Calculating rx_bad as rx_packets - rx_good is unnecessary and
incorrect, since rx_good does not include control frames (e.g.
pause frames) and rx_packets does.
Signed-off-by: NBen Hutchings <bhutchings@solarflare.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Conflicts:
	net/mac80211/main.c

Replace sizeof(bnx2x_parity_mask)/(sizeof(bnx2x_parity_mask[0]) with
ARRAY_SIZE(bnx2x_parity_mask) in drivers/net/bnx2x/bnx2x_main.c
Signed-off-by: NNikitas Angelinas <nikitasangelinas@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

The 'wwan' devtype is meant for devices that require preconfiguration
and *every* time setup before the ethernet interface can be used, like
cellular modems which require a series of setup commands on serial ports
or other mechanisms before the ethernet interface will handle packets.

As ipheth only requires one-per-hotplug pairing setup with no
preconfiguration (like APN, phone #, etc) and the network interface is
usable at any time after that initial setup, remove the incorrect
devtype wwan.
Signed-off-by: NDan Williams <dcbw@redhat.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NJoe Perches <joe@perches.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NFlorian Fainelli <florian@openwrt.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Remove all the volatile keywords where they were used, switch to using the
proper readl/writel accessors.
Signed-off-by: NFlorian Fainelli <florian@openwrt.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Replace asm/io.h and asm/cpu.h wih linux/io.h and linux/cpu.h
Signed-off-by: NFlorian Fainelli <florian@openwrt.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Use pr_(info|err) and pr_cont where required instead of calls to printk.
Add missing pr_fmt to the driver.
Signed-off-by: NFlorian Fainelli <florian@openwrt.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

One line has not been changed because it would not improve readability.
Signed-off-by: NFlorian Fainelli <florian@openwrt.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

This patch fixes the following checkpatch.pl warnings:
- spaces after tabs
- space between function and arguments
- one-line statement braces
- tabs instead of spaces
Signed-off-by: NFlorian Fainelli <florian@openwrt.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NFlorian Fainelli <florian@openwrt.org>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Remove code that trimmed excess trailing info from incoming messages
arriving over an Ethernet interface.  TIPC now ignores the extra info
while the message is being processed by the node, and only trims it off
if the message is retransmitted to another node.  (This latter step is
done to ensure the extra info doesn't cause the sk_buff to exceed the
outgoing interface's MTU limit.) The outgoing buffer is guaranteed to
be linear.
Signed-off-by: NAllan Stephens <allan.stephens@windriver.com>
Signed-off-by: NPaul Gortmaker <paul.gortmaker@windriver.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Use the net_device provided net_device_stats structure.

Remove ixgbevf_get_stats() now its not needed.
Signed-off-by: NEric Dumazet <eric.dumazet@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

xfrm4_tunnel_register() & xfrm6_tunnel_register() should
use rcu_assign_pointer() to make sure previous writes
(to handler->next) are committed to memory before chain
insertion.

deregister functions dont need a particular barrier.
Signed-off-by: NEric Dumazet <eric.dumazet@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

__lock_sock() and __release_sock() releases and regrabs lock but
were missing proper annotations. Add it. This removes following
warning from sparse. (Currently __lock_sock() does not emit any
warning about it but I think it is better to add also.)

 net/core/sock.c:1580:17: warning: context imbalance in '__release_sock' - unexpected unlock
Signed-off-by: NNamhyung Kim <namhyung@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

move_addr_to_kernel() and copy_from_user() requires their argument
as __user pointer but were missing proper markups. Add it.
This removes following warnings from sparse.

 net/core/iovec.c:44:52: warning: incorrect type in argument 1 (different address spaces)
 net/core/iovec.c:44:52:    expected void [noderef] <asn:1>*uaddr
 net/core/iovec.c:44:52:    got void *msg_name
 net/core/iovec.c:55:34: warning: incorrect type in argument 2 (different address spaces)
 net/core/iovec.c:55:34:    expected void const [noderef] <asn:1>*from
 net/core/iovec.c:55:34:    got struct iovec *msg_iov
Signed-off-by: NNamhyung Kim <namhyung@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Add a list_has_sctp_addr function to simplify loop

Based on a patches by Dan Carpenter and David Miller
Signed-off-by: NJoe Perches <joe@perches.com>
Acked-by: NVlad Yasevich <vladislav.yasevich@hp.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Use netdev_alloc_skb_ip_align() helper and do correct allocation
Tested-by: NAbraham Arce <x0066660@ti.com>
Signed-off-by: NAbraham Arce <x0066660@ti.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

commit 30fff923 introduced in linux-2.6.33 (udp: bind() optimisation)
added a secondary hash on UDP, hashed on (local addr, local port).

Problem is that following sequence :

fd = socket(...)
connect(fd, &remote, ...)

not only selects remote end point (address and port), but also sets
local address, while UDP stack stored in secondary hash table the socket
while its local address was INADDR_ANY (or ipv6 equivalent)

Sequence is :
 - autobind() : choose a random local port, insert socket in hash tables
              [while local address is INADDR_ANY]
 - connect() : set remote address and port, change local address to IP
              given by a route lookup.

When an incoming UDP frame comes, if more than 10 sockets are found in
primary hash table, we switch to secondary table, and fail to find
socket because its local address changed.

One solution to this problem is to rehash datagram socket if needed.

We add a new rehash(struct socket *) method in "struct proto", and
implement this method for UDP v4 & v6, using a common helper.

This rehashing only takes care of secondary hash table, since primary
hash (based on local port only) is not changed.
Reported-by: NKrzysztof Piotr Oledzki <ole@ans.pl>
Signed-off-by: NEric Dumazet <eric.dumazet@gmail.com>
Tested-by: NKrzysztof Piotr Oledzki <ole@ans.pl>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Acked-by: NChris Snook <chris.snook@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Use cmpxchg() to get rid of spinlocks in inet_add_protocol() and
friends.

inet_protos[] & inet6_protos[] are moved to read_mostly section
Signed-off-by: NEric Dumazet <eric.dumazet@gmail.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

Ignore ADSL routers, which can have the same vendor and product IDs
as ADSL modems but should be handled by the cx82310_eth driver.

This intentionally ignores device IDs that aren't currently handled
by cx82310_eth. There may be other device IDs that perhaps shouldn't
be claimed by cxacru.
Signed-off-by: NOndrej Zary <linux@rainbow-software.org>
Signed-off-by: NSimon Arlott <simon@fire.lp0.eu>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

flows are an obsolete date type.
Signed-off-by: NAndy Grover <andy.grover@oracle.com>

Replace e.g. u_int32_t types with the more common uint32_t.
Reported-by: NMatthew Wilcox <willy@linux.intel.com>
Signed-off-by: NAndy Grover <andy.grover@oracle.com>

Also, a number of changes were made based on the assumption that
rds.h wasn't exported, so roll these back.
Signed-off-by: NAndy Grover <andy.grover@oracle.com>

Add two CMSGs for masked versions of cswp and fadd. args
struct modified to use a union for different atomic op type's
arguments. Change IB to do masked atomic ops. Atomic op type
in rds_message similarly unionized.
Signed-off-by: NAndy Grover <andy.grover@oracle.com>

This prints the constant identifier for work completion status and rdma
cm event types, like we already do for IB event types.

A core string array helper is added that each string type uses.
Signed-off-by: NZach Brown <zach.brown@oracle.com>

Nothing was canceling the send and receive work that might have been
queued as a conn was being destroyed.
Signed-off-by: NZach Brown <zach.brown@oracle.com>

rds_conn_shutdown() can return before the connection is shut down when
it encounters an existing state that it doesn't understand.  This lets
rds_conn_destroy() then start tearing down the conn from under paths
that are still using it.

It's more reliable the shutdown work and wait for krdsd to complete the
shutdown callback.  This stopped some hangs I was seeing where krdsd was
trying to shut down a freed conn.
Signed-off-by: NZach Brown <zach.brown@oracle.com>

Right now there's nothing to stop the various paths that use
rs->rs_transport from racing with rmmod and executing freed transport
code.  The simple fix is to have binding to a transport also hold a
reference to the transport's module, removing this class of races.

We already had an unused t_owner field which was set for the modular
transports and which wasn't set for the built-in loop transport.
Signed-off-by: NZach Brown <zach.brown@oracle.com>

rs_transport is now also used by the rdma paths once the socket is
bound.  We don't need this stale comment to tell us what cscope can.
Signed-off-by: NZach Brown <zach.brown@oracle.com>

rds_conn_destroy() can race with all other modifications of the
rds_conn_count but it was modifying the count without locking.
Signed-off-by: NZach Brown <zach.brown@oracle.com>

The RDS IB device list wasn't protected by any locking.  Traversal in
both the get_mr and FMR flushing paths could race with additon and
removal.

List manipulation is done with RCU primatives and is protected by the
write side of a rwsem.  The list traversal in the get_mr fast path is
protected by a rcu read critical section.  The FMR list traversal is
more problematic because it can block while traversing the list.  We
protect this with the read side of the rwsem.
Signed-off-by: NZach Brown <zach.brown@oracle.com>

It's nice to not have to go digging in the code to see which event
occurred.  It's easy to throw together a quick array that maps the ib
event enums to their strings.  I didn't see anything in the stack that
does this translation for us, but I also didn't look very hard.
Signed-off-by: NZach Brown <zach.brown@oracle.com>

Flushing FMRs is somewhat expensive, and is currently kicked off when
the interrupt handler notices that we are getting low.  The result of
this is that FMR flushing only happens from the interrupt cpus.

This spreads the load more effectively by triggering flushes just before
we allocate a new FMR.
Signed-off-by: NChris Mason <chris.mason@oracle.com>

This is only needed to keep debugging code from bugging.
Signed-off-by: NChris Mason <chris.mason@oracle.com>