- 29 11月, 2012 2 次提交
-
-
由 Bill Pemberton 提交于
CONFIG_HOTPLUG is going away as an option so __devinitdata is no longer needed. Signed-off-by: NBill Pemberton <wfp5p@virginia.edu> Acked-by: NJean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com> Cc: Viresh Kumar <viresh.linux@gmail.com> Acked-by: NLinus Walleij <linus.walleij@linaro.org> Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>
-
由 Bill Pemberton 提交于
CONFIG_HOTPLUG is going away as an option so __devexit_p is no longer needed. Signed-off-by: NBill Pemberton <wfp5p@virginia.edu> Acked-by: NJean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com> Acked-by: NViresh Kumar <viresh.kumar@linaro.org> Acked-by: NLinus Walleij <linus.walleij@linaro.org> Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>
-
- 03 9月, 2012 1 次提交
-
-
由 Shawn Guo 提交于
Unlike imx6q pinctrl driver that starts nubmering pad from 0, imx5 pinctrl drivers number pad from 1. It causes problem/confusion when driver accesses imx51_pinctrl_pads array using pin ID as the index. Change imx51_pads and imx53_pads numbering start from 0. Signed-off-by: NShawn Guo <shawn.guo@linaro.org> Signed-off-by: NLinus Walleij <linus.walleij@linaro.org>
-
- 17 8月, 2012 1 次提交
-
-
由 Shawn Guo 提交于
The .conf_reg of MX51_PAD_SD2_CMD__CSPI_MOSI should be 0x7bc rather than NO_PAD. This error will cause SD2 probe failure. Signed-off-by: NShawn Guo <shawn.guo@linaro.org> Signed-off-by: NLinus Walleij <linus.walleij@linaro.org>
-
- 21 5月, 2012 1 次提交
-
-
由 Dong Aisheng 提交于
ChangeLog v1->v2: * change PIN_FUNC_ID base in binding doc to 0 from 1. Acked-by: NShawn Guo <shawn.guo@linaro.org> Acked-by: NStephen Warren <swarren@wwwdotorg.org> Signed-off-by: NDong Aisheng <dong.aisheng@linaro.org> Signed-off-by: NLinus Walleij <linus.walleij@linaro.org>
-