Allow UFS device to complete its initialization and accept
SCSI commands by setting fDeviceInit flag. The device may take
time for this operation and hence the host should poll until
fDeviceInit flag is toggled to zero. This step is mandated by
UFS device specification for device initialization completion.
Signed-off-by: NDolev Raviv <draviv@codeaurora.org>
Signed-off-by: NSujit Reddy Thumma <sthumma@codeaurora.org>
Signed-off-by: NSantosh Y <santoshsy@gmail.com>
Signed-off-by: NJames Bottomley <JBottomley@Parallels.com>

As part of device initialization sequence, sending NOP OUT UPIU and
waiting for NOP IN UPIU response is mandatory. This confirms that the
device UFS Transport (UTP) layer is functional and the host can configure
the device with further commands. Add support for sending NOP OUT UPIU to
check the device connection path and test whether the UTP layer on the
device side is functional during initialization.

A tag is acquired from the SCSI tag map space in order to send the device
management command. When the tag is acquired by internal command the scsi
command is rejected with host busy flag in order to requeue the request.
To avoid frequent collisions between internal commands and scsi commands
the device management command tag is allocated in the opposite direction
w.r.t block layer tag allocation.
Signed-off-by: NSujit Reddy Thumma <sthumma@codeaurora.org>
Signed-off-by: NDolev Raviv <draviv@codeaurora.org>
Signed-off-by: NSantosh Y <santoshsy@gmail.com>
Signed-off-by: NJames Bottomley <JBottomley@Parallels.com>

This patch segregates the PCI specific code in ufshcd.c to make it
ready for splitting into core ufs driver and PCI glue driver. Also
copyright header modification to remove extra warranty disclaim.
Reviewed-by: NArnd Bergmann <arnd@arndb.de>
Reviewed-by: NNamjae Jeon <linkinjeon@gmail.com>
Reviewed-by: NSubhash Jadavani <subhashj@codeaurora.org>
Tested-by: NMaya Erez <merez@codeaurora.org>
Signed-off-by: NVinayak Holikatti <vinholikatti@gmail.com>
Signed-off-by: NSantosh Yaraganavi <santoshsy@gmail.com>
Signed-off-by: NJames Bottomley <JBottomley@Parallels.com>

This patch adds support for Universal Flash Storage(UFS)
host controllers. The UFS host controller driver
includes host controller initialization method.

The Initialization process involves following steps:
 - Initiate UFS Host Controller initialization process by writing
   to Host controller enable register
 - Configure UFS Host controller registers with host memory space
   datastructure offsets.
 - Unipro link startup procedure
 - Check for connected device
 - Configure UFS host controller to process requests
 - Enable required interrupts
 - Configure interrupt aggregation

[jejb: fix warnings in 32 bit compile]
Signed-off-by: NSantosh Yaraganavi <santoshsy@gmail.com>
Signed-off-by: NVinayak Holikatti <vinholikatti@gmail.com>
Reviewed-by: NArnd Bergmann <arnd@linaro.org>
Reviewed-by: NVishak G <vishak.g@samsung.com>
Reviewed-by: NGirish K S <girish.shivananjappa@linaro.org>
Reviewed-by: NNamjae Jeon <linkinjeon@gmail.com>
Signed-off-by: NJames Bottomley <JBottomley@Parallels.com>