altera-ps-spi loads FPGA firmware over SPI, using the "passive serial"
interface on Altera Arria 10, Cyclone V or Stratix V FPGAs.

This is one of the simpler ways to set up an FPGA at runtime.
The signal interface is close to unidirectional SPI with lsb first.
Signed-off-by: NJoshua Clayton <stillcompiling@gmail.com>
Signed-off-by: NAnatolij Gustschin <agust@denx.de>
Signed-off-by: NAlan Tull <atull@kernel.org>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

This adds support for the Xilinx LogiCORE PR Decoupler
soft-ip that does decoupling of PR regions in the FPGA
fabric during partial reconfiguration.
Signed-off-by: NMoritz Fischer <mdf@kernel.org>
Signed-off-by: NMichal Simek <michal.simek@xilinx.com>
Cc: Sören Brinkmann <soren.brinkmann@xilinx.com>
Cc: linux-kernel@vger.kernel.org
Cc: devicetree@vger.kernel.org
Acked-by: NAlan Tull <atull@kernel.org>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

This adds a platform bus driver for a fpga-mgr driver
that uses the Altera Partial Reconfiguration IP component.
Signed-off-by: NMatthew Gerlach <matthew.gerlach@linux.intel.com>
Acked-by: NAlan Tull <atull@kernel.org>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

Adding the core functions necessary for a fpga-mgr driver
for the Altera Partial IP component.  It is intended for
these functions to be used by the various bus implementations
like the platform bus or the PCIe bus.
Signed-off-by: NMatthew Gerlach <matthew.gerlach@linux.intel.com>
Acked-by: NAlan Tull <atull@kernel.org>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

The driver loads FPGA firmware over SPI, using the "slave serial"
configuration interface on Xilinx FPGAs.
Signed-off-by: NAnatolij Gustschin <agust@denx.de>
Acked-by: NMichal Simek <michal.simek@xilinx.com>
Reviewed-by: NMoritz Fischer <mdf@kernel.org>
Acked-by: NAlan Tull <atull@kernel.org>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

This patch adds support to the FPGA manager for configuring the SRAM of
iCE40LM, iCE40LP, iCE40HX, iCE40 Ultra, iCE40 UltraLite and iCE40
UltraPlus devices, through slave SPI.
Signed-off-by: NJoel Holdsworth <joel@airwebreathe.org.uk>
Reviewed-by: NMarek Vasut <marex@denx.de>
Reviewed-by: NMoritz Fischer <moritz.fischer@ettus.com>
Acked-by: NAlan Tull <atull@opensource.altera.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

Add support for loading bitstreams on the Altera Cyclone II FPGA
populated on the TS-7300 board. This is done through the configuration
and data registers offered through a memory interface between the EP93xx
SoC and the FPGA via an intermediate CPLD device.

The EP93xx SoC on the TS-7300 does not have direct means of configuring
the on-board FPGA other than by using the special memory mapped
interface to the CPLD. No other entity on the system can control the
FPGA bitstream.
Signed-off-by: NFlorian Fainelli <f.fainelli@gmail.com>
Acked-by: NAlan Tull <atull@opensource.altera.com>
Acked-by: NMoritz Fischer <moritz.fischer@ettus.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

Add low level driver to support reprogramming FPGAs for Altera
SoCFPGA Arria10.
Signed-off-by: NAlan Tull <atull@opensource.altera.com>
Reviewed-by: NMoritz Fischer <moritz.fischer@ettus.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

Add a low level driver for Altera Freeze Bridges to the FPGA Bridge
framework.  A freeze bridge is a bridge that exists in the FPGA
fabric to isolate one region of the FPGA from the busses while that
one region is being reprogrammed.
Signed-off-by: NAlan Tull <atull@opensource.altera.com>
Signed-off-by: NMatthew Gerlach <mgerlach@opensource.altera.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

Supports Altera SOCFPGA bridges:
 * fpga2sdram
 * fpga2hps
 * hps2fpga
 * lwhps2fpga

Allows enabling/disabling the bridges through the FPGA
Bridge Framework API functions.

The fpga2sdram driver only supports enabling and disabling
of the ports that been configured early on.  This is due to
a hardware limitation where the read, write, and command
ports on the fpga2sdram bridge can only be reconfigured
while there are no transactions to the sdram, i.e. when
running out of OCRAM before the kernel boots.

Device tree property 'init-val' configures the driver to
enable or disable the bridge during probe.  If the property
does not exist, the driver will leave the bridge in its
current state.
Signed-off-by: NAlan Tull <atull@opensource.altera.com>
Signed-off-by: NMatthew Gerlach <mgerlach@altera.com>
Signed-off-by: NDinh Nguyen <dinguyen@opensource.altera.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

FPGA Regions support programming FPGA under control of the Device
Tree.
Signed-off-by: NAlan Tull <atull@opensource.altera.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

This framework adds API functions for enabling/
disabling FPGA bridges under kernel control.

This allows the Linux kernel to disable FPGA bridges
during FPGA reprogramming and to enable FPGA bridges
when FPGA reprogramming is done.  This framework is
be manufacturer-agnostic, allowing it to be used in
interfaces that use the FPGA Manager Framework to
reprogram FPGA's.

The functions are:
* of_fpga_bridge_get
* fpga_bridge_put
   Get/put an exclusive reference to a FPGA bridge.

* fpga_bridge_enable
* fpga_bridge_disable
   Enable/Disable traffic through a bridge.

* fpga_bridge_register
* fpga_bridge_unregister
   Register/unregister a device-specific low level FPGA
   Bridge driver.

Get an exclusive reference to a bridge and add it to a list:
* fpga_bridge_get_to_list

To enable/disable/put a set of bridges that are on a list:
* fpga_bridges_enable
* fpga_bridges_disable
* fpga_bridges_put
Signed-off-by: NAlan Tull <atull@opensource.altera.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

This commit adds FPGA Manager support for the Xilinx Zynq chip.
The code borrows some from the xdevcfg driver in Xilinx'
vendor tree.
Signed-off-by: NMoritz Fischer <moritz.fischer@ettus.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

Add driver to fpga manager framework to allow configuration
of FPGA in Altera SoCFPGA parts.
Signed-off-by: NAlan Tull <atull@opensource.altera.com>
Acked-by: NMichal Simek <michal.simek@xilinx.com>
Acked-by: NMoritz Fischer <moritz.fischer@ettus.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

API to support programming FPGA's.

The following functions are exported as GPL:
* fpga_mgr_buf_load
   Load fpga from image in buffer

* fpga_mgr_firmware_load
   Request firmware and load it to the FPGA.

* fpga_mgr_register
* fpga_mgr_unregister
   FPGA device drivers can be added by calling
   fpga_mgr_register() to register a set of
   fpga_manager_ops to do device specific stuff.

* of_fpga_mgr_get
* fpga_mgr_put
   Get/put a reference to a fpga manager.

The following sysfs files are created:
* /sys/class/fpga_manager/<fpga>/name
  Name of low level driver.

* /sys/class/fpga_manager/<fpga>/state
  State of fpga manager
Signed-off-by: NAlan Tull <atull@opensource.altera.com>
Acked-by: NMichal Simek <michal.simek@xilinx.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>