1. 28 4月, 2016 1 次提交
  2. 21 3月, 2016 1 次提交
    • M
      sctp: align MTU to a word · 3822a5ff
      Marcelo Ricardo Leitner 提交于
      SCTP is a protocol that is aligned to a word (4 bytes). Thus using bare
      MTU can sometimes return values that are not aligned, like for loopback,
      which is 65536 but ipv4_mtu() limits that to 65535. This mis-alignment
      will cause the last non-aligned bytes to never be used and can cause
      issues with congestion control.
      
      So it's better to just consider a lower MTU and keep congestion control
      calcs saner as they are based on PMTU.
      
      Same applies to icmp frag needed messages, which is also fixed by this
      patch.
      
      One other effect of this is the inability to send MTU-sized packet
      without queueing or fragmentation and without hitting Nagle. As the
      check performed at sctp_packet_can_append_data():
      
      if (chunk->skb->len + q->out_qlen >= transport->pathmtu - packet->overhead)
      	/* Enough data queued to fill a packet */
      	return SCTP_XMIT_OK;
      
      with the above example of MTU, if there are no other messages queued,
      one cannot send a packet that just fits one packet (65532 bytes) and
      without causing DATA chunk fragmentation or a delay.
      
      v2:
       - Added WORD_TRUNC macro
      Signed-off-by: NMarcelo Ricardo Leitner <marcelo.leitner@gmail.com>
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      3822a5ff
  3. 14 3月, 2016 1 次提交
    • M
      sctp: allow sctp_transmit_packet and others to use gfp · cea8768f
      Marcelo Ricardo Leitner 提交于
      Currently sctp_sendmsg() triggers some calls that will allocate memory
      with GFP_ATOMIC even when not necessary. In the case of
      sctp_packet_transmit it will allocate a linear skb that will be used to
      construct the packet and this may cause sends to fail due to ENOMEM more
      often than anticipated specially with big MTUs.
      
      This patch thus allows it to inherit gfp flags from upper calls so that
      it can use GFP_KERNEL if it was triggered by a sctp_sendmsg call or
      similar. All others, like retransmits or flushes started from BH, are
      still allocated using GFP_ATOMIC.
      
      In netperf tests this didn't result in any performance drawbacks when
      memory is not too fragmented and made it trigger ENOMEM way less often.
      Signed-off-by: NMarcelo Ricardo Leitner <marcelo.leitner@gmail.com>
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      cea8768f
  4. 18 2月, 2016 1 次提交
  5. 29 1月, 2016 1 次提交
  6. 18 1月, 2016 1 次提交
  7. 16 1月, 2016 1 次提交
  8. 06 1月, 2016 3 次提交
  9. 30 8月, 2014 1 次提交
  10. 01 8月, 2014 1 次提交
  11. 22 1月, 2014 3 次提交
  12. 27 12月, 2013 3 次提交
  13. 23 12月, 2013 1 次提交
  14. 22 12月, 2013 2 次提交
  15. 21 12月, 2013 1 次提交
  16. 19 12月, 2013 1 次提交
  17. 12 12月, 2013 1 次提交
  18. 07 12月, 2013 1 次提交
  19. 17 9月, 2013 1 次提交
  20. 10 8月, 2013 3 次提交
  21. 28 7月, 2013 1 次提交
  22. 25 7月, 2013 1 次提交
  23. 02 7月, 2013 1 次提交
    • D
      net: sctp: rework debugging framework to use pr_debug and friends · bb33381d
      Daniel Borkmann 提交于
      We should get rid of all own SCTP debug printk macros and use the ones
      that the kernel offers anyway instead. This makes the code more readable
      and conform to the kernel code, and offers all the features of dynamic
      debbuging that pr_debug() et al has, such as only turning on/off portions
      of debug messages at runtime through debugfs. The runtime cost of having
      CONFIG_DYNAMIC_DEBUG enabled, but none of the debug statements printing,
      is negligible [1]. If kernel debugging is completly turned off, then these
      statements will also compile into "empty" functions.
      
      While we're at it, we also need to change the Kconfig option as it /now/
      only refers to the ifdef'ed code portions in outqueue.c that enable further
      debugging/tracing of SCTP transaction fields. Also, since SCTP_ASSERT code
      was enabled with this Kconfig option and has now been removed, we
      transform those code parts into WARNs resp. where appropriate BUG_ONs so
      that those bugs can be more easily detected as probably not many people
      have SCTP debugging permanently turned on.
      
      To turn on all SCTP debugging, the following steps are needed:
      
       # mount -t debugfs none /sys/kernel/debug
       # echo -n 'module sctp +p' > /sys/kernel/debug/dynamic_debug/control
      
      This can be done more fine-grained on a per file, per line basis and others
      as described in [2].
      
       [1] https://www.kernel.org/doc/ols/2009/ols2009-pages-39-46.pdf
       [2] Documentation/dynamic-debug-howto.txt
      Signed-off-by: NDaniel Borkmann <dborkman@redhat.com>
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      bb33381d
  24. 18 6月, 2013 1 次提交
  25. 31 5月, 2013 1 次提交
  26. 29 5月, 2013 1 次提交
  27. 28 2月, 2013 1 次提交
    • S
      hlist: drop the node parameter from iterators · b67bfe0d
      Sasha Levin 提交于
      I'm not sure why, but the hlist for each entry iterators were conceived
      
              list_for_each_entry(pos, head, member)
      
      The hlist ones were greedy and wanted an extra parameter:
      
              hlist_for_each_entry(tpos, pos, head, member)
      
      Why did they need an extra pos parameter? I'm not quite sure. Not only
      they don't really need it, it also prevents the iterator from looking
      exactly like the list iterator, which is unfortunate.
      
      Besides the semantic patch, there was some manual work required:
      
       - Fix up the actual hlist iterators in linux/list.h
       - Fix up the declaration of other iterators based on the hlist ones.
       - A very small amount of places were using the 'node' parameter, this
       was modified to use 'obj->member' instead.
       - Coccinelle didn't handle the hlist_for_each_entry_safe iterator
       properly, so those had to be fixed up manually.
      
      The semantic patch which is mostly the work of Peter Senna Tschudin is here:
      
      @@
      iterator name hlist_for_each_entry, hlist_for_each_entry_continue, hlist_for_each_entry_from, hlist_for_each_entry_rcu, hlist_for_each_entry_rcu_bh, hlist_for_each_entry_continue_rcu_bh, for_each_busy_worker, ax25_uid_for_each, ax25_for_each, inet_bind_bucket_for_each, sctp_for_each_hentry, sk_for_each, sk_for_each_rcu, sk_for_each_from, sk_for_each_safe, sk_for_each_bound, hlist_for_each_entry_safe, hlist_for_each_entry_continue_rcu, nr_neigh_for_each, nr_neigh_for_each_safe, nr_node_for_each, nr_node_for_each_safe, for_each_gfn_indirect_valid_sp, for_each_gfn_sp, for_each_host;
      
      type T;
      expression a,c,d,e;
      identifier b;
      statement S;
      @@
      
      -T b;
          <+... when != b
      (
      hlist_for_each_entry(a,
      - b,
      c, d) S
      |
      hlist_for_each_entry_continue(a,
      - b,
      c) S
      |
      hlist_for_each_entry_from(a,
      - b,
      c) S
      |
      hlist_for_each_entry_rcu(a,
      - b,
      c, d) S
      |
      hlist_for_each_entry_rcu_bh(a,
      - b,
      c, d) S
      |
      hlist_for_each_entry_continue_rcu_bh(a,
      - b,
      c) S
      |
      for_each_busy_worker(a, c,
      - b,
      d) S
      |
      ax25_uid_for_each(a,
      - b,
      c) S
      |
      ax25_for_each(a,
      - b,
      c) S
      |
      inet_bind_bucket_for_each(a,
      - b,
      c) S
      |
      sctp_for_each_hentry(a,
      - b,
      c) S
      |
      sk_for_each(a,
      - b,
      c) S
      |
      sk_for_each_rcu(a,
      - b,
      c) S
      |
      sk_for_each_from
      -(a, b)
      +(a)
      S
      + sk_for_each_from(a) S
      |
      sk_for_each_safe(a,
      - b,
      c, d) S
      |
      sk_for_each_bound(a,
      - b,
      c) S
      |
      hlist_for_each_entry_safe(a,
      - b,
      c, d, e) S
      |
      hlist_for_each_entry_continue_rcu(a,
      - b,
      c) S
      |
      nr_neigh_for_each(a,
      - b,
      c) S
      |
      nr_neigh_for_each_safe(a,
      - b,
      c, d) S
      |
      nr_node_for_each(a,
      - b,
      c) S
      |
      nr_node_for_each_safe(a,
      - b,
      c, d) S
      |
      - for_each_gfn_sp(a, c, d, b) S
      + for_each_gfn_sp(a, c, d) S
      |
      - for_each_gfn_indirect_valid_sp(a, c, d, b) S
      + for_each_gfn_indirect_valid_sp(a, c, d) S
      |
      for_each_host(a,
      - b,
      c) S
      |
      for_each_host_safe(a,
      - b,
      c, d) S
      |
      for_each_mesh_entry(a,
      - b,
      c, d) S
      )
          ...+>
      
      [akpm@linux-foundation.org: drop bogus change from net/ipv4/raw.c]
      [akpm@linux-foundation.org: drop bogus hunk from net/ipv6/raw.c]
      [akpm@linux-foundation.org: checkpatch fixes]
      [akpm@linux-foundation.org: fix warnings]
      [akpm@linux-foudnation.org: redo intrusive kvm changes]
      Tested-by: NPeter Senna Tschudin <peter.senna@gmail.com>
      Acked-by: NPaul E. McKenney <paulmck@linux.vnet.ibm.com>
      Signed-off-by: NSasha Levin <sasha.levin@oracle.com>
      Cc: Wu Fengguang <fengguang.wu@intel.com>
      Cc: Marcelo Tosatti <mtosatti@redhat.com>
      Cc: Gleb Natapov <gleb@redhat.com>
      Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
      Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
      b67bfe0d
  28. 05 2月, 2013 1 次提交
  29. 05 10月, 2012 1 次提交
  30. 15 8月, 2012 2 次提交