Skip to content

cloud-kernel
cloud-kernel

openanolis / cloud-kernel
1 年多 前同步成功

通知 160
Star 36
Fork 7
cloud-kernel
cloud-kernel
切换分支/标签
  1. 13 9月, 2016 5 次提交
  3. 08 7月, 2016 1 次提交
  5. 12 5月, 2016 3 次提交
  7. 03 5月, 2016 1 次提交
  9. 08 3月, 2016 3 次提交
  11. 01 2月, 2016 5 次提交
  13. 07 5月, 2015 5 次提交
  15. 19 2月, 2015 2 次提交
  17. 01 11月, 2014 1 次提交
  19. 22 10月, 2014 4 次提交
  21. 27 8月, 2014 1 次提交
    • C
      x86: Replace __get_cpu_var uses · 89cbc767
      由 Christoph Lameter 提交于 
      __get_cpu_var() is used for multiple purposes in the kernel source. One of
them is address calculation via the form &__get_cpu_var(x).  This calculates
the address for the instance of the percpu variable of the current processor
based on an offset.

Other use cases are for storing and retrieving data from the current
processors percpu area.  __get_cpu_var() can be used as an lvalue when
writing data or on the right side of an assignment.

__get_cpu_var() is defined as :

#define __get_cpu_var(var) (*this_cpu_ptr(&(var)))

__get_cpu_var() always only does an address determination. However, store
and retrieve operations could use a segment prefix (or global register on
other platforms) to avoid the address calculation.

this_cpu_write() and this_cpu_read() can directly take an offset into a
percpu area and use optimized assembly code to read and write per cpu
variables.

This patch converts __get_cpu_var into either an explicit address
calculation using this_cpu_ptr() or into a use of this_cpu operations that
use the offset.  Thereby address calculations are avoided and less registers
are used when code is generated.

Transformations done to __get_cpu_var()

1. Determine the address of the percpu instance of the current processor.

	DEFINE_PER_CPU(int, y);
	int *x = &__get_cpu_var(y);

    Converts to

	int *x = this_cpu_ptr(&y);

2. Same as #1 but this time an array structure is involved.

	DEFINE_PER_CPU(int, y[20]);
	int *x = __get_cpu_var(y);

    Converts to

	int *x = this_cpu_ptr(y);

3. Retrieve the content of the current processors instance of a per cpu
variable.

	DEFINE_PER_CPU(int, y);
	int x = __get_cpu_var(y)

   Converts to

	int x = __this_cpu_read(y);

4. Retrieve the content of a percpu struct

	DEFINE_PER_CPU(struct mystruct, y);
	struct mystruct x = __get_cpu_var(y);

   Converts to

	memcpy(&x, this_cpu_ptr(&y), sizeof(x));

5. Assignment to a per cpu variable

	DEFINE_PER_CPU(int, y)
	__get_cpu_var(y) = x;

   Converts to

	__this_cpu_write(y, x);

6. Increment/Decrement etc of a per cpu variable

	DEFINE_PER_CPU(int, y);
	__get_cpu_var(y)++

   Converts to

	__this_cpu_inc(y)

Cc: Thomas Gleixner <tglx@linutronix.de>
Cc: x86@kernel.org
Acked-by: NH. Peter Anvin <hpa@linux.intel.com>
Acked-by: NIngo Molnar <mingo@kernel.org>
Signed-off-by: NChristoph Lameter <cl@linux.com>
Signed-off-by: NTejun Heo <tj@kernel.org>
      89cbc767
  23. 09 8月, 2014 1 次提交
  25. 15 7月, 2013 1 次提交
    • P
      x86: delete __cpuinit usage from all x86 files · 148f9bb8
      由 Paul Gortmaker 提交于 
      The __cpuinit type of throwaway sections might have made sense
some time ago when RAM was more constrained, but now the savings
do not offset the cost and complications.  For example, the fix in
commit 5e427ec2 ("x86: Fix bit corruption at CPU resume time")
is a good example of the nasty type of bugs that can be created
with improper use of the various __init prefixes.

After a discussion on LKML[1] it was decided that cpuinit should go
the way of devinit and be phased out.  Once all the users are gone,
we can then finally remove the macros themselves from linux/init.h.

Note that some harmless section mismatch warnings may result, since
notify_cpu_starting() and cpu_up() are arch independent (kernel/cpu.c)
are flagged as __cpuinit  -- so if we remove the __cpuinit from
arch specific callers, we will also get section mismatch warnings.
As an intermediate step, we intend to turn the linux/init.h cpuinit
content into no-ops as early as possible, since that will get rid
of these warnings.  In any case, they are temporary and harmless.

This removes all the arch/x86 uses of the __cpuinit macros from
all C files.  x86 only had the one __CPUINIT used in assembly files,
and it wasn't paired off with a .previous or a __FINIT, so we can
delete it directly w/o any corresponding additional change there.

[1] https://lkml.org/lkml/2013/5/20/589

Cc: Thomas Gleixner <tglx@linutronix.de>
Cc: Ingo Molnar <mingo@redhat.com>
Cc: "H. Peter Anvin" <hpa@zytor.com>
Cc: x86@kernel.org
Acked-by: NIngo Molnar <mingo@kernel.org>
Acked-by: NThomas Gleixner <tglx@linutronix.de>
Acked-by: NH. Peter Anvin <hpa@linux.intel.com>
Signed-off-by: NPaul Gortmaker <paul.gortmaker@windriver.com>
      148f9bb8
  27. 22 3月, 2013 2 次提交
  29. 30 10月, 2012 1 次提交
  31. 18 10月, 2012 1 次提交
  33. 20 7月, 2012 1 次提交
  35. 07 6月, 2012 2 次提交
    • B
      x86, MCE, AMD: Update copyrights and boilerplate · 11122570
      由 Borislav Petkov 提交于 
      Jacob is doing something else now so add myself as the loser who
provides support.
Signed-off-by: NBorislav Petkov <borislav.petkov@amd.com>
      11122570
    • B
      x86, MCE, AMD: Give proper names to the thresholding banks · 336d335a
      由 Borislav Petkov 提交于 
      Having the banks numbered is ok but having real names which mean
something to the user makes a lot more sense:

 /sys/devices/system/machinecheck/machinecheck0/
 |-- bank0
 |-- bank1
 |-- bank2
 |-- bank3
 |-- bank4
 |-- bank5
 |-- bank6
 |-- check_interval
 |-- cmci_disabled
 |-- combined_unit
 |   |-- combined_unit
 |       |-- error_count
 |       |-- threshold_limit
 |-- dont_log_ce
 |-- execution_unit
 |   |-- execution_unit
 |       |-- error_count
 |       |-- threshold_limit
 |-- ignore_ce
 |-- insn_fetch
 |   |-- insn_fetch
 |       |-- error_count
 |       |-- threshold_limit
 |-- load_store
 |   |-- load_store
 |       |-- error_count
 |       |-- threshold_limit
 |-- monarch_timeout
 |-- northbridge
 |   |-- dram
 |   |   |-- error_count
 |   |   |-- interrupt_enable
 |   |   |-- threshold_limit
 |   |-- ht_links
 |   |   |-- error_count
 |   |   |-- interrupt_enable
 |   |   |-- threshold_limit
 |   |-- l3_cache
 |       |-- error_count
 |       |-- interrupt_enable
 |       |-- threshold_limit
...
Signed-off-by: NBorislav Petkov <borislav.petkov@amd.com>
      336d335a