This is a quite large renaming to consolidate display related bindings
into a single "display" directory from various scattered locations of
video, drm, gpu, fb, mipi, and panel. The prior location was somewhat
based on the Linux driver location, but bindings should be independent
of that.
Signed-off-by: NRob Herring <robh@kernel.org>
Cc: Pawel Moll <pawel.moll@arm.com>
Cc: Mark Rutland <mark.rutland@arm.com>
Cc: Ian Campbell <ijc+devicetree@hellion.org.uk>
Cc: Kumar Gala <galak@codeaurora.org>

Add support for an external compontised DRM encoder. The external
encoder can be connected to tilcdc trough device tree graph binding.
The binding document for tilcdc has been updated. The current
implementation supports only tda998x encoder.

To be able to filter out the unsupported video modes the tilcdc driver
needs to hijack the external connectors helper functions. The tilcdc
installes new helper functions that are otherwise identical to
orignals, but the mode_valid() call-back check the mode first localy,
before calling the original call-back. The tilcdc dirver restores the
original helper functions before it is unbound from the external
device.

I got the idea and some lines of code from Jean-Francois Moine's
"drm/tilcdc: Change the interface with the tda998x driver"-patch.
Signed-off-by: NJyri Sarha <jsarha@ti.com>
Acked-by: NTomi Valkeinen <tomi.valkeinen@ti.com>

Adding support for max-pixelclock and max-width device tree
entries. As some devices that use the tilcdc hardware module
have restrictions on the allowed/tested values.  Also update DT
bindings document to reflect new parameters.
Signed-off-by: NDarren Etheridge <detheridge@ti.com>
Acked-by: NRob Clark <robdclark@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

A simple DRM/KMS driver for the TI LCD Controller found in various
smaller TI parts (AM33xx, OMAPL138, etc).  This driver uses the
CMA helpers.  Currently only the TFP410 DVI encoder is supported
(tested with beaglebone + DVI cape).  There are also various LCD
displays, for which support can be added (as I get hw to test on),
and an external i2c HDMI encoder found on some boards.

The display controller supports a single CRTC.  And the encoder+
connector are split out into sub-devices.  Depending on which LCD
or external encoder is actually present, the appropriate output
module(s) will be loaded.

v1: original
v2: fix fb refcnting and few other cleanups
v3: get +/- vsync/hsync from timings rather than panel-info, add
    option DT max-bandwidth field so driver doesn't attempt to
    pick a display mode with too high memory bandwidth, and other
    small cleanups
v4: remove some unneeded stuff from panel-info struct, properly
    set high bits for hfp/hsw/hbp for rev 2, add DT bindings docs
Signed-off-by: NRob Clark <robdclark@gmail.com>
Reviewed-by: NDaniel Vetter <daniel.vetter@ffwll.ch>
Tested-by: NKoen Kooi <koen@dominion.thruhere.net>