Until now, ieee1394 put an IP-over-1394 capability entry into each new
host's config ROM.  As soon as the controller was initialized --- i.e.
right after modprobe ohci1394 --- this entry triggered a hotplug event
which typically caused auto-loading of eth1394.

This irritated or annoyed many users and distributors.  Of course they
could blacklist eth1394, but then ieee1394 wrongly advertized IP-over-
1394 capability to the FireWire bus.

Therefore
  - remove the offending kernel config option
    IEEE1394_CONFIG_ROM_IP1394,
  - let eth1394 add the ROM entry by itself, i.e. only after eth1394 was
    loaded.

This fixes http://bugzilla.kernel.org/show_bug.cgi?id=7793 .

To emulate the behaviour of older kernels, simply add the following to
to /etc/modprobe.conf:

install ohci1394 /sbin/modprobe eth1394; \
                 /sbin/modprobe --ignore-install ohci1394

Note, autoloading of eth1394 when an _external_ IP-over-1394 capable
device is discovered is _not_ affected by this patch.
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

return -EINVAL becomes BUG_ON in checks of function call parameters.
Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Signed-off-by: NStefan Richter <stefanr@s5r6.in-berlin.de>

Signed-off-by: NJörn Engel <joern@wohnheim.fh-wedel.de>
Signed-off-by: NAdrian Bunk <bunk@stusta.de>

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!