Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

NVC0 will be able to share some of nv50's paths this way.  This also makes
it the card-specific vram code responsible for deciding if a given set
of tile_flags is valid, rather than duplicating the allowed types in
nv50_vram.c and nouveau_gem.c
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Reviewed-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

These have been unused since UMS support was ripped out, so lets remove
them completely.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Fix running of destroy_context() when create_context() has never been
called for the channel, and fill in engine's tlb_flush() function pointer.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Reviewed-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Allows callers to install their own handlers for when a GPIO line
changes state (such as for hotplug detect).

This also fixes a bug where we weren't acknowledging the GPIO IRQ
until after the bottom half had run, causing a severe IRQ storm
in some cases.
Reviewed-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Reviewed-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Reviewed-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

The point is to share more code between the PFB/PGRAPH tile region
hooks, and give the hardware specific functions a chance to allocate
per-region resources.
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

nv0x-nv4x should be mostly fine, nv50 doesn't work yet.
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Only supported on NV50+ so far, and disabled by default currently.  The
module parameter "msi=1" will enable it.

There's a kernel bug which will cause this to fail if the module (or the
NVIDIA binary driver) has ever been loaded before loading nouveau with
MSI enabled.  As such, this is only safe to enable if you have nouveau
load on boot, and don't wish to ever reload it.

The workaround is to "echo 0 > /sys/bus/pci/devices/<device>/enable"
until the enable count reads 0.  Then you should be able to load nouveau
with MSI enabled.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

We previously added all the available classes for the entire generation,
even though the objects wouldn't work on the hardware.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

The destroy_context() engine hooks call gpuobj management functions to
release the channel resources, these functions use HARDIRQ-unsafe locks
whereas destroy_context() is called with the HARDIRQ-safe
context_switch_lock held, that's a lock ordering violation.

Push the engine-specific channel destruction logic into destroy_context()
and let the hardware-specific code lock and unlock when it's actually
needed. Change the engine destruction order to avoid a race in the small
gap between pgraph and pfifo context uninitialization.
Reported-by: NMarcin Slusarz <marcin.slusarz@gmail.com>
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

This will be needed for Z compression and to take smarter placement
decisions.
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Acked-by: NBen Skeggs <bskeggs@redhat.com>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Acked-by: NBen Skeggs <bskeggs@redhat.com>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

This will end up quite different, it makes sense for it to be completely
separate.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Currently just hooked up to the already-existing nouveau_hw, which should
handle all relevant chipsets as well as we currently can.

This will likely be eventually split out and improved into chipset specific
code at a later point.
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

This will make nouveau_pm attempt to report the card's current performance
level both during bootup, and through sysfs.

This is a very initial implementation, and can be improved a *lot*
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Instead of emptying the caches to avoid a race with the PFIFO puller,
go straight ahead and try to recover from it when it happens. Also,
kill pfifo->cache_flush and tile->lock, we don't need them anymore.
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Reviewed-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Reviewed-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

nouveau_load() just returned directly if there was an error instead of
releasing resources.
Signed-off-by: NDan Carpenter <error27@gmail.com>
Reviewed-by: NMarcin Slusarz <marcin.slusarz@gmail.com>
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>

Fixes the randomly flashing vertical lines seen on some nv3x after a
cold-boot.
Signed-off-by: NFrancisco Jerez <currojerez@riseup.net>
Signed-off-by: NBen Skeggs <bskeggs@redhat.com>