- 27 1月, 2008 1 次提交
-
-
由 Grant Likely 提交于
Put all the mpc5200 board config option behind a menu item to get them out of the top level of the platform support list Signed-off-by: NGrant Likely <grant.likely@secretlab.ca>
-
- 19 1月, 2008 1 次提交
-
-
由 Marian Balakowicz 提交于
This patch adds support for 'mpc5200-simple-platform' compatible boards which do not need a platform specific setup. Such boards are supported assuming the following: - GPIO pins are configured by the firmware, - CDM configuration (clocking) is setup correctly by firmware, - if the 'fsl,has-wdt' property is present in one of the gpt nodes, then it is safe to use such gpt to reset the board, - PCI is supported if enabled in the kernel configuration and if there is a PCI bus node defined in the device tree. Signed-off-by: NMarian Balakowicz <m8@semihalf.com> Signed-off-by: NGrant Likely <grant.likely@secretlab.ca>
-
- 03 10月, 2007 1 次提交
-
-
由 Domen Puncer 提交于
This provides an implementation of the <linux/clk.h> interface for arch/powerpc using a set of function pointers in clk_functions. Platforms that want to support this interface should fill clk_functions and select CONFIG_PPC_CLOCK in Kconfig. Signed-off-by: NDomen Puncer <domen.puncer@telargo.com> Signed-off-by: NPaul Mackerras <paulus@samba.org>
-
- 22 9月, 2007 1 次提交
-
-
由 Grant Likely 提交于
Signed-off-by: NGrant Likely <grant.likely@secretlab.ca> Acked-by: NDavid Gibson <david@gibson.dropbear.id.au> Signed-off-by: NPaul Mackerras <paulus@samba.org>
-
- 07 5月, 2007 1 次提交
-
-
由 Domen Puncer 提交于
Add fsl-i2c to mpc5200 i2c node in device tree, and enable FSL_SOC. Tested to work with built-in eeprom on lite5200b. Signed-off-by: NDomen Puncer <domen.puncer@telargo.com> Signed-off-by: NSylvain Munaut <tnt@246tNt.com> Signed-off-by: NPaul Mackerras <paulus@samba.org>
-
- 22 3月, 2007 1 次提交
-
-
由 Kumar Gala 提交于
Cleaning up arch/powerpc/Kconfig platform support. Signed-off-by: NKumar Gala <galak@kernel.crashing.org>
-