Use GPIO_ACTIVE_HIGH and GPIO_ACTIVE_LOW instead of 0 and 1.
Signed-off-by: NAndrew Lunn <andrew@lunn.ch>
Signed-off-by: NJason Cooper <jason@lakedaemon.net>

Generally, power LEDs should indicate when power is applied, and go out
once power is removed.  _Not_ annoy the developer with migraine-inducing
blinking reminicent of some badly animated television series designed to
sell sugar to children.

On a more serious note, most of these OS-specific properties aren't
necessary and should be removed.  I left two that are legitimately tying
disk LEDs to disk activity.  Other than that, we keep the state the
bootloader left them in until userspace changes the state via sysfs.
Signed-off-by: NJason Cooper <jason@lakedaemon.net>

Signed-off-by: NEzequiel Garcia <ezequiel.garcia@free-electrons.com>
Tested-by: NAndrew Lunn <andrew@lunn.ch>
Tested-by: NSebastian Hesselbarth <sebastian.hesselbarth@gmail.com>
Signed-off-by: NJason Cooper <jason@lakedaemon.net>

When the pinmux mechanism was added in Kirkwood, the device driver
core was not yet providing the possibility of attaching pinmux
configurations to all devices, drivers had to do it explicitly, and
not all drivers were doing this.

Now that the driver core does that in a generic way, it makes sense to
attach the pinmux configuration to their corresponding devices.
Signed-off-by: NSimon Baatz <gmbnomis@gmail.com>
Reviewed-by: NThomas Petazzoni <thomas.petazzoni@free-electrons.com>
Signed-off-by: NJason Cooper <jason@lakedaemon.net>

Signed-off-by: NSimon Baatz <gmbnomis@gmail.com>
Signed-off-by: NJason Cooper <jason@lakedaemon.net>