- 25 6月, 2016 8 次提交
-
-
由 Christophe RICARD 提交于
Add support for acpi probing. SMO3324 is used for st33zp24. It has been tested with the following acpi node on Minnowboard: Device (TPM1) { Name (_ADR, Zero) // _ADR: Address Name (_HID, "SMO3324") // _HID: Hardware ID Name (_CID, "SMO3324") // _CID: Compatible ID Name (_DDN, "SMO TPM") // _DDN: DOS Device Name Name (_UID, One) // _UID: Unique ID Method (_CRS, 0, NotSerialized) // _CRS: Current Resource Settings { Name (SBUF, ResourceTemplate () { SpiSerialBus (0, PolarityLow, FourWireMode, 8, ControllerInitiated, 4000000, ClockPolarityLow, ClockPhaseFirst, "\\_SB.SPI1", 0x00, ResourceConsumer, ,) GpioInt (Edge, ActiveHigh, ExclusiveAndWake, PullNone, 0x0000, "\\_SB.GPO2", 0x00, ResourceConsumer, ,) { // Pin list 0x0001 } GpioIo (Exclusive, PullDefault, 0x0000, 0x0000, IoRestrictionOutputOnly, "\\_SB.GPO2", 0x00, ResourceConsumer, ,) { // Pin list 0x0002, } }) Return (SBUF) /* \_SB_.SPI1.TPM1._CRS.SBUF */ } Method (_STA, 0, NotSerialized) // _STA: Status { Return (0x0F) } } Signed-off-by: NChristophe Ricard <christophe-h.ricard@st.com> Reviewed-by: NJarkko Sakkinen <jarkko.sakkinen@linux.intel.com> Signed-off-by: NJarkko Sakkinen <jarkko.sakkinen@linux.intel.com>
-
由 Christophe RICARD 提交于
Extend copyright header to 2016 Signed-off-by: NChristophe Ricard <christophe-h.ricard@st.com> Reviewed-by: NJarkko Sakkinen <jarkko.sakkinen@linux.intel.com> Signed-off-by: NJarkko Sakkinen <jarkko.sakkinen@linux.intel.com>
-
由 Christophe RICARD 提交于
Add check in st33zp24_spi_evaluate_latency helping to diagnose if the chip is present or in a bad state. Signed-off-by: NChristophe Ricard <christophe-h.ricard@st.com> Reviewed-by: NJarkko Sakkinen <jarkko.sakkinen@linux.intel.com> Signed-off-by: NJarkko Sakkinen <jarkko.sakkinen@linux.intel.com>
-
由 Christophe RICARD 提交于
DT headers already define NOOP routines when CONFIG_OF is not defined. [jarkko.sakkinen@linux.intel.com: I tested that the driver compiles without warnings and errors with and without CONFIG_OF flag.] Signed-off-by: NChristophe Ricard <christophe-h.ricard@st.com> Reviewed-by: NJarkko Sakkinen <jarkko.sakkinen@linux.intel.com> Tested-by: NJarkko Sakkinen <jarkko.sakkinen@linux.intel.com> Signed-off-by: NJarkko Sakkinen <jarkko.sakkinen@linux.intel.com>
-
由 Christophe RICARD 提交于
Remove spi_xfer from st33zp24_spi_phy structure and declare local spi_xfer when needed instead. Signed-off-by: NChristophe Ricard <christophe-h.ricard@st.com> Reviewed-by: NJarkko Sakkinen <jarkko.sakkinen@linux.intel.com> Signed-off-by: NJarkko Sakkinen <jarkko.sakkinen@linux.intel.com>
-
由 Christophe RICARD 提交于
An affectation is enough when copying 1 byte. Remove memcpy usage where possible. Signed-off-by: NChristophe Ricard <christophe-h.ricard@st.com> Reviewed-by: NJarkko Sakkinen <jarkko.sakkinen@linux.intel.com> Signed-off-by: NJarkko Sakkinen <jarkko.sakkinen@linux.intel.com>
-
由 Christophe RICARD 提交于
Make sure every function name use st33zp24_spi_ prefix. Signed-off-by: NChristophe Ricard <christophe-h.ricard@st.com> Reviewed-by: NJarkko Sakkinen <jarkko.sakkinen@linux.intel.com> Signed-off-by: NJarkko Sakkinen <jarkko.sakkinen@linux.intel.com>
-
由 Christophe RICARD 提交于
nbr_dummy_bytes variable could be easily replaced by phy->latency in st33zp24_spi_send and st33zp24_spi_recv. Signed-off-by: NChristophe Ricard <christophe-h.ricard@st.com> Reviewed-by: NJarkko Sakkinen <jarkko.sakkinen@linux.intel.com> Signed-off-by: NJarkko Sakkinen <jarkko.sakkinen@linux.intel.com>
-
- 28 10月, 2015 1 次提交
-
-
由 Andrew F. Davis 提交于
An spi_driver does not need to set an owner, it will be populated by the driver core. Signed-off-by: NAndrew F. Davis <afd@ti.com> Acked-by: NJonathan Cameron <jic23@kernel.org> Signed-off-by: NMark Brown <broonie@kernel.org>
-
- 27 3月, 2015 1 次提交
-
-
由 Christophe Ricard 提交于
MODULE_DEVICE_TABLE is missing in spi phy in case CONFIG_OF is not set. Reviewed-by: NJason Gunthorpe <jgunthorpe@obsidianresearch.com> Signed-off-by: NChristophe Ricard <christophe-h.ricard@st.com> Signed-off-by: NPeter Huewe <peterhuewe@gmx.de>
-
- 19 3月, 2015 1 次提交
-
-
由 Christophe Ricard 提交于
st33zp24 TIS 1.2 support also SPI. It is using a proprietary protocol to transport TIS data. Acked-by: NJarkko Sakkinen <jarkko.sakknen@linux.intel.com> Reviewed-by: NJason Gunthorpe <jason.gunthorpe@obsidianresearch.com> Signed-off-by: NChristophe Ricard <christophe-h.ricard@st.com> Signed-off-by: NPeter Huewe <peterhuewe@gmx.de>
-