Major rework of CM connection setup/teardown.  We had a number of issues
with MPI applications not starting/terminating properly over time.
With these changes we were able to run longer on larger clusters.

* Remove memory allocation from nes_connect() and nes_cm_connect().
* Fix mini_cm_dec_refcnt_listen() when destroying listener.
* Remove unnecessary code from schedule_nes_timer() and nes_cm_timer_tick().
* Functionalize mini_cm_recv_pkt() and process_packet().
* Clean up cm_node->ref_count usage.
* Reuse skbs if available.
Signed-off-by: NFaisal Latif <flatif@neteffect.com>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>

Remove an explicit memset(..., 0, ...) of a 'listener' structure
allocated with kzalloc().
Signed-off-by: NChristophe Jaillet <christophe.jaillet@wanadoo.fr>
Acked-by: NFaisal Latif <faisal@neteffect.com>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>

Various cleanups:
	- Change // to /* .. */
	- Place whitespace around binary operators.
	- Trim down a few long lines.
	- Some minor alignment formatting for better readability.
	- Remove some silly tabs.
Signed-off-by: NGlenn Streiff <gstreiff@neteffect.com>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>

After PXE boot, the iw_nes driver does a full reset to ensure the card
is in a clean state.  However, it doesn't wait for firmware to
complete its work before issuing a port reset to enable the ports,
which leads to problems bringing up the ports.

The solution is to wait for firmware to complete its work before
proceeding with port reset.

This bug was flagged by Roland Dreier <rolandd@cisco.com>.

Cc: <stable@kernel.org>
Signed-off-by: NChien Tung <ctung@neteffect.com>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>

Use NIPQUAD_FMT instead of printing raw 32-bit hex quantities in
debugging output.
Acked-by: NGlenn Streiff <gstreiff@neteffect.com>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>

Removing open-coded MAC formats shrinks the source and the generated
code too, eg on x86-64:

add/remove: 0/0 grow/shrink: 0/4 up/down: 0/-103 (-103)
function                                     old     new   delta
make_cm_node                                 932     912     -20
nes_netdev_set_mac_address                   427     406     -21
nes_netdev_set_multicast_list               1148    1124     -24
nes_probe                                   2349    2311     -38
Acked-by: NGlenn Streiff <gstreiff@neteffect.com>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>

In list iteration code, you normally wouldn't be calling
"container_of()" directly anyway, you'd be invoking "list_entry()".
But you don't even need that here, "list_for_each_entry()" is fine.
Signed-off-by: NRobert P. J. Day <rpjday@crashcourse.ca>
Acked-by: NGlenn Streiff <gstreiff@neteffect.com>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>

The session_id members of struct nes_cm_listener and struct
nes_cm_node are write-only, so remove them.  This allows the
session_id member of struct nes_cm_core to be removed as well, since
it is only used to write those other session_id values.

This removes the use of current->tgid (which will be deprecated)
pointed out by Pavel Emelyanov <xemul@openvz.org>.
Acked-by: NGlenn Streiff <gstreiff@neteffect.com>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>

__FUNCTION__ is gcc-specific, use __func__ instead.
Signed-off-by: NHarvey Harrison <harvey.harrison@gmail.com>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>

Avoid namespace pollution and allow the compiler to optimize better.
Signed-off-by: NRoland Dreier <rolandd@cisco.com>

Fix a couple of htonl() that should really be ntohl().
Signed-off-by: NRoland Dreier <rolandd@cisco.com>

Fix the calculation of the MSS for RDMA connections: we need to
allow space in frames for a VLAN tag too.
Signed-off-by: NChien Tung <ctung@neteffect.com>
Signed-off-by: NGlenn Streiff <gstreiff@neteffect.com>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>

With commit ef19454b ("[LIB] crc32c: Keep intermediate crc state in
cpu order"), the behavior of crc32c changes on big-endian platforms.

Our algorithm expects the previous behavior; otherwise we have RDMA
connection establishment failure on big-endian platforms like powerpc.
Apply cpu_to_le32() to value returned by crc32c() to get the previous
behavior.
Signed-off-by: NFaisal Latif <flatif@neteffect.com>
Signed-off-by: NGlenn Streiff <gstreiff@neteffect.com>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>

Fix use-after-free spotted by Coverity checker flagged by Adrian Bunk.
Signed-off-by: NFaisal Latif <flatif@neteffect.com>
Signed-off-by: NGlenn Streiff <gstreiff@neteffect.com>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>

Fix a memory leak spotted by the Coverity checker.
Signed-off-by: NAdrian Bunk <bunk@kernel.org>
Signed-off-by: NGlenn Streiff <gstreiff@neteffect.com>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>

Add a standard NIC and RDMA/iWARP driver for NetEffect 1/10Gb ethernet adapters.
Signed-off-by: NGlenn Streiff <gstreiff@neteffect.com>
Signed-off-by: NRoland Dreier <rolandd@cisco.com>