Enable automatic measurements at 10 Hz and use the alarm interrupt to react
more quickly to sudden temperature changes above the passive or critical
temperature trip points.
Signed-off-by: NPhilipp Zabel <p.zabel@pengutronix.de>
Acked-by: NShawn Guo <shawn.guo@linaro.org>
Signed-off-by: NZhang Rui <rui.zhang@intel.com>

Set passive and critical trip point values depending on the maximum die
temperature stored in the OCOTP fuses. This allows higher trip points
for industrial and automotive rated i.MX6 SoCs.
Also allow to configure the passive trip point from userspace.
Signed-off-by: NPhilipp Zabel <p.zabel@pengutronix.de>
Acked-by: NShawn Guo <shawn.guo@linaro.org>
Signed-off-by: NZhang Rui <rui.zhang@intel.com>

This is based on the initial imx thermal work done by
Rob Lee <rob.lee@linaro.org> (Not sure if the email address is still
valid).  Since he is no longer interested in the work and I have
rewritten a significant amount of the code, I just took the authorship
over from him.

It adds the imx thermal support using Temperature Monitor (TEMPMON)
block found on some Freescale i.MX SoCs.  The driver uses syscon regmap
interface to access TEMPMON control registers and calibration data, and
supports cpufreq as the cooling device.
Signed-off-by: NShawn Guo <shawn.guo@linaro.org>
Signed-off-by: NEduardo Valentin <eduardo.valentin@ti.com>