Makes SoC camera videobuf independent. Includes all necessary changes for
PXA camera driver (currently the only driver using soc_camera in the mainline).
These changes are important for the future soc_camera based drivers.
Signed-off-by: NPaulius Zaleckas <paulius.zaleckas@teltonika.lt>
Signed-off-by: NGuennadi Liakhovetski <g.liakhovetski@pengutronix.de>
Signed-off-by: NMauro Carvalho Chehab <mchehab@infradead.org>

All drivers should provide a spinlock to be used in videobuf operations.
Signed-off-by: NGuennadi Liakhovetski <g.liakhovetski@pengutronix.de>
Reviewed-by: NBrandon Philips <bphilips@suse.de>
Signed-off-by: NMauro Carvalho Chehab <mchehab@infradead.org>

Function pointers and the driver owner are not expected to change
throughout soc-camera host's life. Extract them into an operations struct.
Signed-off-by: NGuennadi Liakhovetski <g.liakhovetski@pengutronix.de>
Signed-off-by: NMauro Carvalho Chehab <mchehab@infradead.org>

In case of muliple cameras, handled by the same driver, they can support
Signed-off-by: NMauro Carvalho Chehab <mchehab@infradead.org>

Improve hardware parameter negotiation between the camera host driver and
camera drivers. Parameters like horizontal and vertical synchronisation,
pixel clock polarity shall be set depending on capabilities of the
parties.
Signed-off-by: NGuennadi Liakhovetski <g.liakhovetski@pengutronix.de>
Signed-off-by: NMauro Carvalho Chehab <mchehab@infradead.org>

Only attach cameras to the host interface for probing, then detach until
open. This allows platforms with several cameras on an interface,
physically supporting only one camera, to handle multiple cameras and
activate them selectively after initial probing. The first attach during
probe is needed to activate the host interface to be able to physically
communicate with cameras.
Signed-off-by: NGuennadi Liakhovetski <g.liakhovetski@pengutronix.de>
Signed-off-by: NMauro Carvalho Chehab <mchehab@infradead.org>

This driver provides an interface between platform-specific camera
busses and camera devices. It should be used if the camera is connected
not over a "proper" bus like PCI or USB, but over a special bus, like,
for example, the Quick Capture interface on PXA270 SoCs. Later it should
also be used for i.MX31 SoCs from Freescale.  It can handle multiple
cameras and / or multiple busses, which can be used, e.g., in
stereo-vision applications.
Signed-off-by: NGuennadi Liakhovetski <g.liakhovetski@pengutronix.de>
Signed-off-by: NMauro Carvalho Chehab <mchehab@infradead.org>