Conflicts:
	drivers/acpi/Makefile
Signed-off-by: NLen Brown <len.brown@intel.com>

Conflicts:
	drivers/acpi/Makefile
Signed-off-by: NLen Brown <len.brown@intel.com>

Conflicts:
	drivers/acpi/video.c
Signed-off-by: NLen Brown <len.brown@intel.com>

The battery driver tends to take quite some time to initialize
(100ms-300ms is quite typical).
This patch initializes the batter driver asynchronously, so that other
things in the kernel can initialize in parallel to this 300 msec.

As part of this, the battery driver had to move to the back
of the ACPI init order (hence the Makefile change).
Without this move, the next ACPI driver would just block
on the ACPI/devicee layer semaphores until the battery driver was
done anyway, not gaining any boot time.
Signed-off-by: NArjan van de Ven <arjan@linux.intel.com>
Signed-off-by: NLen Brown <len.brown@intel.com>

Explicitly note in the documentation that the Acer Aspire One is not
supported.
Signed-off-by: NCarlos Corbacho <carlos@strangeworlds.co.uk>
Signed-off-by: NLen Brown <len.brown@intel.com>

Cleanup the failure cleanup handling for brightness and email led.

[cc: Split out from another patch]
Signed-off-by: NAndy Whitcroft <apw@canonical.com>
Signed-off-by: NCarlos Corbacho <carlos@strangeworlds.co.uk>
Signed-off-by: NLen Brown <len.brown@intel.com>

The Aspire One's ACPI-WMI interface is a placeholder that does nothing,
and the invalid results that we get from it are now causing userspace
problems as acer-wmi always returns that the rfkill is enabled (i.e. the
radio is off, when it isn't). As it's hardware controlled, acer-wmi
isn't needed on the Aspire One either.

Thanks to Andy Whitcroft at Canonical for tracking down Ubuntu's userspace
issues to this.
Signed-off-by: NCarlos Corbacho <carlos@strangeworlds.co.uk>
Reported-by: NAndy Whitcroft <apw@canonical.com>
Cc: stable@kernel.org
Signed-off-by: NLen Brown <len.brown@intel.com>

acpi_video_device_write_state() and friends now return ssize_t,
while the constify patch assumed it was still int.
Signed-off-by: NLen Brown <len.brown@intel.com>

Refactor and redesign the brightness control backend...

In order to fix bugzilla #11750...

Add a new brightness control mode: support direct NVRAM checkpointing
of the backlight level (i.e. store directly to NVRAM without the need
for UCMS calls), and use that together with the EC-based control.
Disallow UCMS+EC, thus avoiding races with the SMM firmware.

Switch the models that define HBRV (EC Brightness Value) in the DSDT
to the new mode.  These are: T40-T43, R50-R52, R50e, R51e, X31-X41.

Change the default for all other IBM ThinkPads to UCMS-only.  The
Lenovo models already default to UCMS-only.
Reported-by: NAlexey Fisher <bug-track@fisher-privat.net>
Signed-off-by: NHenrique de Moraes Holschuh <hmh@hmh.eng.br>
Signed-off-by: NLen Brown <len.brown@intel.com>

Enhance debugging messages for the fan subdriver.
Signed-off-by: NHenrique de Moraes Holschuh <hmh@hmh.eng.br>
Signed-off-by: NLen Brown <len.brown@intel.com>

Enhance debugging messages for the hotkey subdriver.
Signed-off-by: NHenrique de Moraes Holschuh <hmh@hmh.eng.br>
Signed-off-by: NLen Brown <len.brown@intel.com>

Enhance debugging messages for all rfkill subdrivers in thinkpad-acpi.

Also, log a warning if the deprecated sysfs attributes are in use.
These attributes are going to be removed sometime in 2010.

There is an user-visible side-effect: we now coalesce attempts to
enable/disable bluetooth or WWAN in the procfs interface, instead of
hammering the firmware with multiple requests.
Signed-off-by: NHenrique de Moraes Holschuh <hmh@hmh.eng.br>
Signed-off-by: NLen Brown <len.brown@intel.com>

Some of the ThinkPad LEDs indicate critical conditions that can cause
data loss or cause hardware damage when ignored (e.g. force-ejecting
a powered up bay; ignoring a failing battery, or empty battery; force-
undocking with the dock buses still active, etc).

On almost all ThinkPads, LED access is write-only, and the firmware
usually does fire-and-forget signaling on them, so you effectively
lose whatever message the firmware was trying to convey to the user
when you override the LED state, without any chance to restore it.

Restrict access to all LEDs that can convey important alarms, or that
could mislead the user into incorrectly operating the hardware.  This
will make the Lenovo engineers less unhappy about the whole issue.

Allow users that really want it to still control all LEDs, it is the
unaware user that we have to worry about.
Signed-off-by: NHenrique de Moraes Holschuh <hmh@hmh.eng.br>
Signed-off-by: NLen Brown <len.brown@intel.com>

The HKEY disable functionality basically cripples the entire event
model of the ThinkPad firmware and of the thinkpad-acpi driver.
Remove this functionality from the driver.  HKEY must be enabled at
all times while thinkpad-acpi is loaded, and disabled otherwise.

For sysfs, according to the sysfs ABI and the thinkpad-acpi sysfs
rules of engagement, we will just remove the attributes.  This will be
done in two stages: disable their function now, after two kernel
releases, remove the attributes.

For procfs, we call WARN().  If nothing triggers it, I will simply
remove the enable/disable commands entirely in the future along with
the sysfs attributes.

I don't expect much, if any fallout from this.  There really isn't any
reason to mess with hotkey_enable or with the enable/disable commands
to /proc/acpi/ibm/hotkey, and this has been true for years...
Signed-off-by: NHenrique de Moraes Holschuh <hmh@hmh.eng.br>
Signed-off-by: NLen Brown <len.brown@intel.com>

Add a debug helper that discloses the TGID of the userspace task
attempting to access the driver.  This is highly useful when dealing
with bug reports, since often the user has no idea that some userspace
application is accessing thinkpad-acpi...

Also add a helper to log warnings about sysfs attributes that are
deprecated.

Use the new helpers to issue deprecation warnings for bluetooth_enable
and wwan_enabled, that have been deprecated for a while, now.
Signed-off-by: NHenrique de Moraes Holschuh <hmh@hmh.eng.br>
Signed-off-by: NLen Brown <len.brown@intel.com>

Add missing log levels in a standalone commit, to avoid dependencies in
future unrelated changes, just because they wanted to use one of the
missing log levels.
Signed-off-by: NHenrique de Moraes Holschuh <hmh@hmh.eng.br>
Signed-off-by: NLen Brown <len.brown@intel.com>

Fix the vdbg_printk macro definition to be sane when
CONFIG_THINKPAD_ACPI_DEBUG is undefined, and move the mess into a file
section of its own.

This doesn't change anything in the current code, but future code will
need the proper behaviour.
Signed-off-by: NHenrique de Moraes Holschuh <hmh@hmh.eng.br>
Signed-off-by: NLen Brown <len.brown@intel.com>

Some cleanups to the documentation of the driver.
Signed-off-by: NHenrique de Moraes Holschuh <hmh@hmh.eng.br>
Signed-off-by: NLen Brown <len.brown@intel.com>

The driver was renamed two years ago, on 2.6.21.  Drop the old
compatibility alias, we have given everybody quite enough time
to update their configs to the new name.
Signed-off-by: NHenrique de Moraes Holschuh <hmh@hmh.eng.br>
Signed-off-by: NLen Brown <len.brown@intel.com>

It is that time of the year again...
Signed-off-by: NHenrique de Moraes Holschuh <hmh@hmh.eng.br>
Signed-off-by: NLen Brown <len.brown@intel.com>

Signed-off-by: NJan Engelhardt <jengelh@medozas.de>
Signed-off-by: NLen Brown <len.brown@intel.com>

Signed-off-by: NJan Engelhardt <jengelh@medozas.de>
Signed-off-by: NLen Brown <len.brown@intel.com>

Add a WMI driver for Dell laptops. Currently it does nothing but send a
generic input event when a button with a picture of a battery on it is
pressed, but maybe other uses will appear over time.
Signed-off-by: NMatthew Garrett <mjg@redhat.com>
Cc: Dmitry Torokhov <dtor@mail.ru>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLen Brown <len.brown@intel.com>

In short Fn key events are always reported through acpi.
The input layer gets all the old style events and only those new style
events that, after being decoded, are mapped to an locally represented
events.
rfkill only update the rfkill device status.
Signed-off-by: NMatthias Welwarsky <matze@welwarsky.de>
Signed-off-by: NMattia Dongili <malattia@linux.it>
Signed-off-by: NLen Brown <len.brown@intel.com>