli <florian@openwrt.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Remove all the volatile keywords where they were used, switch to using the
proper readl/writel accessors.
Signed-off-by: NFlorian Fainelli <florian@openwrt.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Replace asm/io.h and asm/cpu.h wih linux/io.h and linux/cpu.h
Signed-off-by: NFlorian Fainelli <florian@openwrt.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Use pr_(info|err) and pr_cont where required instead of calls to printk.
Add missing pr_fmt to the driver.
Signed-off-by: NFlorian Fainelli <florian@openwrt.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

One line has not been changed because it would not improve readability.
Signed-off-by: NFlorian Fainelli <florian@openwrt.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

This patch fixes the following checkpatch.pl warnings:
- spaces after tabs
- space between function and arguments
- one-line statement braces
- tabs instead of spaces
Signed-off-by: NFlorian Fainelli <florian@openwrt.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NFlorian Fainelli <florian@openwrt.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Remove code that trimmed excess trailing info from incoming messages
arriving over an Ethernet interface.  TIPC now ignores the extra info
while the message is being processed by the node, and only trims it off
if the message is retransmitted to another node.  (This latter step is
done to ensure the extra info doesn't cause the sk_buff to exceed the
outgoing interface's MTU limit.) The outgoing buffer is guaranteed to
be linear.
Signed-off-by: NAllan Stephens <allan.stephens@windriver.com>
Signed-off-by: NPaul Gortmaker <paul.gortmaker@windriver.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Use the net_device provided net_device_stats structure.

Remove ixgbevf_get_stats() now its not needed.
Signed-off-by: NEric Dumazet <eric.dumazet@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

xfrm4_tunnel_register() & xfrm6_tunnel_register() should
use rcu_assign_pointer() to make sure previous writes
(to handler->next) are committed to memory before chain
insertion.

deregister functions dont need a particular barrier.
Signed-off-by: NEric Dumazet <eric.dumazet@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

__lock_sock() and __release_sock() releases and regrabs lock but
were missing proper annotations. Add it. This removes following
warning from sparse. (Currently __lock_sock() does not emit any
warning about it but I think it is better to add also.)

 net/core/sock.c:1580:17: warning: context imbalance in '__release_sock' - unexpected unlock
Signed-off-by: NNamhyung Kim <namhyung@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

move_addr_to_kernel() and copy_from_user() requires their argument
as __user pointer but were missing proper markups. Add it.
This removes following warnings from sparse.

 net/core/iovec.c:44:52: warning: incorrect type in argument 1 (different address spaces)
 net/core/iovec.c:44:52:    expected void [noderef] <asn:1>*uaddr
 net/core/iovec.c:44:52:    got void *msg_name
 net/core/iovec.c:55:34: warning: incorrect type in argument 2 (different address spaces)
 net/core/iovec.c:55:34:    expected void const [noderef] <asn:1>*from
 net/core/iovec.c:55:34:    got struct iovec *msg_iov
Signed-off-by: NNamhyung Kim <namhyung@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Add a list_has_sctp_addr function to simplify loop

Based on a patches by Dan Carpenter and David Miller
Signed-off-by: NJoe Perches <joe@perches.com>
Acked-by: NVlad Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Use netdev_alloc_skb_ip_align() helper and do correct allocation
Tested-by: NAbraham Arce <x0066660@ti.com>
Signed-off-by: NAbraham Arce <x0066660@ti.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

commit 30fff923 introduced in linux-2.6.33 (udp: bind() optimisation)
added a secondary hash on UDP, hashed on (local addr, local port).

Problem is that following sequence :

fd = socket(...)
connect(fd, &remote, ...)

not only selects remote end point (address and port), but also sets
local address, while UDP stack stored in secondary hash table the socket
while its local address was INADDR_ANY (or ipv6 equivalent)

Sequence is :
 - autobind() : choose a random local port, insert socket in hash tables
              [while local address is INADDR_ANY]
 - connect() : set remote address and port, change local address to IP
              given by a route lookup.

When an incoming UDP frame comes, if more than 10 sockets are found in
primary hash table, we switch to secondary table, and fail to find
socket because its local address changed.

One solution to this problem is to rehash datagram socket if needed.

We add a new rehash(struct socket *) method in "struct proto", and
implement this method for UDP v4 & v6, using a common helper.

This rehashing only takes care of secondary hash table, since primary
hash (based on local port only) is not changed.
Reported-by: NKrzysztof Piotr Oledzki <ole@ans.pl>
Signed-off-by: NEric Dumazet <eric.dumazet@gmail.com>
Tested-by: NKrzysztof Piotr Oledzki <ole@ans.pl>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Acked-by: NChris Snook <chris.snook@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Use cmpxchg() to get rid of spinlocks in inet_add_protocol() and
friends.

inet_protos[] & inet6_protos[] are moved to read_mostly section
Signed-off-by: NEric Dumazet <eric.dumazet@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Ignore ADSL routers, which can have the same vendor and product IDs
as ADSL modems but should be handled by the cx82310_eth driver.

This intentionally ignores device IDs that aren't currently handled
by cx82310_eth. There may be other device IDs that perhaps shouldn't
be claimed by cxacru.
Signed-off-by: NOndrej Zary <linux@rainbow-software.org>
Signed-off-by: NSimon Arlott <simon@fire.lp0.eu>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

flows are an obsolete date type.
Signed-off-by: NAndy Grover <andy.grover@oracle.com>

Replace e.g. u_int32_t types with the more common uint32_t.
Reported-by: NMatthew Wilcox <willy@linux.intel.com>
Signed-off-by: NAndy Grover <andy.grover@oracle.com>

Also, a number of changes were made based on the assumption that
rds.h wasn't exported, so roll these back.
Signed-off-by: NAndy Grover <andy.grover@oracle.com>