提交 · 8777c5c11764d8336d8270f96778158c34c92108 · openanolis / cloud-kernel

11 6月, 2014 40 次提交
- B
  drm/nouveau/dp: probe dpcd to determine connectedness · 8777c5c1
  由 Ben Skeggs 提交于 6月 06, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  8777c5c1
- B
  drm/nv50-: trigger update after all connectors disabled · efa366fd
  由 Ben Skeggs 提交于 6月 05, 2014
```
We were sending the necessary state changes to unset the mode, but
never actually hit the big GO button unless another modeset happens
afterwards.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  efa366fd
- B
  drm/nv50-: prepare for attaching a SOR to multiple heads · e84a35a8
  由 Ben Skeggs 提交于 6月 05, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  e84a35a8
- B
  drm/gf119-/disp: fix debug output on update failure · e32d68c9
  由 Ben Skeggs 提交于 6月 04, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  e32d68c9
- B
  drm/nouveau/disp/dp: make use of postcursor when its available · c33ba689
  由 Ben Skeggs 提交于 6月 03, 2014
```
And at the same time, obey the spec better wrt out-of-range requests.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  c33ba689
- B
  drm/g94-/disp/dp: take max pullup value across all lanes · 3e1eb5cf
  由 Ben Skeggs 提交于 6月 03, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  3e1eb5cf
- B
  drm/nouveau/bios/dp: parse lane postcursor data · 7a14bc78
  由 Ben Skeggs 提交于 6月 03, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  7a14bc78
- B
  drm/nouveau/dp: fix support for dpms · 4874322e
  由 Ben Skeggs 提交于 5月 31, 2014
```
SOR_PWR has no effect to power-off DP links, unlike other SOR protocols.

Instead, on the source side, we cut power to the lanes after having put
the sink into D3.  Link training takes care of everything required to
bring it back again.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  4874322e
- B
  drm/nouveau: register a drm_dp_aux channel for each dp connector · 8894f491
  由 Ben Skeggs 提交于 5月 30, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  8894f491
- B
  drm/g94-/disp: add method to power-off dp lanes · ebd6acbb
  由 Ben Skeggs 提交于 5月 26, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  ebd6acbb
- B
  drm/nouveau/disp/dp: maintain link in response to hpd signal · 55f083c3
  由 Ben Skeggs 提交于 5月 20, 2014
```
This previously worked for the most part due to userspace doing a
modeset in response to HPD interrupts.  This will allow us to
properly handle cases where sync is lost for other reasons, or if
userspace isn't caring.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  55f083c3
- B
  drm/g94-/disp: bash and wait for something after changing lane power regs · 13a61757
  由 Ben Skeggs 提交于 5月 26, 2014
```
Some kind of update?  Needed to make the power-down take effect at least.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  13a61757
- B
  drm/nouveau/disp/dp: split link config/power into two steps · 1ecee1cd
  由 Ben Skeggs 提交于 5月 26, 2014
```
We want to be able to power down the lanes for DPMS off.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  1ecee1cd
- B
  drm/nv50/disp: train PIOR-attached DP from second supervisor · b17932c0
  由 Ben Skeggs 提交于 5月 27, 2014
```
Same place as for SOR, between detach and attach phases.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  b17932c0
- B
  drm/nouveau/disp/dp: make use of existing output data for link training · 3b52a1f9
  由 Ben Skeggs 提交于 5月 19, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  3b52a1f9
- B
  drm/gf119/disp: start removing direct vbios parsing from supervisor · 2bd651ea
  由 Ben Skeggs 提交于 5月 21, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  2bd651ea
- B
  drm/nv50/disp: start removing direct vbios parsing from supervisor · 415f12ef
  由 Ben Skeggs 提交于 5月 21, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  415f12ef
- B
  drm/nouveau/disp/dp: maintain receiver caps in response to hpd signal · bb7ef1ec
  由 Ben Skeggs 提交于 5月 19, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  bb7ef1ec
- B
  drm/nouveau/disp/dp: create subclass for dp outputs · b8407c9e
  由 Ben Skeggs 提交于 5月 17, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  b8407c9e
- B
  drm/nouveau: use connector events for HPD instead of GPIO watching · 456b0579
  由 Ben Skeggs 提交于 5月 30, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  456b0579
- B
  drm/nouveau/disp: add internal representaion of output paths and connectors · 7a014a87
  由 Ben Skeggs 提交于 5月 16, 2014
```
This will, at some point, be used to replace various bits and pieces of
code doing direct bios parsing.  For now, it'll just be used for some
DP improvements.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  7a014a87
- B
  drm/nouveau/bios: extend connector table parsing · 20014cbe
  由 Ben Skeggs 提交于 5月 14, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  20014cbe
- B
  drm/nouveau/disp: nothing to see here · 377b1f16
  由 Ben Skeggs 提交于 5月 14, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  377b1f16
- B
  drm/nouveau/i2c/anx9805: add debugging to aux transactions · 37da5b87
  由 Ben Skeggs 提交于 6月 11, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  37da5b87
- B
  drm/nouveau/i2c: introduce locking at a per-port level · 9efc583e
  由 Ben Skeggs 提交于 5月 29, 2014
```
There's also provisions to allow a pad to be locked with a specific
routing, for an indefinite period of time.  This will be used in
future patches.

The G94+ pad driver will now also power-down pads when not required.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  9efc583e
- B
  drm/nouveau/i2c: balance port acquire/release · d2ae2eb4
  由 Ben Skeggs 提交于 5月 29, 2014
```
This was a half-finished hack before, just enough to handle the shared
aux/i2c pad thing on G94 and up.

We got lucky with locking etc up until now, as this was (generally) all
protected by the DRM mode_config lock.  It's about to become a lot more
likely to hit the races.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  d2ae2eb4
- B
  drm/gk104/i2c: add aux channel interrupt driver · 0ff32977
  由 Ben Skeggs 提交于 5月 13, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  0ff32977
- B
  drm/g94/i2c: add aux channel interrupt driver · d78fa39a
  由 Ben Skeggs 提交于 5月 13, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  d78fa39a
- B
  drm/nouveau/i2c: add interfaces to support handling aux channel interrupts · 3668a339
  由 Ben Skeggs 提交于 5月 13, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  3668a339
- B
  drm/nouveau/i2c: start hiding subdev-internal interfaces · c26fe843
  由 Ben Skeggs 提交于 5月 13, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  c26fe843
- B
  drm/nouveau/i2c: remove unnecessary i2c_set_adapdata() · 0bac9879
  由 Ben Skeggs 提交于 5月 07, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  0bac9879
- B
  drm/nouveau/i2c: properly hand aux reply back to caller, and only retry on defer · 842c2953
  由 Ben Skeggs 提交于 5月 07, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  842c2953
- B
  drm/nv50-/mc: also pass PMGR interrupts onto I2C subdev · febb8449
  由 Ben Skeggs 提交于 5月 13, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  febb8449
- B
  drm/nouveau/gpio: send separate event types for high/low transitions · 20a80074
  由 Ben Skeggs 提交于 5月 13, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  20a80074
- B
  drm/nouveau/gpio: use base constructor for all implementations · bc3b0c41
  由 Ben Skeggs 提交于 5月 13, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  bc3b0c41
- B
  drm/nouveau/gpio: move on-reset intr disable-and-ack to common code · f4277a0e
  由 Ben Skeggs 提交于 5月 13, 2014
```
Re-uses the implementation's accessor functions rather than requiring
and init/fini implementation for each chipset.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  f4277a0e
- B
  drm/nouveau/gpio: split "toggled" interrupt into "went high" / "went low" · 5693c0f2
  由 Ben Skeggs 提交于 5月 12, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  5693c0f2
- B
  drm/nouveau/gpio: split g92 class from nv50 · 7356859a
  由 Ben Skeggs 提交于 5月 12, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  7356859a
- B
  drm/nouveau/gpio: use indirect pointer to base class definition · d93174ec
  由 Ben Skeggs 提交于 5月 12, 2014
```
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  d93174ec
- B
  drm/nouveau/disp/dp: support training to highest rate, rather than a target · 1f86ca1a
  由 Ben Skeggs 提交于 5月 16, 2014
```
We really want this for, at least, MST devices.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>
```
  1f86ca1a

openanolis / cloud-kernel 大约 1 年 前同步成功

openanolis / cloud-kernel
大约 1 年前同步成功