Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

kern_addr_valid is currently only being used in kmem_ptr_validate which
is making some vague attempt at verfying the validity of an address.
Only IA-64, PARISC and x86-64 actually make some actual effort to verify
the validity of the pointer.  Most architecture definitions of
kern_addr_valid() just define it as 1; the Alpha and CONFIG_DISCONTIGMEM
on i386 and MIPS even as 0; the 0-definition will result in
kmem_ptr_validate always failing which in turn will cause d_validate to
always fail.  d_validate's only two users are smbfs and ncpfs, so the
0 definition ended breaking those ...
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRodolfo Giometti <giometti@linux.it>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

It's not SN0-specific.
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

IP27 configuration isn't the only NUMA system - it just happens to be
the currently only supported MIPS NUMA system.  So move the necessary
options back into the main MIPS Kconfig file.
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NYoichi Yuasa <yoichi_yuasa@tripeaks.co.jp>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Mark au1xxx_timer_setup() __init, just because it is. Get rid of
unneeded extern's (note that (*do_gettimeoffset)() is already declared by
<asm/time.c>) and an unused variable. Kill some whitespace...
Signed-off-by: NSergei Shtylyov <sshtylyov@ru.mvista.com>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NThiemo Seufer <ths@networkno.de>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

The struct mips_fpu_soft_struct and mips_fpu_hard_struct are
completely same now and the kernel fpu emulator assumes that.  This
patch unifies them to mips_fpu_struct and get rid of mips_fpu_union.
Signed-off-by: NAtsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

    
Support for the GT-64120-based Wind River 4KC PPMC Evaluation board.
Signed-off-by: NRongkai.Zhan <Rongkai.zhan@windriver.com>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Convert sizeof/sizeof use to use of ARRAY_SIZE macro, and annotate
irqmap structures as __initdata.
Signed-off-by: NHerbert Valerio Riedel <hvr@gnu.org>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

I found that NPTL's pthread_cond_signal() does not work properly on
kernels compiled by gcc 4.1.x.  I suppose inline asm for
__futex_atomic_op() was wrong.  I suppose:

1. "=&r" constraint should be used for oldval.
2. Instead of "r" (uaddr), "=R" (*uaddr) for output and "R" (*uaddr)
   for input should be used.
3. "memory" should be added to the clobber list.
Signed-off-by: NAtsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Running a UP kernel on a bcm1480 board, I get nonsensical timing
results, like this:
release@unknown:~/tmp$ time ./a.out
real    0m22.906s
user    0m45.792s
sys     0m0.010s
According to my watch, this program took 23 seconds to run, so the real
time clock is OK.  It is process accounting that is broken.

I tracked this down to a problem with the function
bcm1480_timer_interrupt in the file sibyte/bcm1480/time.c.  This
function calls ll_timer_interrupt for cpu0, and ll_local_timer_interrupt
for all cpus.  However, both of these functions do process accounting.
Thus processes running on cpu0 end up with doubled times.  This is very
obvious in a UP kernel where all processes run on cpu0.

The correct way to do this is to only call ll_local_timer interrupt if
this is not cpu0.  This can be seen in the mips-board/generic/time.c
file, and also in the sibyte/sb1250/time.c file, both of which handle
this correctly.  I fixed the bcm1480/time.c file by copying over the
correct code from the sb1250/time.c file.

With this fix, I now get sensible results.
release@unknown:~/tmp$ time ./a.out
real    0m22.903s
user    0m22.894s
sys     0m0.006s
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

    
Broken in too many way for me to fix it for 2.6.17.
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

    
It took a while longer than on other architectures but gcc has finally
started to strike us as well ...
    
This also fixes the damage by 6edfba1b.
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Signed-off-by: NYoichi Yuasa <yoichi_yuasa@tripeaks.co.jp>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

> Without this fix, _save_fp() in 64-bit kernel is seriously broken.
>
> ffffffff8010bec0 <_save_fp>:
> ffffffff8010bec0:       400d6000        mfc0    t1,c0_status
> ffffffff8010bec4:       000c7140        sll     t2,t0,0x5
> ffffffff8010bec8:       05c10011        bgez    t2,ffffffff8010bf10 <_save_fp+0x50>
> ffffffff8010becc:       00000000        nop
> ffffffff8010bed0:       f4810328        sdc1    $f1,808(a0)
> ...

Fix register usage in fpu_save_double() and make fpu_restore_double()
more symmetric with fpu_save_double().
Signed-off-by: NAtsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

    
The SOC-it system controller running in big endian mode might forget
byteswapping when DMAing to the last word of physical memory.  Fixed by
ignoring the last page of memory.
Signed-off-by: NRalf Baechle <ralf@linux-mips.org>

Being named "Crazed Snow-Weasel" instills a lot of confidence in this
release, so I'm sure this will be one of the better ones.

Reflect the fact that the Cell Broadband Engine supports 64k
pages by adding the bit to the CPU features.
Signed-off-by: NArnd Bergmann <arnd.bergmann@de.ibm.com>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

The page size encoding passed to tlbie is incorrect for new-style
large pages.  This fixes it.  This doesn't affect anything on older
machines because mmu_psize_defs[psize].penc (the page size encoding)
is 0 for 4k and 16M pages (the two are distinguished by a separate "is
a large page" bit).
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: NArnd Bergmann <arnd.bergmann@de.ibm.com>
Signed-off-by: NPaul Mackerras <paulus@samba.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

arm_timer() checks PF_EXITING to prevent BUG_ON(->exit_state)
in run_posix_cpu_timers().

However, for some reason it does so only for CPUCLOCK_PERTHREAD
case (which is imho wrong).

Also, this check is not reliable, PF_EXITING could be set on
another cpu without any locks/barriers just after the check,
so it can't prevent from attaching the timer to the exiting
task.

The previous patch makes this check unneeded.
Signed-off-by: NOleg Nesterov <oleg@tv-sign.ru>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

do_exit() clears ->it_##clock##_expires, but nothing prevents
another cpu to attach the timer to exiting process after that.
arm_timer() tries to protect against this race, but the check
is racy.

After exit_notify() does 'write_unlock_irq(&tasklist_lock)' and
before do_exit() calls 'schedule() local timer interrupt can find
tsk->exit_state != 0. If that state was EXIT_DEAD (or another cpu
does sys_wait4) interrupted task has ->signal == NULL.

At this moment exiting task has no pending cpu timers, they were
cleanuped in __exit_signal()->posix_cpu_timers_exit{,_group}(),
so we can just return from irq.

John Stultz recently confirmed this bug, see

	http://marc.theaimsgroup.com/?l=linux-kernel&m=115015841413687Signed-off-by: NOleg Nesterov <oleg@tv-sign.ru>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

If the local timer interrupt happens just after do_exit() sets PF_EXITING
(and before it clears ->it_xxx_expires) run_posix_cpu_timers() will call
check_process_timers() with tasklist_lock + ->siglock held and

	check_process_timers:

		t = tsk;
		do {
			....

			do {
				t = next_thread(t);
			} while (unlikely(t->flags & PF_EXITING));
		} while (t != tsk);

the outer loop will never stop.

Actually, the window is bigger.  Another process can attach the timer
after ->it_xxx_expires was cleared (see the next commit) and the 'if
(PF_EXITING)' check in arm_timer() is racy (see the one after that).
Signed-off-by: NOleg Nesterov <oleg@tv-sign.ru>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

A couple of fixes that should prevent crashes when using netconsole and
suspend/resume. First, netconsole poll routine shouldn't run unless the
device is up; second, the NAPI poll should be disabled during suspend.

This is only an issue on sky2, because it has to have one NAPI poll
routine for both ports on dual port boards. Normal drivers use
netif_rx_schedule_prep and that checks for netif_running.
Signed-off-by: NStephen Hemminger <shemminger@osdl.org>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>

If get_user_pages() returns less pages than what we asked for, we jump
to out_unmap which will return ERR_PTR(ret).  But ret can contain a
positive number just smaller than local_nr_pages, so be sure to set it
to -EFAULT always.

Problem found and diagnosed by Damien Le Moal <damien@sdl.hitachi.co.jp>
Signed-off-by: NJens Axboe <axboe@suse.de>
Signed-off-by: NLinus Torvalds <torvalds@osdl.org>