- 07 1月, 2009 32 次提交
-
-
由 Mike Frysinger 提交于
Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
- unify all dma in/out functions (takes ~35 lines of code now) - unify dma_memcpy with dma in/out functions (1 place that touches MDMA0 registers) - add support for 32bit transfers - cleanup dma_memcpy code to be much more readable - irqs are disabled only while programming MDMA registers rather than the entire transaction Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
Check pointers in safe_dma_memcpy as this is the entry point for user-space code Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Michael Hennerich 提交于
Add BF537-STAMP platform Support Signed-off-by: NMichael Hennerich <michael.hennerich@analog.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Robin Getz 提交于
Signed-off-by: NRobin Getz <rgetz@blackfin.uclinux.org> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
All slaves I'm aware of should support at least 100kHz Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Michael Hennerich 提交于
This device shouldn't be considered as an alternative to a Memory Mapped or built-in Ethernet MAC. Throughput is slow (~460kByte/s) while generating a very high system load (~60%). Signed-off-by: NMichael Hennerich <michael.hennerich@analog.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Yi Li 提交于
Turn to use the mmc_spi driver in mainline kernel. Signed-off-by: NYi Li <yi.li@analog.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Yi Li 提交于
Signed-off-by: NYi Li <yi.li@analog.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Michael Hennerich 提交于
Signed-off-by: NMichael Hennerich <michael.hennerich@analog.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Sonic Zhang 提交于
Signed-off-by: NSonic Zhang <sonic.zhang@analog.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Michael McTernan 提交于
Signed-off-by: NMichael McTernan <mmcternan@airvana.com> Signed-off-by: NSonic Zhang <sonic.zhang@analog.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Graf Yang 提交于
Signed-off-by: NGraf Yang <graf.yang@analog.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Graf Yang 提交于
1. Use inline get_l1_... functions instead of macro 2. Fix compile issue about smp barrier functions Signed-off-by: NGraf Yang <graf.yang@analog.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Graf Yang 提交于
Signed-off-by: NGraf Yang <graf.yang@analog.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Bernd Schmidt 提交于
Fix a few problems I discovered when building a kernel with upstream CVS binutils. We have to add the NOTES macro to our linker script, since a kernel built with --build-id is otherwise unable to boot. Last time NOTES was added, it broke things, but the definition of the macro has changed not to rely on parts of the linker script that aren't present on Blackfin. I also noticed that _l2_lma_start does not point into the kernel image, but rather somewhere in L1/L2 space, which seems unintended. Also, when the L2 section was added to the linker script, the part following it which computes then length of the init section was not updated. Signed-off-by: NBernd Schmidt <bernds_cb1@t-online.de> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Graf Yang 提交于
Add document about bfin-gpio when requesting a pin both as gpio and gpio interrupt. Signed-off-by: NGraf Yang <graf.yang@analog.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Bernd Schmidt 提交于
Remove all traces of the relocation stack. It's been removed from binutils for years now. Add a sanity overflow check to pcrel24 relocations to catch modules that were built without -mlong-calls. Signed-off-by: NBernd Schmidt <bernds_cb1@t-online.de> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
Tweak the BUG_ON() check to allow for equal values since the way pos is handled ... it is always indexed and post incremented Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Michael Hennerich 提交于
Signed-off-by: NMichael Hennerich <michael.hennerich@analog.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
use scm changelog rather than comment blocks in files Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Michael Hennerich 提交于
- remove duplicated code and headers - add option allowing arbitrary SDRAM/DDR Timing parameters. - mark automatically calculated timings as EXPERIMENTAL - fix comment header block Related to BUGs: - kernel boot up fails with CONFIG_BFIN_KERNEL_CLOCK item on. - kernel does not boot if re-program clocks [ Mike Frysinger <vapier.adi@gmail.com> - fix comment header - mark do_sync static - document the DMA shutdown - simplify SIC_IWR handling - fix ANOMALY_05000265 handling to work as intended ] Signed-off-by: NMichael Hennerich <michael.hennerich@analog.com> Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Graf Yang 提交于
[Mike Frysinger <vapier.adi@gmail.com>: - use KERN_NOTICE when using gpios as both irq and non rather than KERN_ERR - embedded newlines in printk() does not fly] Signed-off-by: NGraf Yang <graf.yang@analog.com> Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
- 18 11月, 2008 8 次提交
-
-
由 Michael Hennerich 提交于
CCLK is variable: get current CCLK in show_cpuinfo Signed-off-by: NMichael Hennerich <michael.hennerich@analog.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Graf Yang 提交于
Signed-off-by: NGraf Yang <graf.yang@analog.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Graf Yang 提交于
Signed-off-by: NGraf Yang <graf.yang@analog.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
add ANOMALY_05000435 to handle SIC_IWR1 workaround for rebooting Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
Only define HI/LO macros for assembly files since some common C files use HI/LO as variable names Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-
由 Mike Frysinger 提交于
Signed-off-by: NMike Frysinger <vapier.adi@gmail.com> Signed-off-by: NBryan Wu <cooloney@kernel.org>
-