- 20 7月, 2008 1 次提交
-
-
由 Jussi Kivilinna 提交于
Add size table functions for qdiscs and calculate packet size in qdisc_enqueue(). Based on patch by Patrick McHardy http://marc.info/?l=linux-netdev&m=115201979221729&w=2Signed-off-by: NJussi Kivilinna <jussi.kivilinna@mbnet.fi> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 18 7月, 2008 1 次提交
-
-
由 David S. Miller 提交于
This actually fixes a bug added by the RR scheduler changes. The ->bands and ->prio2band parameters were being set outside of the sch_tree_lock() and thus could result in strange behavior and inconsistencies. It might be possible, in the new design (where there will be one qdisc per device TX queue) to allow similar functionality via a TX hash algorithm for RR but I really see no reason to export this aspect of how these multiqueue cards actually implement the scheduling of the the individual DMA TX rings and the single physical MAC/PHY port. Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 01 2月, 2008 1 次提交
-
-
由 Patrick McHardy 提交于
Add support for dumping statistics and make internal queues visible as classes. Signed-off-by: NPatrick McHardy <kaber@trash.net> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 29 1月, 2008 1 次提交
-
-
由 Patrick McHardy 提交于
Signed-off-by: NPatrick McHardy <kaber@trash.net> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 11 10月, 2007 1 次提交
-
-
由 Jesper Dangaard Brouer 提交于
This is done in order to, add support to changing the rate table to use the upper-boundry L2T (length to time) value. Currently we use the lower-boundry, which result in under-estimating the actual bandwidth usage. Extend the tc_ratespec struct, with two parameters: 1) "cell_align" that allow adjusting the alignment of the rate table. 2) "overhead" that allow adding a packet overhead before the lookup. Signed-off-by: NJesper Dangaard Brouer <hawk@comx.dk> Acked-by: NPatrick McHardy <kaber@trash.net> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 11 7月, 2007 1 次提交
-
-
由 Peter P Waskiewicz Jr 提交于
Add the new sch_rr qdisc for multiqueue network device support. Allow sch_prio and sch_rr to be compiled with or without multiqueue hardware support. sch_rr is part of sch_prio, and is referenced from MODULE_ALIAS. This was done since sch_prio and sch_rr only differ in their dequeue routine. Signed-off-by: NPeter P Waskiewicz Jr <peter.p.waskiewicz.jr@intel.com> Signed-off-by: NPatrick McHardy <kaber@trash.net> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 04 1月, 2006 1 次提交
-
-
由 Stephen Hemminger 提交于
Here is a new feature for netem in 2.6.16. It adds the ability to randomly corrupt packets with netem. A version was done by Hagen Paul Pfeifer, but I redid it to handle the cases of backwards compatibility with netlink interface and presence of hardware checksum offload. It is useful for testing hardware offload in devices. Signed-off-by: NStephen Hemminger <shemminger@osdl.org> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 06 11月, 2005 3 次提交
-
-
由 Thomas Graf 提交于
Introduces a new flag TC_RED_HARDDROP which specifies that if ECN marking is enabled packets should still be dropped once the average queue length exceeds the maximum threshold. This _may_ help to avoid global synchronisation during small bursts of peers advertising but not caring about ECN. Use this option very carefully, it does more harm than good if (qth_max - qth_min) does not cover at least two average burst cycles. The difference to the current behaviour, in which we'd run into the hard queue limit, is that due to the low pass filter of RED short bursts are less likely to cause a global synchronisation. Signed-off-by: NThomas Graf <tgraf@suug.ch> Signed-off-by: NArnaldo Carvalho de Melo <acme@mandriva.com>
-
由 Thomas Graf 提交于
Adds a new u8 flags in a unused padding area of the netlink message. Adds ECN marking support to be used instead of dropping packets immediately. Signed-off-by: NThomas Graf <tgraf@suug.ch> Signed-off-by: NArnaldo Carvalho de Melo <acme@mandriva.com>
-
由 Thomas Graf 提交于
Removes unnecessary includes, initializers, and simplifies the code a bit. Signed-off-by: NThomas Graf <tgraf@suug.ch> Signed-off-by: NArnaldo Carvalho de Melo <acme@mandriva.com>
-
- 29 6月, 2005 1 次提交
-
-
由 Patrick McHardy 提交于
Plug holes with padding fields and initialized them to zero. Signed-off-by: NPatrick McHardy <kaber@trash.net> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 27 5月, 2005 1 次提交
-
-
由 Stephen Hemminger 提交于
Here is a fixed up version of the reorder feature of netem. It is the same as the earlier patch plus with the bugfix from Julio merged in. Has expected backwards compatibility behaviour. Go ahead and merge this one, the TCP strangeness I was seeing was due to the reordering bug, and previous version of TSO patch. Signed-off-by: NStephen Hemminger <shemminger@osdl.org> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 17 4月, 2005 1 次提交
-
-
由 Linus Torvalds 提交于
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
-