TPS65910 can be used without interrupts.
Hence let probe succeed in case interrupt can't be
configured and let Kernel only to complain about it
Signed-off-by: NAfzal Mohammed <afzal@ti.com>
Signed-off-by: NSamuel Ortiz <sameo@linux.intel.com>

The function is not actually cleaing the bitmask.
Signed-off-by: NMarcus Folkesson <marcus.folkesson@gmail.com>
Signed-off-by: NSamuel Ortiz <sameo@linux.intel.com>

In drivers/mfd/tps65910.c:tps65910_i2c_probe() there's potential for a
tiny optimization.

We assign to init_data->irq and init_data->irq_base long before we
need them, and there are two potential exits from the function before
they are needed.

Moving the assignments below these two potential exits means we
completely avoid doing them in these two (failure) cases.
Signed-off-by: NJesper Juhl <jj@chaosbits.net>
Acked-by: NGraeme Gregory <gg@slimlogic.co.uk>
Signed-off-by: NSamuel Ortiz <sameo@linux.intel.com>

There are a couple of situations where we leak init_data in
drivers/mfd/tps65910.c:tps65910_i2c_probe() - this patch should take
care of them.
Signed-off-by: NJesper Juhl <jj@chaosbits.net>
Signed-off-by: NSamuel Ortiz <sameo@linux.intel.com>

The tps65910_irq_exit() cleanup function was generating a warning from
sparse due to the lack of a prototype. This wasn't causing GCC warnings
as the driver wasn't cleaning up its IRQs on exit at all so there was no
use of an unprototyped function.
Signed-off-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: NSamuel Ortiz <sameo@linux.intel.com>

The TPS65911 is the next generation of the TPS65910 family of
PMIC chips. It adds a few features:

- Watchdog Timer
- PWM & LED generators
- Comparators for system control status

It also adds a set of Interrupts and GPIOs, among other things.

The driver exports a function to identify between different
versions of the tps65910 family, allowing other modules to
identify the capabilities of the current chip.
Signed-off-by: NJorge Eduardo Candelaria <jedu@slimlogic.co.uk>
Acked-by: NSamuel Ortiz <sameo@linux.intel.com>
Signed-off-by: NLiam Girdwood <lrg@slimlogic.co.uk>

If bytes == (TPS65910_MAX_REGISTER + 1), we have a buffer overflow when
doing memcpy(&msg[1], src, bytes).
Signed-off-by: NAxel Lin <axel.lin@gmail.com>
Acked-by: NSamuel Ortiz <sameo@linux.intel.com>
Signed-off-by: NLiam Girdwood <lrg@slimlogic.co.uk>

This module controls the interrupt handling for the tps chip. The
interrupt sources are the following:

- GPIO falling/rising edge detection
- Battery voltage below/above threshold
- PWRON signal
- PWRHOLD signal
- Temperature detection
- RTC alarm and periodic event
Signed-off-by: NGraeme Gregory <gg@slimlogic.co.uk>
Signed-off-by: NJorge Eduardo Candelaria <jedu@slimlogic.co.uk>
Reviewed-by: NMark Brown <broonie@opensource.wolfsonmicro.com>
Acked-by: NSamuel Ortiz <sameo@linux.intel.com>
Signed-off-by: NLiam Girdwood <lrg@slimlogic.co.uk>

TPS65910 has one configurable GPIO that can be used for several
purposes. Subsequent versions of the TPS chip support more than
one GPIO.
Signed-off-by: NGraeme Gregory <gg@slimlogic.co.uk>
Signed-off-by: NJorge Eduardo Candelaria <jedu@slimlogic.co.uk>
Acked-by: NGrant Likely <grant.likely@secretlab.ca>
Signed-off-by: NLiam Girdwood <lrg@slimlogic.co.uk>

The TPS65910 chip is a power management IC for multimedia and handheld
devices. It contains the following components:

- Regulators
- GPIO controller
- RTC

The tps65910 core driver is registered as a platform driver and provides
communication through I2C with the host device for the different
components.
Signed-off-by: NGraeme Gregory <gg@slimlogic.co.uk>
Signed-off-by: NJorge Eduardo Candelaria <jedu@slimlogic.co.uk>
Acked-by: NSamuel Ortiz <sameo@linux.intel.com>
Signed-off-by: NLiam Girdwood <lrg@slimlogic.co.uk>