There is no general support for 64-bit big endian accesses, so that is
left unsupported.
Signed-off-by: NAndreas Larsson <andreas@gaisler.com>
Acked-by: NAnton Vorontsov <anton@enomsg.org>
Signed-off-by: NLinus Walleij <linus.walleij@linaro.org>

CONFIG_HOTPLUG is going away as an option so __devexit is no
longer needed.
Signed-off-by: NBill Pemberton <wfp5p@virginia.edu>
Cc: Grant Likely <grant.likely@secretlab.ca>
Acked-by: NLinus Walleij <linus.walleij@linaro.org>
Cc: Peter Tyser <ptyser@xes-inc.com>
Acked-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

CONFIG_HOTPLUG is going away as an option so __devinit is no longer
needed.
Signed-off-by: NBill Pemberton <wfp5p@virginia.edu>
Cc: Grant Likely <grant.likely@secretlab.ca>
Cc: Peter Tyser <ptyser@xes-inc.com>
Cc: Santosh Shilimkar <santosh.shilimkar@ti.com>
Cc: Kevin Hilman <khilman@ti.com>
Acked-by: NLinus Walleij <linus.walleij@linaro.org>
Acked-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

CONFIG_HOTPLUG is going away as an option so __devexit_p is no longer
needed.
Signed-off-by: NBill Pemberton <wfp5p@virginia.edu>
Cc: Grant Likely <grant.likely@secretlab.ca>
Cc: Peter Tyser <ptyser@xes-inc.com>
Acked-by: NLinus Walleij <linus.walleij@linaro.org>
Acked-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

It fixes the issue in gpio-generic that commit fb149218 (gpio/mxc: add
missing initialization of basic_mmio_gpio shadow variables) manged to
fix in gpio-mxc driver, so that other platform specific drivers do not
suffer from the same problem over and over again.

Changes since v1:
* Turn the last parameter of bgpio_init() "bool big_endian" into
  "unsigned long flags" and give those really quirky hardwares a
  chance to tell that reg_set and reg_dir are unreadable.
Signed-off-by: NShawn Guo <shawn.guo@linaro.org>
[grant.likely: Fix big-endian usage to explicitly set BBGPIOF_BIG_ENDIAN]
Signed-off-by: NGrant Likely <grant.likely@secretlab.ca>

Where appropriate factor out some boilerplate code for platform device
registration into module_platform_driver. Drivers that don't use the
standard module_init initcall haven't been converted.
Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NGrant Likely <grant.likely@secretlab.ca>

Building a kernel with hotplug disabled results in a link failure:

  `bgpio_remove' referenced in section `___ksymtab_gpl+bgpio_remove' of drivers/built-in.o: defined in discarded section `.devexit.text' of drivers/built-in.o

This is because of bgpio_remove() is exported.  It is illegal to export
symbols which are discarded either at link time or as part of an
init/exit section.

Fix this by dropping the __devexit attributation from bgpio_remove().
Also drop the __devinit attributation from bgpio_init().
Signed-off-by: NRussell King <rmk+kernel@arm.linux.org.uk>
Cc: Grant Likely <grant.likely@secretlab.ca>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

Sort the gpio makefile and enforce the naming convention gpio-*.c for
gpio drivers.

v2: cleaned up filenames in Kconfig and comment blocks
v3: fixup use of BASIC_MMIO to GENERIC_GPIO for mxc
Signed-off-by: NGrant Likely <grant.likely@secretlab.ca>

Allow GPIO_BASIC_MMIO_CORE to be used to provide an accessor library
for implementing GPIO drivers whilst abstracting the register access
detail.  Based on a patch from Anton Vorontsov[1] and adapted to allow
bgpio_chip to be embedded in another structure.

Changes since v1:
	- Register the gpio_chip in the platform device probe

1. https://lkml.org/lkml/2011/4/19/401Signed-off-by: NAnton Vorontsov <cbouatmailru@gmail.com>
Signed-off-by: NJamie Iles <jamie@jamieiles.com>
Signed-off-by: NGrant Likely <grant.likely@secretlab.ca>

The __raw_* accessors don't include memory barriers and can cause
problems when writes get stuck in write buffers.
Suggested-by: NLinus Walleij <linus.walleij@linaro.org>
Acked-by: NAnton Vorontsov <cbouatmailru@gmail.com>
Signed-off-by: NJamie Iles <jamie@jamieiles.com>
Signed-off-by: NGrant Likely <grant.likely@secretlab.ca>

Most controllers require the direction of a GPIO to be set by writing to
a direction register.  Add support for either an input direction
register or an output direction register.
Signed-off-by: NJamie Iles <jamie@jamieiles.com>
Acked-by: NAnton Vorontsov <cbouatmailru@gmail.com>
Signed-off-by: NGrant Likely <grant.likely@secretlab.ca>

Some controllers have separate input and output registers.  For these
controllers, use "set" for the output and "dat" for the input.

Changes since v2: reuse "set" for output and "dat" for input rather than
adding a new "in" register.
Signed-off-by: NJamie Iles <jamie@jamieiles.com>
Acked-by: NAnton Vorontsov <cbouatmailru@gmail.com>
Signed-off-by: NGrant Likely <grant.likely@secretlab.ca>

Rather than detecting the output method each time in the .set()
callback, do it at probe time and set the appropriate callback.

Changes since v2: moved the reg_dat initialization into
bgpio_setup_io().
Signed-off-by: NJamie Iles <jamie@jamieiles.com>
Acked-by: NAnton Vorontsov <cbouatmailru@gmail.com>
Signed-off-by: NGrant Likely <grant.likely@secretlab.ca>

Make sure that we get the register regions with request_mem_region()
before ioremap() to make sure we have exclusive access.
Signed-off-by: NJamie Iles <jamie@jamieiles.com>
Acked-by: NAnton Vorontsov <cbouatmailru@gmail.com>
Signed-off-by: NGrant Likely <grant.likely@secretlab.ca>

Some platforms may have a number of GPIO that is less than the register
width of the peripheral.
Signed-off-by: NJamie Iles <jamie@jamieiles.com>
Acked-by: NAnton Vorontsov <cbouatmailru@gmail.com>
Signed-off-by: NGrant Likely <grant.likely@secretlab.ca>

Use the platform drvdata helpers rather than working on the struct
device itself.
Signed-off-by: NJamie Iles <jamie@jamieiles.com>
Acked-by: NAnton Vorontsov <cbouatmailru@gmail.com>
Signed-off-by: NGrant Likely <grant.likely@secretlab.ca>

Remove endianness/width calculations at runtime by installing function
pointers for bit-to-mask conversion and register accessors.
Reported-by: NThomas Gleixner <tglx@linutronix.de>
Signed-off-by: NJamie Iles <jamie@jamieiles.com>
Acked-by: NAnton Vorontsov <cbouatmailru@gmail.com>
Signed-off-by: NGrant Likely <grant.likely@secretlab.ca>

The basic GPIO controllers may be found in various on-board FPGA and ASIC
solutions that are used to control board's switches, LEDs, chip-selects,
Ethernet/USB PHY power, etc.

These controllers may not provide any means of pin setup
(in/out/open drain).

The driver supports:
- 8/16/32/64 bits registers;
- GPIO controllers with clear/set registers;
- GPIO controllers with a single "data" register;
- Big endian bits/GPIOs ordering (mostly used on PowerPC).
Signed-off-by: NAnton Vorontsov <cbouatmailru@gmail.com>
Reviewed-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Cc: David Brownell <david-b@pacbell.net>
Cc: Samuel Ortiz <sameo@linux.intel.com>,
Cc: Alan Cox <alan@lxorguk.ukuu.org.uk>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>