update_mem_hiwater has attracted various criticisms, in particular from those
concerned with mm scalability.  Originally it was called whenever rss or
total_vm got raised.  Then many of those callsites were replaced by a timer
tick call from account_system_time.  Now Frank van Maarseveen reports that to
be found inadequate.  How about this?  Works for Frank.

Replace update_mem_hiwater, a poor combination of two unrelated ops, by macros
update_hiwater_rss and update_hiwater_vm.  Don't attempt to keep
mm->hiwater_rss up to date at timer tick, nor every time we raise rss (usually
by 1): those are hot paths.  Do the opposite, update only when about to lower
rss (usually by many), or just before final accounting in do_exit.  Handle
mm->hiwater_vm in the same way, though it's much less of an issue.  Demand
that whoever collects these hiwater statistics do the work of taking the
maximum with rss or total_vm.

And there has been no collector of these hiwater statistics in the tree.  The
new convention needs an example, so match Frank's usage by adding a VmPeak
line above VmSize to /proc/<pid>/status, and also a VmHWM line above VmRSS
(High-Water-Mark or High-Water-Memory).

There was a particular anomaly during mremap move, that hiwater_vm might be
captured too high.  A fleeting such anomaly remains, but it's quickly
corrected now, whereas before it would stick.

What locking?  None: if the app is racy then these statistics will be racy,
it's not worth any overhead to make them exact.  But whenever it suits,
hiwater_vm is updated under exclusive mmap_sem, and hiwater_rss under
page_table_lock (for now) or with preemption disabled (later on): without
going to any trouble, minimize the time between reading current values and
updating, to minimize those occasions when a racing thread bumps a count up
and back down in between.
Signed-off-by: NHugh Dickins <hugh@veritas.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

I was lazy when we added anon_rss, and chose to change as few places as
possible.  So currently each anonymous page has to be counted twice, in rss
and in anon_rss.  Which won't be so good if those are atomic counts in some
configurations.

Change that around: keep file_rss and anon_rss separately, and add them
together (with get_mm_rss macro) when the total is needed - reading two
atomics is much cheaper than updating two atomics.  And update anon_rss
upfront, typically in memory.c, not tucked away in page_add_anon_rmap.
Signed-off-by: NHugh Dickins <hugh@veritas.com>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

 - added typedef unsigned int __nocast gfp_t;

 - replaced __nocast uses for gfp flags with gfp_t - it gives exactly
   the same warnings as far as sparse is concerned, doesn't change
   generated code (from gcc point of view we replaced unsigned int with
   typedef) and documents what's going on far better.
Signed-off-by: NAl Viro <viro@zeniv.linux.org.uk>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Move call to get_mm_counter() in update_mem_hiwater() to be
inside the check for tsk->mm being null. Otherwise you can be
following a null pointer here. This patch submitted by
Javier Herrero <jherrero@hvsistemas.es>.

Modify the end check for munmap regions to allow for the
legacy behavior of 0 being valid. Pretty much all current
uClinux system libc malloc's pass in 0 as the end point.
A hard check will fail on these, so change the check so
that if it is non-zero it must be valid otherwise it fails.
A passed in value will always succeed (as it used too).

Also export a few more mm system functions - to be consistent
with the VM code exports.
Signed-off-by: NGreg Ungerer <gerg@uclinux.com>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

We have found what seems to be a small bug in __vm_enough_memory() when
sysctl_overcommit_memory is set to OVERCOMMIT_NEVER.

When this bug occurs the systems fails to boot, with /sbin/init whining
about fork() returning ENOMEM.

We hunted down the problem to this:

The deferred update mecanism used in vm_acct_memory(), on a SMP system,
allows the vm_committed_space counter to have a negative value.

This should not be a problem since this counter is known to be inaccurate.

But in __vm_enough_memory() this counter is compared to the `allowed'
variable, which is an unsigned long.  This comparison is broken since it
will consider the negative values of vm_committed_space to be huge positive
values, resulting in a memory allocation failure.

Signed-off-by: <Jean-Marc.Saffroy@ext.bull.net>
Signed-off-by: <Simon.Derr@bull.net>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Ingo recently introduced a great speedup for allocating new mmaps using the
free_area_cache pointer which boosts the specweb SSL benchmark by 4-5% and
causes huge performance increases in thread creation.

The downside of this patch is that it does lead to fragmentation in the
mmap-ed areas (visible via /proc/self/maps), such that some applications
that work fine under 2.4 kernels quickly run out of memory on any 2.6
kernel.

The problem is twofold:

  1) the free_area_cache is used to continue a search for memory where
     the last search ended.  Before the change new areas were always
     searched from the base address on.

     So now new small areas are cluttering holes of all sizes
     throughout the whole mmap-able region whereas before small holes
     tended to close holes near the base leaving holes far from the base
     large and available for larger requests.

  2) the free_area_cache also is set to the location of the last
     munmap-ed area so in scenarios where we allocate e.g.  five regions of
     1K each, then free regions 4 2 3 in this order the next request for 1K
     will be placed in the position of the old region 3, whereas before we
     appended it to the still active region 1, placing it at the location
     of the old region 2.  Before we had 1 free region of 2K, now we only
     get two free regions of 1K -> fragmentation.

The patch addresses thes issues by introducing yet another cache descriptor
cached_hole_size that contains the largest known hole size below the
current free_area_cache.  If a new request comes in the size is compared
against the cached_hole_size and if the request can be filled with a hole
below free_area_cache the search is started from the base instead.

The results look promising: Whereas 2.6.12-rc4 fragments quickly and my
(earlier posted) leakme.c test program terminates after 50000+ iterations
with 96 distinct and fragmented maps in /proc/self/maps it performs nicely
(as expected) with thread creation, Ingo's test_str02 with 20000 threads
requires 0.7s system time.

Taking out Ingo's patch (un-patch available per request) by basically
deleting all mentions of free_area_cache from the kernel and starting the
search for new memory always at the respective bases we observe: leakme
terminates successfully with 11 distinctive hardly fragmented areas in
/proc/self/maps but thread creating is gringdingly slow: 30+s(!) system
time for Ingo's test_str02 with 20000 threads.

Now - drumroll ;-) the appended patch works fine with leakme: it ends with
only 7 distinct areas in /proc/self/maps and also thread creation seems
sufficiently fast with 0.71s for 20000 threads.
Signed-off-by: NWolfgang Wander <wwc@rentec.com>
Credit-to: "Richard Purdie" <rpurdie@rpsys.net>
Signed-off-by: NKen Chen <kenneth.w.chen@intel.com>
Acked-by: Ingo Molnar <mingo@elte.hu> (partly)
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Linus changed the second argument of __vmalloc from int to unsigned int
breaking the compilation for CONFIG_MMU=n configurations (since he only
changed vmalloc.c but not nommu.c).
Signed-off-by: NAdrian Bunk <bunk@stusta.de>
Signed-off-by: NAndrew Morton <akpm@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!