This patch adds driver for Samsung S5K4ECGX image sensor with an
embedded SoC ISP. The driver only implements preview operation mode
and still capture (snapshot) and face detection features are missing
now. Following controls are supported: contrast, saturation,
brightness, sharpness.
Signed-off-by: NSangwook Lee <sangwook.lee@linaro.org>
Reviewed-by: NSylwester Nawrocki <s.nawrocki@samsung.com>
Signed-off-by: NSylwester Nawrocki <s.nawrocki@samsung.com>
Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>

Initial version of this driver.

The full datasheets are available from the Analog Devices website:

  http://ez.analog.com/docs/DOC-1741

Not all features of the receiver are supported by this driver for various
reasons. Most notably:

- No CEC support (the CEC API needs a lot more discussion)
- No HDCP repeater support (we don't use that either)

I'm sure that there are more things missing, but this driver does work
well for our hardware.

Note that I am using the register addresses instead of register names: the
datasheet containing the register descriptions is organized by register
address. Using names would make the datasheet lookup very hard. An attempt
was made to try and document what is being done when registers are used
instead.
Signed-off-by: NHans Verkuil <hans.verkuil@cisco.com>
Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>

Initial version of this driver.

The full datasheets are available from the Analog Devices website:

  http://ez.analog.com/docs/DOC-1545

Not all features of the receiver are supported by this driver for various
reasons. Most notably:

- No CEC support (the CEC API needs a lot more discussion)
- Only port A of the four HDMI input ports is implemented (our hardware only
  uses that port)
- No HDCP repeater support (we don't use that either)

And since there are some 600-odd pages of datasheet for this single device,
I'm sure that there are many more things missing, but this driver does work
well for our hardware.

Note that I am using the register addresses instead of register names: the
datasheet containing the register descriptions is organized by register
address. Using names would make the datasheet lookup very hard. An attempt
was made to try and document what is being done when registers are used
instead.
Signed-off-by: NHans Verkuil <hans.verkuil@cisco.com>
Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>

Move all soc_camera i2c drivers into drivers/media/i2c/soc_camera/.
Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>

Move ancillary I2C drivers into drivers/media/i2c, in order to
better organize them.
Signed-off-by: NMauro Carvalho Chehab <mchehab@redhat.com>