1. 10 1月, 2006 1 次提交
  2. 08 1月, 2006 2 次提交
  3. 06 1月, 2006 1 次提交
  4. 15 12月, 2005 1 次提交
  5. 30 11月, 2005 1 次提交
  6. 11 11月, 2005 1 次提交
    • H
      [NET]: Detect hardware rx checksum faults correctly · fb286bb2
      Herbert Xu 提交于
      Here is the patch that introduces the generic skb_checksum_complete
      which also checks for hardware RX checksum faults.  If that happens,
      it'll call netdev_rx_csum_fault which currently prints out a stack
      trace with the device name.  In future it can turn off RX checksum.
      
      I've converted every spot under net/ that does RX checksum checks to
      use skb_checksum_complete or __skb_checksum_complete with the
      exceptions of:
      
      * Those places where checksums are done bit by bit.  These will call
      netdev_rx_csum_fault directly.
      
      * The following have not been completely checked/converted:
      
      ipmr
      ip_vs
      netfilter
      dccp
      
      This patch is based on patches and suggestions from Stephen Hemminger
      and David S. Miller.
      Signed-off-by: NHerbert Xu <herbert@gondor.apana.org.au>
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      fb286bb2
  7. 04 10月, 2005 1 次提交
    • H
      [IPV4]: Replace __in_dev_get with __in_dev_get_rcu/rtnl · e5ed6399
      Herbert Xu 提交于
      The following patch renames __in_dev_get() to __in_dev_get_rtnl() and
      introduces __in_dev_get_rcu() to cover the second case.
      
      1) RCU with refcnt should use in_dev_get().
      2) RCU without refcnt should use __in_dev_get_rcu().
      3) All others must hold RTNL and use __in_dev_get_rtnl().
      
      There is one exception in net/ipv4/route.c which is in fact a pre-existing
      race condition.  I've marked it as such so that we remember to fix it.
      
      This patch is based on suggestions and prior work by Suzanne Wood and
      Paul McKenney.
      Signed-off-by: NHerbert Xu <herbert@gondor.apana.org.au>
      Signed-off-by: NDavid S. Miller <davem@davemloft.net>
      e5ed6399
  8. 31 7月, 2005 1 次提交
  9. 17 4月, 2005 1 次提交
    • L
      Linux-2.6.12-rc2 · 1da177e4
      Linus Torvalds 提交于
      Initial git repository build. I'm not bothering with the full history,
      even though we have it. We can create a separate "historical" git
      archive of that later if we want to, and in the meantime it's about
      3.2GB when imported into git - space that would just make the early
      git days unnecessarily complicated, when we don't have a lot of good
      infrastructure for it.
      
      Let it rip!
      1da177e4