- 28 7月, 2010 5 次提交
-
-
由 Giridhar Malavali 提交于
Signed-off-by: NGiridhar Malavali <giridhar.malavali@qlogic.com> Signed-off-by: NJames Bottomley <James.Bottomley@suse.de>
-
由 Lalit Chandivade 提交于
Driver was not unprotecting correctly, use correct bits to unprotect the flash on ISP 82xx. Signed-off-by: NGiridhar Malavali <giridhar.malavali@qlogic.com> Signed-off-by: NJames Bottomley <James.Bottomley@suse.de>
-
由 Santosh Vernekar 提交于
Outstanding mailbox commands, have no way to recover on f/w hung, and we timeout on waiting for mbx response. This in turn affects the recovery process as follows: - We might already be in dpc while waiting for mbx to complete, so recovery for that pci function will never get invoked. Reset Timeout (10 sec) is far less than mbx timeout (30 sec). - Other mbx cmds will get stuck due to serial mbx access. Solution is to identify fw-hung scenario and handle outstanding mbx commands to have an early-exit instead of waiting for response. Other mbx commands waiting for access will also do an early-exit if fw-hung is still applicable. Signed-off-by: NGiridhar Malavali <giridhar.malavali@qlogic.com> Signed-off-by: NJames Bottomley <James.Bottomley@suse.de>
-
由 Harish Zunjarrao 提交于
Used bootloder address from FLT while loading FW from flash as well. Signed-off-by: NGiridhar Malavali <giridhar.malavali@qlogic.com> Signed-off-by: NJames Bottomley <James.Bottomley@suse.de>
-
由 Giridhar Malavali 提交于
The CRB drive active register is cleared when driver is unloaded or when driver enters failed state. Signed-off-by: NGiridhar Malavali <giridhar.malavali@qlogic.com> Signed-off-by: NJames Bottomley <James.Bottomley@suse.de>
-
- 17 5月, 2010 1 次提交
-
-
由 Giridhar Malavali 提交于
1) Allow transition to NEED RESET state only from READY state for ISP82xx. 2) Avoid infinite ISP aborts when chip reset fails. 3) Code cleanup to remove some of the unused debug code. Signed-off-by: NLalit Chandivade <lalit.chandivade@qlogic.com> Signed-off-by: NSantosh Vernekar <santosh.vernekar@qlogic.com> Signed-off-by: NGiridhar Malavali <giridhar.malavali@qlogic.com> Signed-off-by: NJames Bottomley <James.Bottomley@suse.de>
-
- 02 5月, 2010 1 次提交
-
-
由 Giridhar Malavali 提交于
Enhanced the driver to support new FCoE host bus adapter. Signed-off-by: NGiridhar Malavali <giridhar.malavali@qlogic.com> Signed-off-by: NJames Bottomley <James.Bottomley@suse.de>
-