- 12 8月, 2013 1 次提交
-
-
由 Mark Brown 提交于
This makes it possible to hook the device into a more complex board and ensures it will continue to work with non-DAPM support removed from the core. Signed-off-by: NMark Brown <broonie@linaro.org> Acked-by: NAlexander Sverdlin <subaparts@yandex.ru>
-
- 11 8月, 2013 1 次提交
-
-
由 Mark Brown 提交于
Signed-off-by: NMark Brown <broonie@linaro.org> Acked-by: NAlexander Sverdlin <subaparts@yandex.ru>
-
- 22 3月, 2013 1 次提交
-
-
由 Daniel Mack 提交于
Use the newly introduced mute_stream DAI operation, and don't mute the codec if it's called for the _CAPTURE stream. Signed-off-by: NDaniel Mack <zonque@gmail.com> Acked-by: NAlexander Sverdlin <subaparts@yandex.ru> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 15 3月, 2013 1 次提交
-
-
由 Daniel Mack 提交于
By using the regmap API directly, we can make use of the .write_flag_mask for SPI, which allows us to drop the strange register hacks that were necessary so far. Signed-off-by: NDaniel Mack <zonque@gmail.com> Acked-by: NAlexander Sverdlin <alexander.sverdlin@gmx.de> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 24 12月, 2012 1 次提交
-
-
由 Daniel Mack 提交于
The CS4271 requires its LRCLK and MCLK to be stable before its RESET line is de-asserted. That also means that clocks cannot be changed without putting the chip back into hardware reset, which also requires a complete re-initialization of all registers. One (undocumented) workaround is to assert and de-assert the PDN bit in the MODE2 register. This patch adds a new flag to both the DT bindings as well as to the platform data to enable that workaround. Signed-off-by: NDaniel Mack <zonque@gmail.com> Acked-by: NAlexander Sverdlin <subaparts@yandex.ru> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 09 12月, 2012 1 次提交
-
-
由 Bill Pemberton 提交于
CONFIG_HOTPLUG is going away as an option. As result the __dev* markings will be going away. Remove use of __devinit, __devexit_p, __devinitdata, __devinitconst, and __devexit. Signed-off-by: NBill Pemberton <wfp5p@virginia.edu> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 02 12月, 2012 2 次提交
-
-
由 Daniel Mack 提交于
The driver had the property check for 'cirrus,amutec_eq_bmutec' the wrong way around. That happens if you misspell the property in the bindings during tests. Signed-off-by: NDaniel Mack <zonque@gmail.com> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
由 Daniel Mack 提交于
Make the flag in the pdata of type bool to fix a sparse warning. Signed-off-by: NDaniel Mack <zonque@gmail.com> Reported-by: NFengguang Wu <fengguang.wu@intel.com> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 13 11月, 2012 1 次提交
-
-
由 Daniel Mack 提交于
In case of probe deferral, the allocated GPIO line is not freed, which prevents it from being claimed and properly asserted in later attempts. Fix this by using devm_gpio_request(). Signed-off-by: NDaniel Mack <zonque@gmail.com> Reported-by: NMichael Hirsch <hirsch@teufel.de> Cc: Alexander Sverdlin <subaparts@yandex.ru> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 15 10月, 2012 1 次提交
-
-
由 Daniel Mack 提交于
The CS4271 has a feature to sync its analog mute flags, so one mute circuitry can be used for both channels. Give users access to this feature with a new DT property and a flag in the platform data. Signed-off-by: NDaniel Mack <zonque@gmail.com> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 28 9月, 2012 1 次提交
-
-
由 Daniel Mack 提交于
Apart from pure matching, the bindings also support setting the the reset gpio line. Signed-off-by: NDaniel Mack <zonque@gmail.com> Cc: Alexander Sverdlin <subaparts@yandex.ru> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 04 4月, 2012 1 次提交
-
-
由 Mark Brown 提交于
In order to support CODEC<->CODEC links remove the assumption that there is only a single CODEC on a DAI link by removing the use of the CODEC pointer in the rtd from the CODEC drivers. They are already being passed their DAI whenever they are passed an rtd and can get the CODEC from there. Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 04 2月, 2012 1 次提交
-
-
由 Liam Girdwood 提交于
Currently ASoC can only add kcontrols using codec and platform component device handles. It's also desirable to add kcontrols for DAIs (i.e. McBSP) and for SoC card machine drivers too. This allows the kcontrol to have a direct handle to the parent ASoC component DAI/SoC Card/Platform/Codec device and hence easily get it's private data. This change makes snd_soc_add_controls() static and wraps it in the folowing calls (card and dai are new) :- snd_soc_add_card_controls() snd_soc_add_codec_controls() snd_soc_add_dai_controls() snd_soc_add_platform_controls() This patch also does a lot of small mechanical changes in individual codec drivers to replace snd_soc_add_controls() with snd_soc_add_codec_controls(). It also updates the McBSP DAI driver to use snd_soc_add_dai_controls(). Finally, it updates the existing machine drivers that register controls to either :- 1) Use snd_soc_add_card_controls() where no direct codec control is required. 2) Use snd_soc_add_codec_controls() where there is direct codec control. In the case of 1) above we also update the machine drivers to get the correct component data pointers from the kcontrol (rather than getting the machine pointer via the codec pointer). Signed-off-by: NLiam Girdwood <lrg@ti.com> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 02 12月, 2011 1 次提交
-
-
由 Lars-Peter Clausen 提交于
The existence of this parameter is purely historical. None of the CODEC drivers uses it and we always pass in the same value anyway, so it should be safe to remove it. Signed-off-by: NLars-Peter Clausen <lars@metafoo.de> Acked-by: NLiam Girdwood <lrg@ti.com> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 23 11月, 2011 1 次提交
-
-
由 Lars-Peter Clausen 提交于
Commit 1ee46ebd("ASoC: Make the DAI ops constant in the DAI structure") introduced the possibility to have constant DAI ops structures, yet this is barley used in both existing drivers and also new drivers being submitted, although none of them modifies its DAI ops structure. The later is not surprising since existing drivers are often used as templates for new drivers. So this patch just constifies all existing snd_soc_dai_ops structs to eliminate the issue altogether. The patch was generated with the following coccinelle semantic patch: // <smpl> @@ identifier ops; @@ -struct snd_soc_dai_ops ops = +const struct snd_soc_dai_ops ops = { ... }; // </smpl> Signed-off-by: NLars-Peter Clausen <lars@metafoo.de> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 21 11月, 2011 1 次提交
-
-
由 Axel Lin 提交于
Signed-off-by: NAxel Lin <axel.lin@gmail.com> Acked-by: NAlexander Sverdlin <subaparts@yandex.ru> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 30 9月, 2011 1 次提交
-
-
由 Axel Lin 提交于
The control_data field is used to initialize the codec's control_data field, but since this is also done by the snd-soc-cache core, the redundant assignment can be removed and the field can be dropped. Signed-off-by: NAxel Lin <axel.lin@gmail.com> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 09 3月, 2011 1 次提交
-
-
由 Alexander Sverdlin 提交于
Manage mode and rate bits correctly, according to datasheet in CS4271 CODEC. This is done to make capture work properly. Signed-off-by: NAlexander Sverdlin <subaparts@yandex.ru> Acked-by: NLiam Girdwood <lrg@ti.com> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 08 3月, 2011 1 次提交
-
-
由 Alexander Sverdlin 提交于
Extend range of supported sample rates for CS4271 CODEC. Signed-off-by: NAlexander Sverdlin <subaparts@yandex.ru> Acked-by: NLiam Girdwood <lrg@ti.com> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 07 3月, 2011 1 次提交
-
-
由 Axel Lin 提交于
Signed-off-by: NAxel Lin <axel.lin@gmail.com> Acked-by: NAlexander Sverdlin <subaparts@yandex.ru> Acked-by: NTimur Tabi <timur@freescale.com> Acked-by: NLiam Girdwood <lrg@ti.com> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 08 2月, 2011 1 次提交
-
-
由 Alexander Sverdlin 提交于
Move Chip Select control out of the CODEC code for CS4271. Signed-off-by: NAlexander Sverdlin <subaparts@yandex.ru> Reviewed-by: NH Hartley Sweeten <hsweeten@visionengravers.com> Acked-by: NLiam Girdwood <lrg@slimlogic.co.uk> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 27 1月, 2011 1 次提交
-
-
由 Mark Brown 提交于
Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com> Acked-by: NAlexander Sverdlin <subaparts@yandex.ru> Acked-by: NLiam Girdwood <lrg@slimlogic.co.uk>
-
- 25 1月, 2011 1 次提交
-
-
由 Alexander Sverdlin 提交于
CS4271 CODEC driver adapted to recently introduced error handling in snd_soc_update_bits(). Added snd_soc_cache_sync() error handling. Signed-off-by: NAlexander Sverdlin <subaparts@yandex.ru> Acked-by: NLiam Girdwood <lrg@slimlogic.co.uk> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-
- 22 1月, 2011 1 次提交
-
-
由 Alexander Sverdlin 提交于
Added support for CS4271 codec to ASoC. Signed-off-by: NAlexander Sverdlin <subaparts@yandex.ru> Acked-by: NLiam Girdwood <lrg@slimlogic.co.uk> Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
-