- 01 12月, 2012 3 次提交
-
-
由 Jan Glauber 提交于
Add SCLP PCI configure/deconfigure and implement a PCI hotplug controller (s390_pci_hpc). The hotplug controller creates a slot for every PCI function in stand-by or configured state. The PCI functions are named after the PCI function ID (fid). By writing to the power attribute in /sys/bus/pci/slots/<fid>/power the PCI function is moved to stand-by or configured state. If moved to the configured state the device is automatically scanned by the s390 PCI layer. Signed-off-by: NJan Glauber <jang@linux.vnet.ibm.com> Signed-off-by: NMartin Schwidefsky <schwidefsky@de.ibm.com>
-
由 Jan Glauber 提交于
Add DMA IOMMU support using 4K page table entries. Implement dma_map_ops. Signed-off-by: NJan Glauber <jang@linux.vnet.ibm.com> Signed-off-by: NMartin Schwidefsky <schwidefsky@de.ibm.com>
-
由 Jan Glauber 提交于
Support PCI adapter interrupts using the Single-IRQ-mode. Single-IRQ-mode disables an adapter IRQ automatically after delivering it until the SIC instruction enables it again. This is used to reduce the number of IRQs for streaming workloads. Up to 64 MSI handlers can be registered per PCI function. A hash table is used to map interrupt numbers to MSI descriptors. The interrupt vector is scanned using the flogr instruction. Only MSI/MSI-X interrupts are supported, no legacy INTs. Signed-off-by: NJan Glauber <jang@linux.vnet.ibm.com> Signed-off-by: NMartin Schwidefsky <schwidefsky@de.ibm.com>
-
- 30 11月, 2012 2 次提交
-
-
由 Jan Glauber 提交于
CLP instructions are used to query the firmware about detected PCI functions, the attributes of those functions and to enable or disable a PCI function. The CLP interface is the equivalent to a PCI bus scan. Signed-off-by: NJan Glauber <jang@linux.vnet.ibm.com> Signed-off-by: NMartin Schwidefsky <schwidefsky@de.ibm.com>
-
由 Jan Glauber 提交于
Add PCI support for s390, (only 64 bit mode is supported by hardware): - PCI facility tests - PCI instructions: pcilg, pcistg, pcistb, stpcifc, mpcifc, rpcit - map readb/w/l/q and writeb/w/l/q to pcilg and pcistg instructions - pci_iomap implementation - memcpy_fromio/toio - pci_root_ops using special pcilg/pcistg - device, bus and domain allocation Signed-off-by: NJan Glauber <jang@linux.vnet.ibm.com> Signed-off-by: NMartin Schwidefsky <schwidefsky@de.ibm.com>
-