- 09 1月, 2009 23 次提交
-
-
由 Oliver Neukum 提交于
This converts the pegasus driver to use of the new net_device_ops structure Signed-off-by: NOliver Neukum <oneukum@suse.de> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Eilon Greenstein 提交于
Signed-off-by: NEilon Greenstein <eilong@broadcom.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Oliver Neukum 提交于
This converts the kaweth ethernet USB driver to netdevops. Signed-off-by: NOliver Neukum <oneukum@suse.de> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Stephen Hemminger 提交于
The link check watchdog timer on this driver fires every two seconds, but since not aligned it causes extra wakeups. It is more important on this driver than most because it is the hardware that is emulated by default when using network interfaces on VMware. Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Inaky Perez-Gonzalez 提交于
Current code was assuming PM was always enabled, which is not correct. Code which accesses members in the struct usb_device that are dependant on CONFIG_PM must be protected the same. Reported by Randy Dunlap from a build error in the linux-next tree on 07/01/2009. Signed-off-by: NInaky Perez-Gonzalez <inaky@linux.intel.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Inaky Perez-Gonzalez 提交于
Current WiMAX rfkill code is missing the case where rfkill is compiled in as modules and works only when rfkill is compiled in. This is not correct. Fixed to test for CONFIG_RFKILL or CONFIG_RKILL_MODULE. Signed-off-by: NInaky Perez-Gonzalez <inaky@linux.intel.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Inaky Perez-Gonzalez 提交于
WiMAX can work without RFKILL, but it was missing a check to make sure RFKILL is not being made a module with wimax compiled into the kernel. This caused failed builds in s390, where CONFIG_INPUT is always off. When RFKILL is enabled, the code uses the input layer to report hardware switch changes; thus, if RFKILL is enabled, INPUT has to be too. It also needs to display some message when INPUT is disabled that explains why WiMAX is not selectable. (issues found by Randy Dunlap in the linux-next tree). Signed-off-by: NInaky Perez-Gonzalez <inaky@linux.intel.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Inaky Perez-Gonzalez 提交于
Reported by Randy Dunlap: > Also, this warning needs to be fixed: > > linux-next-20090106/net/wimax/id-table.c:133: warning: ISO C90 > forbids mixed declarations and code Move the return on #defined(CONFIG_BUG) below the variable declarations so it doesn't violate ISO C90. On wimax_id_table_release() we want to do a debug check if CONFIG_BUG is enabled. However, we also want the debug code to be always compiled to ensure there is no bitrot. It will be optimized out by the compiler when CONFIG_BUG is disabled. Added a note to the function header stating this. Signed-off-by: NInaky Perez-Gonzalez <inaky@linux.intel.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 David S. Miller 提交于
-
由 Florian Fainelli 提交于
This patch bumps release number to 0.20 and 07Jan2009. Signed-off-by: NFlorian Fainelli <florian@openwrt.org> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Florian Fainelli 提交于
Some bootloader/BIOSes do not set the MAC address, warn about that. Signed-off-by: NFlorian Fainelli <florian@openwrt.org> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Florian Fainelli 提交于
This patch makes the driver properly initialize the PHY status if not correctly set by the bootloader/BIOS. It prevents some boards to bring up the link on boot. Signed-off-by: NFlorian Fainelli <florian@openwrt.org> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Florian Fainelli 提交于
This patch fixes some printks which were not prefixed with DRV_NAME, useful when having multiple cards/drivers on the system. Signed-off-by: NFlorian Fainelli <florian@openwrt.org> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Kumar Gala 提交于
Commit b31a1d8b ("gianfar: Convert gianfar to an of_platform_driver") went back to using BUS_ID_SIZE instead of sizeof() as per the larger patch series that will remove "char bus_id[20]" from struct device. Signed-off-by: NKumar Gala <galak@kernel.crashing.org> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Yevgeny Petrilin 提交于
Signed-off-by: NYevgeny Petrilin <yevgenyp@mellanox.co.il> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Yevgeny Petrilin 提交于
Was trying to unmap work queue entries that had inline packets, so naturally weren't mapped. Signed-off-by: NYevgeny Petrilin <yevgenyp@mellanox.co.il> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Sonic Zhang 提交于
Signed-off-by: NSonic Zhang <sonic.zhang@analog.com> Signed-off-by: NBryan Wu <cooloney@kernel.org> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Frank Blaschka 提交于
qeth_l2, qeth_l3 convert to net_device_ops. qeth_l3 remove vlan neigh_setup hack since it does not work any longer with the new net_device_ops. Signed-off-by: NFrank Blaschka <frank.blaschka@de.ibm.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Frank Blaschka 提交于
In case the real device has a neigh_setup function, this neigh_setup function should be used for the vlan device. Signed-off-by: NFrank Blaschka <frank.blaschka@de.ibm.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Wu Fengguang 提交于
Add warnings on invalid mac address to help disclose/debug problems. Signed-off-by: NWu Fengguang <fengguang.wu@intel.com> Acked-by: NPeter Korsgaard <jacmet@sunsite.dk> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Wu Fengguang 提交于
Otherwise unicast RX will only work in promisc mode. Signed-off-by: NPeter Korsgaard <jacmet@sunsite.dk> Signed-off-by: NWu Fengguang <fengguang.wu@intel.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Herbert Xu 提交于
This patch adds GRO support for TCP over IPv6. The code is exactly the same as the IPv4 version except for the pseudo-header checksum computation. Note that I've removed the unused tcphdr argument from tcp_v6_check rather than invent a bogus value for GRO. Signed-off-by: NHerbert Xu <herbert@gondor.apana.org.au> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Herbert Xu 提交于
This patch adds GRO support for IPv6. IPv6 GRO supports extension headers in the same way as GSO (by using the same infrastructure). It's also simpler compared to IPv4 since we no longer have to worry about fragmentation attributes or header checksums. Signed-off-by: NHerbert Xu <herbert@gondor.apana.org.au> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 08 1月, 2009 17 次提交
-
-
由 Stephen Hemminger 提交于
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Stephen Hemminger 提交于
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Stephen Hemminger 提交于
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Stephen Hemminger 提交于
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Stephen Hemminger 提交于
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Stephen Hemminger 提交于
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Acked-by: NDavid Vrabel <david.vrabel@csr.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Stephen Hemminger 提交于
Convert to net_device_ops Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Stephen Hemminger 提交于
Convert to net_device_ops and internal net_device_stats Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Stephen Hemminger 提交于
Convert to net_device_ops and internal net_device_stats Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Stephen Hemminger 提交于
Add net_device_ops and use interal stats Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Acked-by: NKarsten Keil <kkeil@suse.de> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Stephen Hemminger 提交于
Several API problems fixed: * use proper allocation * handle renames * convert to net_device_ops * use internal net_device_stats This driver is putrid (as in old and rotten), so I doubt any one uses it. Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Stephen Hemminger 提交于
Use internal network_device_stats that exist in network device and net_device_ops. Compile tested only. Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Stephen Hemminger 提交于
Convert to net_device_ops and internal net_device_stats Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Stephen Hemminger 提交于
Convert to net_device_ops and internal net_device_stats Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Stephen Hemminger 提交于
Convert to internal net_device-stats and net_device_ops Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Stephen Hemminger 提交于
Convert to net_device_ops and internal net_device_stats Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Stephen Hemminger 提交于
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-