bugs galore:
	* 0xf380 instead of htons(ETH_P_AARP), etc.  Works only on l-e.
	* back in 2.3.20 driver got readb() and friends instead of
direct dereferencing of iomem.  Somebody got too enthusiatic and replaced
	ntohs(p->mrx_overflow)
with
	ntohs(read(&p->mrx_overflow)
without noticing that (a) the sucker is 16bit and (b) that expression can't possibly
be portable anyway (hell, on l-e it's always less than 256, on b-e it's always a
multiple of 256).  Proper fix is
	swab16(readw(&p->mrx_overflow)
taking into account the conversion done by readw() itself.  That crap happened
in several places; the same fix applies.
	* untranslate() assumes little-endian almost everywhere, except for
the code checking for IPX/AARP packets; there we forgot ntohs(), so that part
only works on big-endian.
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

* ->exp_id in bootrec_exp_if is __le16; missing conversion in its use
* !(x & y) misspelled as !x & y
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

it's le32, not le16...
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

in writerids() we do _not_ byteswap, so we want to access
->opmode as little-endian.
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

never had been byteswapped, used as host-endian...
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

On big-endian we end up with swapped first two bytes in packet,
due to earlier conversion to host-endian and forgotten conversion
back.

The code we calculated that host-endian for had been duplicated
several time - it finds the 802.11 MAC header length by the first
two bytes of packet; taken into a new helper (header_len(__le16 ctl)).
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

airo_translate_scan() reads BSSListRid directly, does _not_ byteswap
and uses ->dBm (__le16) as host-endian.
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

a) gaplen would better be stored little-endian
b) for control packets (shorter than 24-byte header) we ended up with
        bap_write(ai, hdrlen == 30 ?
                (const u16*)&gap.gaplen : (const u16*)&gap, 38 - hdrlen, BAP1);
passing to card the data past the end of gap (i.e. random stuff from stack)
and did _not_ feed the gaplen at the right offset.
c) sending the contents of uninitialized fields of struct is Not Nice(tm) either
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

It's only a debugging printk, so it went unnoticed; still, the
fix is trivial, so...
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

The struct ieee8021_auth * passed to it comes straight from skb->data
without any conversions; members of the struct are little-endian, so
we'd better take that into account when doing switch by auth->algorithm,
etc.
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

on some codepaths we forgot to convert to little-endian as we do on the
rest of them and as the caller expects from us.
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

Make it match the on-the-wire endianness, eliminate byteswapping.
The only driver that used this sucker (ipw2200) updated.
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

This short patch modifies the IPv4 networking to enable use of the
240.0.0.0/4 (aka "class-E") address space as propsed in the internet
draft draft-fuller-240space-00.txt.
Signed-off-by: NJan Engelhardt <jengelh@computergmbh.de>
Acked-by: NYOSHIFUJI Hideaki <yoshfuji@linux-ipv6.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

White spaces etc. are changed in gen_replace_estimator() to make it
similar to others in a file.
Signed-off-by: NJarek Poplawski <jarkao2@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Get rid of some more sparse warnings.
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Classifier code cleanup. Get rid of printk wrapper, and fix whitespace
and other style stuff reported by checkpatch
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

ATM scheduler clean house:
  * get rid of printk and qdisc_priv() wrapper
  * split some assignment in if() statements
  * whitespace and line breaks.
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Get rid of all style things checkpatch warns about, indentation and
whitespace.
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Make dsmark work properly with non-linear and cloned skb's
Before modifying the header, it needs to check that skb header is
writeable.

Note: this makes the assumption, that if it queues a good skb
then a good skb will come out of the embedded qdisc.
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Based upon a patch by Stephen Hemminger and suggestions
from Patrick McHardy.
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Remove extraneous macro wrappers for printk and qdisc_priv.
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Get rid of a couple of sparse warnings in IPV6 addrconf code.
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The code is already gone for about half a year, the config option
has been kept around to select the replacement options for easier
upgrades. This seems long enough, people upgrading from older
kernels will have to reconfigure a lot anyway.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

When the lower device's carrier is off, the macvlan devices's
carrier state should be checked to decide whether it needs to
be turned off. Currently the lower device's state is checked
a second time.

This still works, but unnecessarily tries to turn off the
carrier when its already off.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

I think, that we can make this code flow easier to understand
by introducing the vlan_set_encap_proto() function (I hope the
name is good) to setup the skb proto and merge the paths calling
netif_rx() together.

[Patrick: Modified to apply on top of my previous patches]
Signed-off-by: NPavel Emelyanov <xemul@openvz.org>
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

- remove three instances of identical code
- remove unnecessary NULL initialization
- remove obvious and unnecessary comments
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

VLAN related mail should go to netdev.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Checkpatch cleanups, consisting mainly of overly long lines and
missing spaces.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Keep track of the number of VLAN devices in a vlan group. This allows
to have the caller sense when the group is going to be destroyed and
stop using it, which in turn allows to remove the wrapper around
unregister_vlan_dev for the NETDEV_UNREGISTER notifier and avoid
iterating over all possible VLAN ids whenever a device in unregistered.

Also fix what looks like a use-after-free (but is actually safe since
we're holding the RTNL), the real_dev reference should not be dropped
while we still use it.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Save two levels of indentation by aborting on error conditions,
remove unnecessary initialization to NULL and remove two obvious
comments.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

- move module init/exit functions to end of file, remove some now unnecessary
  forward declarations
- remove some obvious comments
- clean up proc init function and move a proc-related printk there
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The GET_VLAN_INGRESS_PRIORITY_CMD/GET_VLAN_EGRESS_PRIORITY_CMD ioctls are
not implemented and won't be, new functionality will be added to the netlink
interface. Remove the code and make the ioctl handler return -EOPNOTSUPP
for unknown commands instead of -EINVAL.

Also remove a comment about passing unknown commands to the underlying
device, that doesn't make any sense since its a VLAN specific ioctl and
if its not implemented here, its implemented nowhere.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

- use pr_* functions and common prefix for non-device related messages

- remove VLAN_ printk levels

- kill lots of useless debugging statements

- remove a few unnecessary printks like for double VID registration (already
  returns -EEXIST) and kill of a number of unnecessary checks in
  vlan_proc_{add,rem}_dev() that are already performed by the caller
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The print_mac function is not very suitable for debugging printks
in performance critical paths since without ifdefs it will always
get called. MAC_FMT can be used with pr_debug without any overhead
when debugging is disabled.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

vlan->real_dev is always equal to the device since thats what we used
for the lookup. It doesn't even seem worth a WARN_ON or BUG_ON.
Signed-off-by: NPatrick McHardy <kaber@trash.net>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>