Skip to content

cloud-kernel
cloud-kernel

openanolis / cloud-kernel
接近 2 年 前同步成功

通知 170
Star 36
Fork 7
cloud-kernel
cloud-kernel
切换分支/标签
  1. 29 5月, 2018 4 次提交
  3. 12 4月, 2018 1 次提交
  5. 31 3月, 2018 3 次提交
  7. 26 3月, 2018 3 次提交
  9. 22 1月, 2018 13 次提交
  11. 07 1月, 2018 1 次提交
  13. 16 11月, 2017 1 次提交
    • F
      Btrfs: fix reported number of inode blocks after buffered append writes · e3b8a485
      由 Filipe Manana 提交于 
      The patch from commit a7e3b975 ("Btrfs: fix reported number of inode
blocks") introduced a regression where if we do a buffered write starting
at position equal to or greater than the file's size and then stat(2) the
file before writeback is triggered, the number of used blocks does not
change (unless there's a prealloc/unwritten extent). Example:

  $ xfs_io -f -c "pwrite -S 0xab 0 64K" foobar
  $ du -h foobar
  0	foobar
  $ sync
  $ du -h foobar
  64K	foobar

The first version of that patch didn't had this regression and the second
version, which was the one committed, was made only to address some
performance regression detected by the intel test robots using fs_mark.

This fixes the regression by setting the new delaloc bit in the range, and
doing it at btrfs_dirty_pages() while setting the regular dealloc bit as
well, so that this way we set both bits at once avoiding navigation of the
inode's io tree twice. Doing it at btrfs_dirty_pages() is also the most
meaninful place, as we should set the new dellaloc bit when if we set the
delalloc bit, which happens only if we copied bytes into the pages at
__btrfs_buffered_write().

This was making some of LTP's du tests fail, which can be quickly run
using a command line like the following:

  $ ./runltp -q -p -l /ltp.log -f commands -s du -d /mnt

Fixes: a7e3b975 ("Btrfs: fix reported number of inode blocks")
Signed-off-by: NFilipe Manana <fdmanana@suse.com>
Signed-off-by: NDavid Sterba <dsterba@suse.com>
      e3b8a485
  15. 15 11月, 2017 1 次提交
    • L
      Btrfs: add write_flags for compression bio · f82b7359
      由 Liu Bo 提交于 
      Compression code path has only flaged bios with REQ_OP_WRITE no matter
where the bios come from, but it could be a sync write if fsync starts
this writeback or a normal writeback write if wb kthread starts a
periodic writeback.

It breaks the rule that sync writes and writeback writes need to be
differentiated from each other, because from the POV of block layer,
all bios need to be recognized by these flags in order to do some
management, e.g. throttlling.

This passes writeback_control to compression write path so that it can
send bios with proper flags to block layer.
Signed-off-by: NLiu Bo <bo.li.liu@oracle.com>
Reviewed-by: NDavid Sterba <dsterba@suse.com>
Signed-off-by: NDavid Sterba <dsterba@suse.com>
      f82b7359
  17. 02 11月, 2017 1 次提交
    • G
      License cleanup: add SPDX GPL-2.0 license identifier to files with no license · b2441318
      由 Greg Kroah-Hartman 提交于 
      Many source files in the tree are missing licensing information, which
makes it harder for compliance tools to determine the correct license.

By default all files without license information are under the default
license of the kernel, which is GPL version 2.

Update the files which contain no license information with the 'GPL-2.0'
SPDX license identifier.  The SPDX identifier is a legally binding
shorthand, which can be used instead of the full boiler plate text.

This patch is based on work done by Thomas Gleixner and Kate Stewart and
Philippe Ombredanne.

How this work was done:

Patches were generated and checked against linux-4.14-rc6 for a subset of
the use cases:
 - file had no licensing information it it.
 - file was a */uapi/* one with no licensing information in it,
 - file was a */uapi/* one with existing licensing information,

Further patches will be generated in subsequent months to fix up cases
where non-standard license headers were used, and references to license
had to be inferred by heuristics based on keywords.

The analysis to determine which SPDX License Identifier to be applied to
a file was done in a spreadsheet of side by side results from of the
output of two independent scanners (ScanCode & Windriver) producing SPDX
tag:value files created by Philippe Ombredanne.  Philippe prepared the
base worksheet, and did an initial spot review of a few 1000 files.

The 4.13 kernel was the starting point of the analysis with 60,537 files
assessed.  Kate Stewart did a file by file comparison of the scanner
results in the spreadsheet to determine which SPDX license identifier(s)
to be applied to the file. She confirmed any determination that was not
immediately clear with lawyers working with the Linux Foundation.

Criteria used to select files for SPDX license identifier tagging was:
 - Files considered eligible had to be source code files.
 - Make and config files were included as candidates if they contained >5
   lines of source
 - File already had some variant of a license header in it (even if <5
   lines).

All documentation files were explicitly excluded.

The following heuristics were used to determine which SPDX license
identifiers to apply.

 - when both scanners couldn't find any license traces, file was
   considered to have no license information in it, and the top level
   COPYING file license applied.

   For non */uapi/* files that summary was:

   SPDX license identifier                            # files
   ---------------------------------------------------|-------
   GPL-2.0                                              11139

   and resulted in the first patch in this series.

   If that file was a */uapi/* path one, it was "GPL-2.0 WITH
   Linux-syscall-note" otherwise it was "GPL-2.0".  Results of that was:

   SPDX license identifier                            # files
   ---------------------------------------------------|-------
   GPL-2.0 WITH Linux-syscall-note                        930

   and resulted in the second patch in this series.

 - if a file had some form of licensing information in it, and was one
   of the */uapi/* ones, it was denoted with the Linux-syscall-note if
   any GPL family license was found in the file or had no licensing in
   it (per prior point).  Results summary:

   SPDX license identifier                            # files
   ---------------------------------------------------|------
   GPL-2.0 WITH Linux-syscall-note                       270
   GPL-2.0+ WITH Linux-syscall-note                      169
   ((GPL-2.0 WITH Linux-syscall-note) OR BSD-2-Clause)    21
   ((GPL-2.0 WITH Linux-syscall-note) OR BSD-3-Clause)    17
   LGPL-2.1+ WITH Linux-syscall-note                      15
   GPL-1.0+ WITH Linux-syscall-note                       14
   ((GPL-2.0+ WITH Linux-syscall-note) OR BSD-3-Clause)    5
   LGPL-2.0+ WITH Linux-syscall-note                       4
   LGPL-2.1 WITH Linux-syscall-note                        3
   ((GPL-2.0 WITH Linux-syscall-note) OR MIT)              3
   ((GPL-2.0 WITH Linux-syscall-note) AND MIT)             1

   and that resulted in the third patch in this series.

 - when the two scanners agreed on the detected license(s), that became
   the concluded license(s).

 - when there was disagreement between the two scanners (one detected a
   license but the other didn't, or they both detected different
   licenses) a manual inspection of the file occurred.

 - In most cases a manual inspection of the information in the file
   resulted in a clear resolution of the license that should apply (and
   which scanner probably needed to revisit its heuristics).

 - When it was not immediately clear, the license identifier was
   confirmed with lawyers working with the Linux Foundation.

 - If there was any question as to the appropriate license identifier,
   the file was flagged for further research and to be revisited later
   in time.

In total, over 70 hours of logged manual review was done on the
spreadsheet to determine the SPDX license identifiers to apply to the
source files by Kate, Philippe, Thomas and, in some cases, confirmation
by lawyers working with the Linux Foundation.

Kate also obtained a third independent scan of the 4.13 code base from
FOSSology, and compared selected files where the other two scanners
disagreed against that SPDX file, to see if there was new insights.  The
Windriver scanner is based on an older version of FOSSology in part, so
they are related.

Thomas did random spot checks in about 500 files from the spreadsheets
for the uapi headers and agreed with SPDX license identifier in the
files he inspected. For the non-uapi files Thomas did random spot checks
in about 15000 files.

In initial set of patches against 4.14-rc6, 3 files were found to have
copy/paste license identifier errors, and have been fixed to reflect the
correct identifier.

Additionally Philippe spent 10 hours this week doing a detailed manual
inspection and review of the 12,461 patched files from the initial patch
version early this week with:
 - a full scancode scan run, collecting the matched texts, detected
   license ids and scores
 - reviewing anything where there was a license detected (about 500+
   files) to ensure that the applied SPDX license was correct
 - reviewing anything where there was no detection but the patch license
   was not GPL-2.0 WITH Linux-syscall-note to ensure that the applied
   SPDX license was correct

This produced a worksheet with 20 files needing minor correction.  This
worksheet was then exported into 3 different .csv files for the
different types of files to be modified.

These .csv files were then reviewed by Greg.  Thomas wrote a script to
parse the csv files and add the proper SPDX tag to the file, in the
format that the file expected.  This script was further refined by Greg
based on the output to detect more types of files automatically and to
distinguish between header and source .c files (which need different
comment types.)  Finally Greg ran the script using the .csv files to
generate the patches.
Reviewed-by: NKate Stewart <kstewart@linuxfoundation.org>
Reviewed-by: NPhilippe Ombredanne <pombredanne@nexb.com>
Reviewed-by: NThomas Gleixner <tglx@linutronix.de>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>
      b2441318
  19. 30 10月, 2017 1 次提交
    • L
      Btrfs: remove bio_flags which indicates a meta block of log-tree · 18fdc679
      由 Liu Bo 提交于 
      Since both committing transaction and writing log-tree are doing
plugging on metadata IO, we can unify to use %sync_writers to benefit
both cases, instead of checking bio_flags while writing meta blocks of
log-tree.

We can remove this bio_flags because in order to write dirty blocks,
log tree also uses btrfs_write_marked_extents(), inside which we
have enabled %sync_writers, therefore, every write goes in a
synchronous way, so does checksuming.

Please also note that, bio_flags is applied per-context while
%sync_writers is applied per-inode, so this might incur some overhead, ie.

1) while log tree is flushing its dirty blocks via
   btrfs_write_marked_extents(), in which %sync_writers is increased
   by one.

2) in the meantime, some writeback operations may happen upon btrfs's
   metadata inode, so these writes go synchronously, too.

However, AFAICS, the overhead is not a big one while the win is that
we unify the two places that needs synchronous way and remove a
special hack/flag.

This removes the bio_flags related stuff for writing log-tree.
Signed-off-by: NLiu Bo <bo.li.liu@oracle.com>
Reviewed-by: NDavid Sterba <dsterba@suse.com>
Signed-off-by: NDavid Sterba <dsterba@suse.com>
      18fdc679
  21. 16 8月, 2017 1 次提交
    • J
      btrfs: struct-funcs, constify readers · 1cbb1f45
      由 Jeff Mahoney 提交于 
      We have reader helpers for most of the on-disk structures that use
an extent_buffer and pointer as offset into the buffer that are
read-only.  We should mark them as const and, in turn, allow consumers
of these interfaces to mark the buffers const as well.

No impact on code, but serves as documentation that a buffer is intended
not to be modified.
Signed-off-by: NJeff Mahoney <jeffm@suse.com>
Signed-off-by: NDavid Sterba <dsterba@suse.com>
      1cbb1f45
  23. 15 7月, 2017 1 次提交
  25. 30 6月, 2017 2 次提交
  27. 20 6月, 2017 7 次提交