The cool thing is that same kernel image can run on
 - nsim OSCI simulation platform
 - SDPlite FPGA setups
Signed-off-by: NVineet Gupta <vgupta@synopsys.com>

With required ARC PGU updates that allow it to be used on simulation
platforms we may finally utilize ARC PGU in nSIM OSCI virtual platforms
with modern Linux kernels.
Signed-off-by: NAlexey Brodkin <abrodkin@synopsys.com>

Since ezchip network driver was adapted to little endian architecture
this patch provides the corresponding arch/arc/{boot/dts,configs}/ updates so
we can switch over to this device-model/driver for OSCI platform.

Cc: Alexey Brodkin <abrodkin@synopsys.com>
Signed-off-by: NLada Trimasova <ltrimas@synopsys.com>
Signed-off-by: NVineet Gupta <vgupta@synopsys.com>

The problem is with CONFIG_CPU_BIG_ENDIAN=y we still needed .config
fixup to override the the defconfig prefix to arceb-linux-

So remove these from defconfig and let user pass this via CROSS_COMPILE
environment var or use the default for ENDIAN (per previous patch)

No other arch carries them in defconfigs anyways !

Cc: Noam Camus <noamc@ezchip.com>
Cc: Alexey Brodkin <abrodkin@synopsys.com>
Cc: Anton Kolesov <akolesov@synosys.com>
Signed-off-by: NVineet Gupta <vgupta@synopsys.com>

Even though DEVTMPFS is required when our pre-built initramfs
is used it is not the case in general. It is perfectly possible
to use initramfs with device nodes already populated or there
could be other usages, see discussion below for more detials:
http://thread.gmane.org/gmane.comp.embedded.openwrt.devel/37819/focus=37821

This change removes mentioned dependency from arch/arc/Kconfig
updating instead those defconfigs that are usually used with this
kind of pre-build initramfs.

And while at it all touched defconfigs were regenerated via
savedefconfig and some options were removed:
 * USB is selected by other options implicitly
 * VGA_CONSOLE is disableb for ARC since
   031e29b5
 * EXT3_FS automatically selects EXT4_FS
 * MTDxxx and JFFS2_FS make no sense for AXS because
   AXS NAND controller is not upstreamed
 * NET_OSCI_LAN is not in upstream as well
 * ARCPGU_xxx options make no sense because ARC PGU is not yet
   in upstream and when it gets there all config options would
   be taken from devicetree
Signed-off-by: NAlexey Brodkin <abrodkin@synopsys.com>
Signed-off-by: NVineet Gupta <vgupta@synopsys.com>

When building kernel with buildroot built toolchain, CROSS_COMPILE
currently needs adjustment even if minor. This is because the defconfigs
prefer "arc-linux-uclibc-" prefix from hand built (non buildroot) toolchain
while buildroot provides "arc-buildroot-linux-uclibc-"

To avoid this use the common "arc-linux-" prefix which is provided by
buildroot and has also been in hand built tools for quite some time.
Signed-off-by: Nsujayraaj <sujayraaj@gmail.com>
Signed-off-by: NVineet Gupta <vgupta@synopsys.com>
[vgupta: updated changelog]

Cc: Grant Likely <grant.likely@linaro.org>
Cc: Rob Herring <robh+dt@kernel.org>
Cc: devicetree@vger.kernel.org
Signed-off-by: NVineet Gupta <vgupta@synopsys.com>

* Remove remanants of legacy ARC FPGA platforms (AA4, ML509...)
* Only nsim simulation platform is left, rename platform accordingly
* AA4 DT stuff is compatible with nsim for ARC700 so rename it too
Signed-off-by: NVineet Gupta <vgupta@synopsys.com>

Signed-off-by: NVineet Gupta <vgupta@synopsys.com>

ARC GNU tools have had support for arc-linux-* driver for some time now.
This is functionally similar to arc-linux-uclibc-* but uclibc prefix
seemed weird at best when trying to compile the kernel itself.
Signed-off-by: NVineet Gupta <vgupta@synopsys.com>

Signed-off-by: NMischa Jonker <mjonker@synopsys.com>

Commit c00bfd97 ("ARC: [arcfpga] Get rid of legacy BVCI latency unit
support") removed the Kconfig symbol ARC_HAS_BVCI_LAT_UNIT. And that
symbol's entry was the only place were the symbols ARC_BOARD_ANGEL4 and
ARC_BOARD_ML509 were used. So ARC_BOARD_ANGEL4 and ARC_BOARD_ML509 can
be removed too.
Signed-off-by: NPaul Bolle <pebolle@tiscali.nl>
Signed-off-by: NVineet Gupta <vgupta@synopsys.com>

Despite the switch to right UART driver (prev patch), serial console
still doesn't work due to missing CONFIG_SERIAL_OF_PLATFORM

Also fix the default cmdline in DT to not refer to out-of-tree
ARC framebuffer driver for console.
Signed-off-by: NVineet Gupta <vgupta@synopsys.com>
Cc: <stable@vger.kernel.org>   #3.10, 3.12, 3.13, 3.14
Cc: Francois Bedard <Francois.Bedard@synopsys.com>

* DWARF unwinder related
  + Force DWARF2 compliant .debug_frame (gcc 4.8 defaults to DWARF4
    which kernel unwinder can't grok).
  + Discard the additional .eh_frame generated
  + Discard the dwarf4 debug info generated by -gdwarf-2 for normal
    no debug case

* 4.8 already uses arc600 multilibs for -mno-mpy

* switch to using uclibc compiler (to get -mmedium-calls and -mno-sdata)
  and also since buildroot can only use 1 toolchain
Signed-off-by: NVineet Gupta <vgupta@synopsys.com>

This adds support for an ARC Virtual Platform. This platform is based on the
System C standard promoted by the OSCI (Open System C Initiative) and uses
nSIM to simulate the ARC CPU core itself.

Users can build a virtual SoC by combining System C models of peripherals
and CPU cores.
Signed-off-by: NMischa Jonker <mjonker@synopsys.com>
Signed-off-by: NVineet Gupta <vgupta@synopsys.com>

* Allow initramfs path to be symlink
* CONFIG_PREEMPT be default
Signed-off-by: NVineet Gupta <vgupta@synopsys.com>

Signed-off-by: NVineet Gupta <vgupta@synopsys.com>

With this we get to a running kernel on ISS

---------------------------------->8-----------------------------------
Linux version 3.8.0-rc3+ (vineetg@vineetg-Latitude) (gcc version 4.4.7
(ARCompact elf32 toolchain (built 20121213)) ) #3 Thu Jan 17 14:22:05
IST 2013
Board "arc-angel4" from snps (Manufacturer)
Memory size set via devicetree 256M
[plat-arcfpga]: registering early dev resources
bootconsole [early_ARCuart0] enabled
pcpu-alloc: s0 r0 d32768 u32768 alloc=1*32768
pcpu-alloc: [0] 0
Built 1 zonelists in Zone order, mobility grouping on.  Total pages:
32624
Kernel command line: console=ttyARC0,115200n8
PID hash table entries: 1024 (order: -1, 4096 bytes)
Dentry cache hash table entries: 32768 (order: 4, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 3, 65536 bytes)
Memory Available: 248M / 256M (1312K code, 463K data, 4184K init, 1400K
reserv)
SLUB: Genslabs=12, HWalign=64, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
NR_IRQS:16
Console: colour dummy device 80x25
Calibrating delay loop... 39.73 BogoMIPS (lpj=198656)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 1024
devtmpfs: initialized
[plat-arcfpga]: registering device resources
bio: create slab <bio-0> at 0
Switching to clocksource ARC RTSC
io scheduler noop registered (default)
arc-uart: ttyARC0 at MMIO 0xc0fc1000 (irq = 5) is a arc-uart
console [ttyARC0] enabled, bootconsole disabled
console [ttyARC0] enabled, bootconsole disabled
mousedev: PS/2 mouse device common for all mice
Warning: unable to open an initial console.
Freeing unused kernel memory: 4184k [80002000] to [80418000]
Mounting proc
Mounting sysfs
Mounting devpts
Setting hostname to ARCLinux
Starting System logger (syslogd)
Bringing up loopback device
ifconfig: socket: Function not implemented
route: socket: Function not implemented
Disk not detected !
Mounting tmpfs
mount: mounting tmpfs on /dev/shm failed: Invalid argument
/etc/init.d/rcS: line 76: can't create /proc/sys/kernel/msgmni:
nonexistent directory

Please press Enter to activate this console.
***********************************************************************
                        Welcome to ARCLinux
***********************************************************************
[ARCLinux]$

---------------------------------->8-----------------------------------
Signed-off-by: NVineet Gupta <vgupta@synopsys.com>