Skip to content

cloud-kernel
cloud-kernel

openanolis / cloud-kernel
1 年多 前同步成功

通知 161
Star 36
Fork 7
cloud-kernel
cloud-kernel
切换分支/标签
  1. 16 3月, 2006 2 次提交
    • M
      [PATCH] powerpc: RTC memory corruption · 0e8ed479
      由 Michael Neuling 提交于 
      We should be memset'ing the data we are pointing to, not the pointer
itself.  This is in an error path so we probably don't hit it much.
Signed-off-by: NMichael Neuling <mikey@neuling.org>
Signed-off-by: NPaul Mackerras <paulus@samba.org>
      0e8ed479
    • P
      powerpc: Fix problem with time going backwards · 0a45d449
      由 Paul Mackerras 提交于 
      The recent changes to keep gettimeofday in sync with xtime had the side
effect that it was occasionally possible for the time reported by
gettimeofday to go back by a microsecond.  There were two reasons:
(1) when we recalculated the offsets used by gettimeofday every 2^31
timebase ticks, we lost an accumulated fractional microsecond, and
(2) because the update is done some time after the notional start of
jiffy, if ntp is slowing the clock, it is possible to see time go backwards
when the timebase factor gets reduced.

This fixes it by (a) slowing the gettimeofday clock by about 1us in
2^31 timebase ticks (a factor of less than 1 in 3.7 million), and (b)
adjusting the timebase offsets in the rare case that the gettimeofday
result could possibly go backwards (i.e. when ntp is slowing the clock
and the timer interrupt is late).  In this case the adjustment will
reduce to zero eventually because of (a).
Signed-off-by: NPaul Mackerras <paulus@samba.org>
      0a45d449
  3. 08 3月, 2006 1 次提交
    • P
      powerpc: Fix various syscall/signal/swapcontext bugs · 1bd79336
      由 Paul Mackerras 提交于 
      A careful reading of the recent changes to the system call entry/exit
paths revealed several problems, plus some things that could be
simplified and improved:

* 32-bit wasn't testing the _TIF_NOERROR bit in the syscall fast exit
  path, so it was only doing anything with it once it saw some other
  bit being set.  In other words, the noerror behaviour would apply to
  the next system call where we had to reschedule or deliver a signal,
  which is not necessarily the current system call.

* 32-bit wasn't doing the call to ptrace_notify in the syscall exit
  path when the _TIF_SINGLESTEP bit was set.

* _TIF_RESTOREALL was in both _TIF_USER_WORK_MASK and
  _TIF_PERSYSCALL_MASK, which is odd since _TIF_RESTOREALL is only set
  by system calls.  I took it out of _TIF_USER_WORK_MASK.

* On 64-bit, _TIF_RESTOREALL wasn't causing the non-volatile registers
  to be restored (unless perhaps a signal was delivered or the syscall
  was traced or single-stepped).  Thus the non-volatile registers
  weren't restored on exit from a signal handler.  We probably got
  away with it mostly because signal handlers written in C wouldn't
  alter the non-volatile registers.

* On 32-bit I simplified the code and made it more like 64-bit by
  making the syscall exit path jump to ret_from_except to handle
  preemption and signal delivery.

* 32-bit was calling do_signal unnecessarily when _TIF_RESTOREALL was
  set - but I think because of that 32-bit was actually restoring the
  non-volatile registers on exit from a signal handler.

* I changed the order of enabling interrupts and saving the
  non-volatile registers before calling do_syscall_trace_leave; now we
  enable interrupts first.
Signed-off-by: NPaul Mackerras <paulus@samba.org>
      1bd79336
  5. 05 3月, 2006 1 次提交
  7. 03 3月, 2006 3 次提交
  9. 01 3月, 2006 1 次提交
  11. 28 2月, 2006 1 次提交
  13. 25 2月, 2006 1 次提交
  15. 24 2月, 2006 5 次提交
  17. 20 2月, 2006 5 次提交
    • M
      [PATCH] powerpc: Make UP -> SMP kexec work again · 8fca9270
      由 Michael Ellerman 提交于 
      For UP to SMP kexec to work we need to jump into pSeries_secondary_smp_init
event on a UP + KEXEC kernel. The secondary cpus will not find their hw_cpu_id
in the paca and so they'll jump into kexec_wait, ready for a kexec.
Signed-off-by: NMichael Ellerman <michael@ellerman.id.au>
Signed-off-by: NPaul Mackerras <paulus@samba.org>
      8fca9270
    • M
      [PATCH] powerpc: Don't start secondary CPUs in a UP && KEXEC kernel · f018b36f
      由 Michael Ellerman 提交于 
      Because smp_release_cpus() is built for SMP || KEXEC, it's not safe to
unconditionally call it from setup_system(). On a UP && KEXEC kernel we'll
start up the secondary CPUs which will then go beserk and we die.

Simple fix is to conditionally call smp_release_cpus() in setup_system(). With
that in place we don't need the dummy definition of smp_release_cpus() because
all call sites are #ifdef'ed either SMP or KEXEC.
Signed-off-by: NMichael Ellerman <michael@ellerman.id.au>
Signed-off-by: NPaul Mackerras <paulus@samba.org>
      f018b36f
    • O
      [PATCH] powerpc: Fix OOPS in lparcfg on G5 · 2b9a32ed
      由 Olof Johansson 提交于 
      Fallback gracefully when reading /proc/ppc64/lparcfg when the /rtas
device node can't be found.
Signed-off-by: NOlof Johansson <olof@lixom.net>
Signed-off-by: NPaul Mackerras <paulus@samba.org>
      2b9a32ed
    • O
      [PATCH] powerpc: remove duplicate exports · 0728a2f9
      由 Olaf Hering 提交于 
      A few symbols are exported twice, remove them from ppc_ksyms.c
Remove users of sys_ctrler in arch/ppc/

WARNING: vmlinux: duplicate symbol '__delay' previous definition was in vmlinux
WARNING: vmlinux: duplicate symbol '__up' previous definition was in vmlinux
WARNING: vmlinux: duplicate symbol '__down' previous definition was in vmlinux
WARNING: vmlinux: duplicate symbol '__down_interruptible' previous definition was in vmlinux
WARNING: vmlinux: duplicate symbol 'sys_ctrler' previous definition was in vmlinux
WARNING: vmlinux: duplicate symbol 'strncat' previous definition was in vmlinux
WARNING: vmlinux: duplicate symbol 'strncmp' previous definition was in vmlinux
WARNING: vmlinux: duplicate symbol 'strchr' previous definition was in vmlinux
WARNING: vmlinux: duplicate symbol 'strrchr' previous definition was in vmlinux
WARNING: vmlinux: duplicate symbol 'strnlen' previous definition was in vmlinux
WARNING: vmlinux: duplicate symbol 'strpbrk' previous definition was in vmlinux
WARNING: vmlinux: duplicate symbol 'memscan' previous definition was in vmlinux
WARNING: vmlinux: duplicate symbol 'strstr' previous definition was in vmlinux
Signed-off-by: NOlaf Hering <olh@suse.de>
Signed-off-by: NPaul Mackerras <paulus@samba.org>
      0728a2f9
    • P
      powerpc: Keep xtime and gettimeofday in sync · 092b8f34
      由 Paul Mackerras 提交于 
      This fixes a regression which was introduced by moving ppc32 to use
the same sort of lockless gettimeofday as ppc64 has been using for
some time.  This involves getting the timebase and performing some
simple arithmetic to convert it to seconds and microseconds.  However,
the factor and offset used there weren't being updated when NTP
varied the tick length using adjtimex.  64-bit didn't notice the
problem because it had a hook in the 32-bit adjtimex compat routine
that attempted to work out what the generic timekeeping code would
do and alter the factor and offset to match.  However, that code
was very complex and it wasn't clear that it still matched what the
generic code would do.

Now we use the generic current_tick_length() routine that was recently
added to check that the current tick will be as long as we expect; if
not we recompute the factor and offset.  This keeps gettimeofday and
xtime in sync.  In addition we check that gettimeofday hasn't got ahead
of xtime on each timer interrupt; if it has, we resync.
Signed-off-by: NPaul Mackerras <paulus@samba.org>
      092b8f34
  19. 10 2月, 2006 2 次提交
  21. 08 2月, 2006 1 次提交
  23. 07 2月, 2006 16 次提交
  25. 02 2月, 2006 1 次提交