Signed-off-by: NDavid Woodhouse <David.Woodhouse@intel.com>

[dwmw2: updated and made to still register whole device first]
Signed-off-by: NPhilip Rakity <pakity@yahoo.com>
Signed-off-by: NDavid Woodhouse <David.Woodhouse@intel.com>

Signed-off-by: NDavid Woodhouse <David.Woodhouse@intel.com>

Signed-off-by: NToralf Förster <toralf.foerster@gmx.de>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

... should be unsigned int
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Originally from Marcelo; modified to put the original timing registers
back instead of 0xFFFFFFFF.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

It was only the very early prototypes which made the mistake of using
the same device ident for all three functions on the device -- don't
bother trying to express that in the PCI match table, since the tools
don't cope. We can check in the probe routine instead, just in case.
Also remember to terminate the table.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Fix a couple drivers that do not correctly terminate their pci_device_id
lists.  This results in garbage being spewed into modules.pcimap when the
module happens to not have 28 NULL bytes following the table, and/or the
last PCI ID is actually truncated from the table when calculating the
modules.alias PCI aliases, cause those unfortunate device IDs to not
auto-load.
Signed-off-by: NKees Cook <kees@ubuntu.com>
Acked-by: NCorey Minyard <minyard@acm.org>
Cc: David Woodhouse <dwmw2@infradead.org>
Acked-by: NJeff Garzik <jeff@garzik.org>
Cc: Greg KH <greg@kroah.com>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

The CAFÉ can handle two chip on separate chipselect lines. Hook up the
undocumented chipselect bits in the driver and probe both.

In the case of OLPC, it's not actually two separate devices -- it's a
single '1GiB' package with two 512MiB dies internally. So clear the
NAND_BBT_PERCHIP flag to treat it as a single chip for BBT purposes, and
make life easier for the firmware.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NSegher Boessenkool <segher@kernel.crashing.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

We'll need them for suspend/resume.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

drivers/mtd/nand/cafe.c: In function 'cafe_nand_cmdfunc':
drivers/mtd/nand/cafe.c:269: warning: 'irqs' may be used uninitialized in this function
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

The obsolete SA_xxx interrupt flags have been used despite the scheduled
removal.  Fixup the remaining users in -mm.
Signed-off-by: NThomas Gleixner <tglx@linutronix.de>
Acked-by: NIngo Molnar <mingo@elte.hu>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

The precise timings are board-specific (or NAND chip specific) and don't
belong here. If they're set already, then use what we find there.
Otherwise, revert to the most conservative default values (and whinge).
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

The newly-added cafe_ecc.c had a lot of it because of the way the lookup
table was auto-generated; clean up the other files too while we're at it.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

We were resetting cafe->ctl2 to zero after an erase (and also during a
write, but it was correctly reset after that). This meant that ECC reads
after an erase were failing. Doh.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Also use cafe_readl() and cafe_writel() abstraction to make code
slightly cleaner -- especially if we want to use it in PIO mode.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

They fixed the hardware so that ECC doesn't fail on reading an empty
block.
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Fixes http://dev.laptop.org/ticket/237Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

- Fix OOB handling, bad block table marker placement
- Some cleanups, enable runtime-optional debugging
- Allow BBT stuff to be skipped
Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>

Signed-off-by: NDavid Woodhouse <dwmw2@infradead.org>