drm/i915: Throw out WIP CHV power well definitions

Expecting CHV power wells to be just an extended versions of the VLV
power wells, a bunch of commented out power wells were added in
anticipation when Punit folks would implement it all. Turns out they
never did, and instead CHV has fewer power wells than VLV. Rip out all
the #if 0'ed junk that's not needed.

v2: Rename the "pipe-a" well to "display" to match VLV
    Clarify the pipe A power well relationship to pipes B and C (Deepak)
Reviewed-by: NDeepak S <deepak.s@linux.intel.com>
Signed-off-by: NVille Syrjälä <ville.syrjala@linux.intel.com>
Signed-off-by: NDaniel Vetter <daniel.vetter@ffwll.ch>

drivers/gpu/drm/i915/i915_reg.h

@@ -595,10 +595,6 @@ enum punit_power_well {
 	PUNIT_POWER_WELL_DPIO_RX0		= 10,
 	PUNIT_POWER_WELL_DPIO_RX1		= 11,
 	PUNIT_POWER_WELL_DPIO_CMN_D		= 12,
-	/* FIXME: guesswork below */
-	PUNIT_POWER_WELL_DPIO_TX_D_LANES_01	= 13,
-	PUNIT_POWER_WELL_DPIO_TX_D_LANES_23	= 14,
-	PUNIT_POWER_WELL_DPIO_RX2		= 15,
 
 	PUNIT_POWER_WELL_NUM,
 };

drivers/gpu/drm/i915/intel_runtime_pm.c

@@ -1233,18 +1233,6 @@ void intel_display_power_put(struct drm_i915_private *dev_priv,
 	BIT(POWER_DOMAIN_AUX_C) |		\
 	BIT(POWER_DOMAIN_INIT))
 
-#define CHV_PIPE_A_POWER_DOMAINS (	\
-	BIT(POWER_DOMAIN_PIPE_A) |	\
-	BIT(POWER_DOMAIN_INIT))
-
-#define CHV_PIPE_B_POWER_DOMAINS (	\
-	BIT(POWER_DOMAIN_PIPE_B) |	\
-	BIT(POWER_DOMAIN_INIT))
-
-#define CHV_PIPE_C_POWER_DOMAINS (	\
-	BIT(POWER_DOMAIN_PIPE_C) |	\
-	BIT(POWER_DOMAIN_INIT))
-
 #define CHV_DPIO_CMN_BC_POWER_DOMAINS (		\
 	BIT(POWER_DOMAIN_PORT_DDI_B_2_LANES) |	\
 	BIT(POWER_DOMAIN_PORT_DDI_B_4_LANES) |	\
@@ -1260,17 +1248,6 @@ void intel_display_power_put(struct drm_i915_private *dev_priv,
 	BIT(POWER_DOMAIN_AUX_D) |		\
 	BIT(POWER_DOMAIN_INIT))
 
-#define CHV_DPIO_TX_D_LANES_01_POWER_DOMAINS (	\
-	BIT(POWER_DOMAIN_PORT_DDI_D_2_LANES) |	\
-	BIT(POWER_DOMAIN_PORT_DDI_D_4_LANES) |	\
-	BIT(POWER_DOMAIN_AUX_D) |		\
-	BIT(POWER_DOMAIN_INIT))
-
-#define CHV_DPIO_TX_D_LANES_23_POWER_DOMAINS (	\
-	BIT(POWER_DOMAIN_PORT_DDI_D_4_LANES) |	\
-	BIT(POWER_DOMAIN_AUX_D) |		\
-	BIT(POWER_DOMAIN_INIT))
-
 static const struct i915_power_well_ops i9xx_always_on_power_well_ops = {
 	.sync_hw = i9xx_always_on_power_well_noop,
 	.enable = i9xx_always_on_power_well_noop,
@@ -1428,40 +1405,17 @@ static struct i915_power_well chv_power_wells[] = {
 		.domains = VLV_ALWAYS_ON_POWER_DOMAINS,
 		.ops = &i9xx_always_on_power_well_ops,
 	},
-#if 0
 	{
 		.name = "display",
-		.domains = VLV_DISPLAY_POWER_DOMAINS,
-		.data = PUNIT_POWER_WELL_DISP2D,
-		.ops = &vlv_display_power_well_ops,
-	},
-#endif
-	{
-		.name = "pipe-a",
 		/*
-		 * FIXME: pipe A power well seems to be the new disp2d well.
-		 * At least all registers seem to be housed there. Figure
-		 * out if this a a temporary situation in pre-production
-		 * hardware or a permanent state of affairs.
+		 * Pipe A power well is the new disp2d well. Pipe B and C
+		 * power wells don't actually exist. Pipe A power well is
+		 * required for any pipe to work.
 		 */
-		.domains = CHV_PIPE_A_POWER_DOMAINS | VLV_DISPLAY_POWER_DOMAINS,
+		.domains = VLV_DISPLAY_POWER_DOMAINS,
 		.data = PIPE_A,
 		.ops = &chv_pipe_power_well_ops,
 	},
-#if 0
-	{
-		.name = "pipe-b",
-		.domains = CHV_PIPE_B_POWER_DOMAINS,
-		.data = PIPE_B,
-		.ops = &chv_pipe_power_well_ops,
-	},
-	{
-		.name = "pipe-c",
-		.domains = CHV_PIPE_C_POWER_DOMAINS,
-		.data = PIPE_C,
-		.ops = &chv_pipe_power_well_ops,
-	},
-#endif
 	{
 		.name = "dpio-common-bc",
 		.domains = CHV_DPIO_CMN_BC_POWER_DOMAINS,
@@ -1474,50 +1428,6 @@ static struct i915_power_well chv_power_wells[] = {
 		.data = PUNIT_POWER_WELL_DPIO_CMN_D,
 		.ops = &chv_dpio_cmn_power_well_ops,
 	},
-#if 0
-	{
-		.name = "dpio-tx-b-01",
-		.domains = VLV_DPIO_TX_B_LANES_01_POWER_DOMAINS |
-			   VLV_DPIO_TX_B_LANES_23_POWER_DOMAINS,
-		.ops = &vlv_dpio_power_well_ops,
-		.data = PUNIT_POWER_WELL_DPIO_TX_B_LANES_01,
-	},
-	{
-		.name = "dpio-tx-b-23",
-		.domains = VLV_DPIO_TX_B_LANES_01_POWER_DOMAINS |
-			   VLV_DPIO_TX_B_LANES_23_POWER_DOMAINS,
-		.ops = &vlv_dpio_power_well_ops,
-		.data = PUNIT_POWER_WELL_DPIO_TX_B_LANES_23,
-	},
-	{
-		.name = "dpio-tx-c-01",
-		.domains = VLV_DPIO_TX_C_LANES_01_POWER_DOMAINS |
-			   VLV_DPIO_TX_C_LANES_23_POWER_DOMAINS,
-		.ops = &vlv_dpio_power_well_ops,
-		.data = PUNIT_POWER_WELL_DPIO_TX_C_LANES_01,
-	},
-	{
-		.name = "dpio-tx-c-23",
-		.domains = VLV_DPIO_TX_C_LANES_01_POWER_DOMAINS |
-			   VLV_DPIO_TX_C_LANES_23_POWER_DOMAINS,
-		.ops = &vlv_dpio_power_well_ops,
-		.data = PUNIT_POWER_WELL_DPIO_TX_C_LANES_23,
-	},
-	{
-		.name = "dpio-tx-d-01",
-		.domains = CHV_DPIO_TX_D_LANES_01_POWER_DOMAINS |
-			   CHV_DPIO_TX_D_LANES_23_POWER_DOMAINS,
-		.ops = &vlv_dpio_power_well_ops,
-		.data = PUNIT_POWER_WELL_DPIO_TX_D_LANES_01,
-	},
-	{
-		.name = "dpio-tx-d-23",
-		.domains = CHV_DPIO_TX_D_LANES_01_POWER_DOMAINS |
-			   CHV_DPIO_TX_D_LANES_23_POWER_DOMAINS,
-		.ops = &vlv_dpio_power_well_ops,
-		.data = PUNIT_POWER_WELL_DPIO_TX_D_LANES_23,
-	},
-#endif
 };
 
 static struct i915_power_well *lookup_power_well(struct drm_i915_private *dev_priv,